Question about 2007 Land Rover LR3 V6

1 Answer

I disconnected the battery cables waited a short time and touched tha cables togeather to reset the ESA . Now when I reconnect the battery cables back on the vehicle it will not start. All the light

This all has to do with the self leveling that is notworking.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Land Rover Master
  • 5,370 Answers

Car not starting or turning over indicates towards multiple possibilities. It can be issue with battery or weak battery. But if battery checks out ok, then it can be starter issue or faulty alternator or problem with low fuel pressure or no spark at spark plugs due to dirty spark plugs or faulty ignition coil or injectors getting cracked or dirty and needs to be cleaned.


To confirm the problem, the basic troubleshooting is required.



From start to end troubleshooting these problems I suggest you to check the help link below and follow its procedure: -----


Mostly all types of car no start problems are discussed here with solutions:---

CAR NO START: ENGINE NOT TURNING OVER:

http://alltypesofpartsreplacing.blogspot.com/2012/11/car-no-start-engine-not-turning-over.html

---------

These will help.

Thanks.

Posted on Dec 09, 2012

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

On my ford truck how do I reset the codes ? It's 1991 f-150


what codes or are you getting service codes --and with any code repair it and it will reset or disconnect positive battery cable and wait about 5 minutes and reconnect but most codes will come back if not corrected

Nov 12, 2016 | Ford Cars & Trucks

2 Answers

I'm working on a 2007 Dodge Caliber with charging issues. I replaced the alternator and the battery but it's still not charging, any Ideas?


have alternator rechecked new doesnt mean free from defects---check wiring and connectors-have battery tested may not be taking charge [damaged ] and check fusible link if above are good

Apr 05, 2015 | 2007 Dodge Caliber

1 Answer

I have a 2007 mercury mariner I was driving home and battery light came on got home shut off car went to start and wouldn't start theft light blinking waited a while went out and started it 2 xs in a row...


Could be the battery or alternator. Try this. Disconnect the battery cable, either neg or pos doesn't matter. Leave it unconnected for 5 minutes. Then reconnect. Be sure to tighten screws/bolts that hold the cable clamp in place securely. A loose cable will cause the kind of alert you cited, but if the disconnect resets the entire electrical system, it may not re-occur. Other than the two parts mentioned, there aren't any other parts that would cause the problem. Or maybe a "short" in another area.....try the disconnect first. Good luck Michelle.

Jan 21, 2015 | Mercury Cars & Trucks

1 Answer

How do i rove the clock spring 2012 nissian par\th finder


remove clock spring in steering wheel.
step 1 , disconnect battery minus lug.
then defeat air bags as the FSM book directs,(or great danger waits)
BOOM
Battery disonn.folly 110. "under collateral damage"

quote
Whenever the negative battery cable is disconnected the following components will require resetting. The Idle Air Volume Learning, Steering Angle Sensor Neutral Position, Sunroof Memory Reset/Initialization, Automatic Drive Positioner System, Audio presets and Navigation. Use the CONSULT-III diagnostic tool, or equivalent to perform the required resets. As necessary, refer to Battery Reconnect/Relearn Procedures.
he automatic back door system, if equipped, must be initialized anytime the battery has been disconnected. Close the back door. Open the back door with the automatic open feature. Do not stop the process until the back door opens completely.
end .

begin:
  1. Disconnect the negative battery cable. (wait 30min)
  2. Disconnect the positive battery cable.
  3. Set the front wheels in the straight-ahead position.
  4. Remove the air bag module.

  1. Remove the steering wheel.
  2. Remove the column cover upper and lower.
  3. Disconnect wiper and washer switch connector. Then while pressing tabs, pull wiper and washer switch away from spiral cable to remove.
Disconnect lighting and turn signal switch connector. Then while pressing tabs, pull lighting and turn signal switch toward driver door to remove.
  1. Remove the screws. Then while pressing the tab, pull the spiral cable away from steering column assembly. CAUTION Do not disassemble spiral cable. Do not apply lubricant to the spiral cable.
  2. Disconnect the spiral cable connectors.
With the steering linkage disconnected, the spiral cable may snap by turning the steering wheel beyond the limited number of turns. The spiral cable can be turned counterclockwise about 2.5 turns from the neutral position.
end remove.
to install, read the FSM book
or login to alldata.com


the cars steering angle is lost in the process.
so.....?????
steering angle sensor calibration after installing spiral cable.

Jun 25, 2014 | 2002 Nissan Pathfinder

2 Answers

To reset ECU on 93 jeep the instruction say to ground the positive battery cable to the negative cable


ignition off remove pos. and negative battery terminlas hold both cables do not touch the battery both cables touch them together and hold for 5min. then reconnect battery start engine codes cleared id it a hard code it will come back on

Dec 05, 2010 | Jeep Grand Cherokee Cars & Trucks

1 Answer

How do you reset the computer


To reset the computer you disconnect the negative battery cable and wait approximately 15 seconds, then reconnect battery cable. Your computer is now reset.

Mar 27, 2010 | 1991 Chevrolet Lumina

3 Answers

2006 vw passat. car wont release hand brake. dash board says check manual. the warning lights are all on


or disconnect battery wires, positive then negative wait 2mins then reconnect negative 1st then positive, this should reset your electrics, it worked for me anyway.

Mar 21, 2010 | 2004 Volkswagen Passat

3 Answers

Tried turning on ignition and pump gas pedal three times, but light still flashes


Look in you owners manual if you have one, It should tell you there.
If not call one of your local jiffy lube or minit lube, they should be able to tell you how to reset it.
Good luck

May 20, 2009 | 2002 Chevrolet Suburban

1 Answer

97 audi a4 no power/battery fuse?


Sounds like either the battery leads are on the wrong way round, or the starter main cable is touching something and shorting to earth. Retrace your steps and check your connection locations.
Either that or its a dead short through the starter. Remove main cable from back of starter and tape up incase of short. then reconnect battery. If ok now then your looking at starter motor.

TL

Jan 01, 2009 | 1998 Audi A4

2 Answers

How to reset the "service engine soon" light on a 2001 pontiac grand prix gt


you can go to advance auto and use there scanner for free to clear the code its called an obd2 connection or when you disconnect your battery you can touch your black negative cable to your red positive cable that connects to the battery and it will completley drain everything and reset but warning you if your trying to get the car through emissions your gonna have to drive the car 50 or 100 miles after you disconnect the battery each time..

Sep 30, 2008 | 2001 Pontiac Grand Prix

Not finding what you are looking for?
2007 Land Rover LR3 V6 Logo

230 people viewed this question

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75077 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...