Question about Cars & Trucks
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
There are two release catches about 15" to the right and left of the centre safety catch. Roughly at each end of the top of the radiator.
The bonnet release cable goes first to the right hand one then there is a wire from that to the left, in a daisy chain way. They are typically French, cables fit into plastic levers ( a bit like bike brakes) not metal which break easily. replacements are not cheap. You need to be able to pull the cable to both catches to get the bonnet up. I managed to do this from underneath. In my case the, left hand one was broken and right hand one was working, but the getting it open broke the bit that that pulls the left. Managed to away with buying just one new catch as they are identical, swopping the right partly broken one over to the left side.
Posted on Dec 18, 2008
32 psi in the front and 30 psi in the back. if the tyre preasure monitoring is acting up even with the preasures ok. take the car to a renault garage to have them re initialised
Posted on Aug 22, 2008
Renault Laguna II Key Remote Control Programming
LAGUNA II INFRA RED RESYNCHRONISING
1. Turn the Ignition OFF.
2. Press the central door locking button for more than 5 seconds. Note: the door should lock then unlock.
3. When this happens 15 seconds is allowed and the immobiliser warning light illuminates.
4. Point the 1st key at the receiver and press the button once, the doors should lock and unlock.
5. Point the 2nd key at the receiver and press the button once, the doors should lock and unlock.
6. Check the remote control unlocks and locks the doors.
Posted on Mar 25, 2009
These rear hatches have a cheesy rod and clip setup. You have to remove the panel from inside, you have to loosen the screws around the hatch and pull it away and reach in down toward the latch and open it that way so you can get the 2 screws out of the bottom easier. There is a peice of plastic in these that's a dust barrier, try not to tear it up too badly, and when you go to put it back, I use a spray adhesive to stick it back on while I put the panel back on. after you get it open you will see a rod with what looks like threads hanging there attached to nothing, and a little thing that has 2 notched areas and a clip to hold that rod into those 2 notches. bend the clip down to make it tighter and then force the rod back into place that should fix your problems. If that's all in place then it's the latch mechanism, usually they can't be fixed because parts aren't available, just have to buy a new one and put it in.
Posted on Aug 14, 2009
Testimonial: "Thanks very much, I'll give it a try. It's a bugger getting the inside panel off, I tried a few times unsucessfully."
Tips for a great answer:
Jul 11, 2015 | 1993 Chevrolet S-10 Blazer
May 01, 2014 | Renault Laguna Cars & Trucks
Oct 12, 2013 | 2000 Renault 181
Mar 02, 2013 | 2004 Renault 181
Mar 05, 2011 | 2003 Chevrolet Tahoe
Jul 09, 2009 | 2004 Renault 181
Aug 16, 2008 | 2002 Chevrolet Blazer
15 people viewed this question
Usually answered in minutes!