Question about Cars & Trucks

1 Answer

Where is the MAP sensor located in a 2004 Dodge Ram 4.7?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 278 Answers

I have a 1500 with a Hemi, and a Durango with a 4.7 FFV. Still, the locations are the same. My Chilton says the front of the intake manifold. They don,t have any pictures but best guess is behind the alternator. Remember that the codes don't necessarily mean the part is bad, just where to look and what to test.

Posted on Dec 09, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 316 Answers

SOURCE: location dodge 1500 4x4 5.2 1996 map sensor

Your map sensor is mounted on the throttle body. This is what you're looking for.a2184d5.jpg

Posted on Apr 27, 2009

  • 264 Answers

SOURCE: Where is the MAP sensor

HI your MAP sensor is located right in the front on the intake manifold it is attached with 2 screws very easy to see with the air cleaner tube off.

Posted on Aug 30, 2010

Testimonial: "Awesome! Thanks!"

  • 66 Answers

SOURCE: I am looking for the I.A.T. Sensor location on my truck

If your looking for the Intake Air Temp/Manifold Absolute Pressure sensor (IAT/MAP)(2003 model year and up) It is on the top of the intake manifold, just to the left of the #3 injector fuel line. There are 2 small Torx screws holding it.

Posted on May 27, 2009

polarcycle
  • 1392 Answers

SOURCE: 2004 DODGE STRATUS 2.7L, Location of Crankshaft Position Sensor?

it is located on the right side of the motor, in the trans area. Actually in the bell housing.

Posted on Jun 23, 2009

suterman
  • 158 Answers

SOURCE: I need the location of MAF sensor in a 1998 Dodge

Your vehicle dose not have a maf sensor. They used a map sensor it is on the engine located under the front of the breater where it attaches to the engine.

Posted on Jul 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Map sensor location for 2003 dodge ram 2500 5.9 diesel


Mass air pressure sensor location should show on parts stores parts location charts, or you could buy a shop manual.

Feb 05, 2015 | Dodge Cars & Trucks

1 Answer

Engine code p1297 on 2001 dodge ram 1500 with 3.9


P1297 DODGE Description The Engine Control Module (ECM) detected no change in MAP sensor voltage.

- MAP Sensor harness is open or shorted
- MAP Sensor circuit poor electrical connection
- Faulty MAP Sensor
- Faulty ECM

Feb 27, 2013 | 2001 Dodge Ram 1500 Truck 2WD

1 Answer

Where are the spark plugs located in the 2006 dodge ram 1500 quad cab


under the map sensors. sits about 4-5 inches down. 16 spark plugs if its a hemi. some of them can be a pain to get to. need a couple universal sockets.

May 25, 2011 | 2006 Dodge Ram 1500

3 Answers

I have a 2004 dodge ram 1500 with hemi 5.7. The o2 sensor is bad on bank one. where is that located


Hi!!
The O2 sensor for Bank 1 is located below left front of transmission, in exhaust. Check diag. below.
1kbron_41.gif

Good Luck!! A HELPFUL - 4 THUMBS - rating for this solution would be greatly appreciated. Thank you for using FixYa.

Dec 04, 2010 | 2004 Dodge Ram 1500

1 Answer

My 2004 ram 1500 4x4 has the 5.7 HEMI engine and runs great out on the highway but when i first start it up and take off it blows black smoke and seems like its trying to flood out and uses way too much...


Check the following:- Map sensor, Air flow sensor if fitted instead of map sensor and the engine coolant temp. sensor. When did you last replace the air filter?

Oct 02, 2010 | 2004 Dodge Ram 2500

1 Answer

2004 Ram 1500 1/2 ton 2WD. Code P0068 is what is coming up. Truck will idle high/low at times and will die sometimes when I stop. Engine light is on, I have checked for vac leaks and cleaned the sensor...


It's a map/tps sensor correlation code, essentially it means the map sensor reading isn't what's expected with the tps reading and vice versa! It sounds like your tps sensor is probably bad or the circuit to one of those 2 sensors.

Hope helps (remember rated this).

Aug 17, 2010 | 2004 Dodge Ram 1500

2 Answers

I have a dodge truck 2004 cummins engine with codes reading. p o 0191, 0193, 0652, 0341, 0069 can you tell me what all the codes mean?


0191 is fuel rail pressure sensor circuit range/performance 0193 fuel rail sensor circuit high input 0652 sensor reference voltage b circuit low 0341 cam shaft position sensor a circuit range/performance (bank1 or single sensor) and 0069 map barometric pressure correlation
i hope that helps you some what

Aug 14, 2010 | 2004 Dodge Ram 2500

4 Answers

I need the location of MAF sensor in a 1998 Dodge


Your vehicle dose not have a maf sensor. They used a map sensor it is on the engine located under the front of the breater where it attaches to the engine.

Jul 02, 2009 | 1998 Dodge Ram

1 Answer

Location dodge 1500 4x4 5.2 1996 map sensor


Your map sensor is mounted on the throttle body. This is what you're looking for.a2184d5.jpg

Apr 27, 2009 | 1998 Dodge Ram 1500 4WD

1 Answer

I am looking for the I.A.T. Sensor location on my truck


If your looking for the Intake Air Temp/Manifold Absolute Pressure sensor (IAT/MAP)(2003 model year and up) It is on the top of the intake manifold, just to the left of the #3 injector fuel line. There are 2 small Torx screws holding it.

Apr 05, 2009 | 2004 Dodge Ram 3500 Truck

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

282 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...