Question about 2011 Subaru Outback

Open Question

Removing back seat on 2011 outback

Releasing back seat to install seat covers underneath

Posted by on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
motor1258
  • 6674 Answers

SOURCE: My drivers side power seat (on a 2004 Outback) is

For $5-$10 you can buy a 12 volt test light at auto store or hardware store if you don't already have one. Multimeter will work too. Probe (poke) wires going to motor for power when you hit switch. Should light up on one, when switch one way, and other wire when switch pushed other way. Just reverses polarity to move motor in different direction. If no power on any, then I'd go to switch and poke for wire with constant power at one of the terminals. If constant source going into switch, but nothing getting to motor, then I'd replace switch.

Posted on Sep 05, 2009

Ad
  • 507 Answers

SOURCE: 1998 Subaru Outback right rear seatbelt stuck.

you need to pull the belt out all the way to release it ,they have a locking mechanism for baby seats that stops them retracting,you pull them all the way out and they are reset and retract,common in modern cars,rare to give trouble

Posted on Oct 30, 2009

saailer
  • 1871 Answers

SOURCE: I am swapping the seats

Hello! Here is procedure to remove seats in you Outback...Guru....Saailer

FRONT SEATS

There are 2 bolts in the front, and 2 in the rear.... You'll probably have to pop off some plastic trim to get to the rear bolts....The yellow harness goes to the side airbag. The airbag light will probably go on if you drive with it disconnected, which might disable the system...Disconnect heater connector..



REAR SEATS
Locate the two bolts that are directly below and in front of each rear seat cushion. Unscrew both bolts...Locate the bolt that is attached to the bar holding down the rear seat.... Find it in the crack at the center of the rear seats between the back and seat cushions.... Unscrew the bolt. Locate the bolt that is attached to the bar holding down the rear seat. ... Find it in the crack at the center of the rear seats between the back and seat cushions. Unscrew the bolt.... Push the seat in and then pull it out to release the seat from the bar.... Locate the two bolts that are still holding the seat in, near each of the rear doors.... Unscrew the bolts. Pull the lever on the passenger side in the gap between the back and seat cushions to put both rear seats down.... Grab the seats by the headrests and lift up both sides to remove the seats....

Posted on Jan 14, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I remove the back seat to install seat covers on my 2014 chevy cruz?


Try this for the back seat: Pull the back seat down. Unscrew all the bolts behind the back seats to release it from the brace. Pull the seat back off the rear deck and out of the car. Feel under the seat cushions for release tabs on both sides. Pull the release tabs to loosen the seat cushion. Push the seat belt buckles into the holes to prevent the seat from getting caught up in the seat cushion

Jun 08, 2016 | Chevrolet Cruze Cars & Trucks

1 Answer

My 2015 subaru outback 3.6 r makes a clicking sound when I floor the acceleration and it clicks while accelerating.


2011 3.6R Back Seat or Door Rattle / Click Sound - Subaru Outback ...

www.subaruoutback.org > ... > Models > Gen 4: 2010-2014
Dec 3, 2011 - 2011 3.6R Back Seat or Door Rattle / Click Sound ... The latch can bang into the plastic cover making a rattle sound. See More is offline. Clicking sound on stopped car with brake pedal
Oct 25, 2015
Yet another clicking sound. But in console and sounds like a relay ...
Jan 1, 2011
Clicking Sound After Engine Turned Off - Subaru Outback ...
May 30, 2010
Engine ticking sound? - Subaru Outback
Apr 4, 2010
More results from www.subaruoutback.org

2013 Subaru Outback Shifter makes clicking sound at low ...

? 0:07
www.youtube.com/watch?v=AUAKNhxKWTM
Jan 8, 2015 - Uploaded by Eric Seeger
I noticed this sound occurs during low speed stop and go driving. This video was ... 2013 Subaru Outback Shifter makes clicking sound at low speed braking. ... 2015 Subaru Legacy Challenges the Roadkill Project Cars! ... 2013 Subaru outback 3.6R up hill in snow - Duration: 1:47. by davidlcb 13,610 views.

Nov 13, 2015 | Subaru Cars & Trucks

1 Answer

How can i open the trunk from inside a running buick regal 2011?


If that model has a fold down section of the rear seat back, the manufacturer normally installs an accessible manual boot release tab in the vicinity of the fold down seat section just inside the trunk compartment.

If there is no fold down seat in that model or no manual boot release inside the trunk area, the rear seat needs to be removed so that you can access the trunk from inside the car.

Nov 11, 2015 | 2011 Buick Regal CXL

1 Answer

BROCKEN REAR FOLD DOWN SEAT LATCH 2011 SUBARU OUTBACK


your best option is to try unbolting the seat from the car to access the latch then pry it open with a screw driver
after its removed you will need to go though the proces to remove the seat cover and repair the release mech.

Nov 08, 2013 | 2011 Subaru Outback

1 Answer

Drivers seat is stuck in farthest back position and will not slide forward.


Check under the seat where the guide rails are and look tovsee if the wire underneath is pulling to release both sides of the seat on the rails or one side. If it's not releasing both sides you have to check to make sure there is nothing stuck in the guide rails (coins perhaps). If all is clear you'll have to adjust the rod or cable that attaches to the lever of the seat to make it release both sides so the seat unlocks and moves easily.

Feb 21, 2012 | 2011 Mini Cooper

2 Answers

Drivers power seat will not move forward or back.


check first to make sure there is nothing caught in the track or under the seat or there maybe a bad wire on the power motor itself and yes there should be a fuse or relay check under the dash for the box there and the diagram will tell if you if one is there or check the relay box under the hood for the relay for it

Apr 05, 2009 | 2000 Subaru Outback

1 Answer

Rear seatbelts jammed down backseats


hello tracieandmia, I am assuming that the seatbelt buckles are just underneath the seat. The rear seat bottem can be removed for access. If you reach under the front part of the seat bottem near each corner and lift up, the seat will release. You will need to give it a little yank and use a little force for it to release. Once each corner is released you can remove the seat bottem. To install the seat, slide it back under the seat back and push hard down on each front corner that you had previuosly pulled up at. You should hear a definite click/lock sound when the catches are locked.

Apr 04, 2009 | 2001 BMW 3 Series

1 Answer

1998 Subaru Outback right rear seatbelt stuck.


you need to pull the belt out all the way to release it ,they have a locking mechanism for baby seats that stops them retracting,you pull them all the way out and they are reset and retract,common in modern cars,rare to give trouble

Mar 19, 2009 | Subaru Outback Cars & Trucks

1 Answer

How can I remove front row seat headrest?


Most volvo headrest can be removed by releasing the catches which are on the back of the headrest on some models and on the front on others I believe on 960 they are on the back. To release the seat on a 960 look where the shafts should be then follow it down on the back where the seat back top stops then goes in press around that area you should be able to find the catch there pull up on the headrest while releasing the catch you have to do this on both sides. The headrest should come off this also works on 740 and 760 series the volvo 780 is a different story the only way to get the headrest off on that is to disassemble the seat

Mar 03, 2009 | 1995 Volvo 960

Not finding what you are looking for?
2011 Subaru Outback Logo

Related Topics:

394 people viewed this question

Ask a Question

Usually answered in minutes!

Top Subaru Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Brandon Johnson
Brandon Johnson

Level 2 Expert

251 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...