Question about 1992 Ford Mustang

1 Answer

1992 mustang just stopped runinng but still cranks

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Ford Master
  • 5,370 Answers

Car not starting or turning over indicates towards multiple possibilities. It can be issue with battery or weak battery. But if battery checks out ok, then it can be starter issue or faulty alternator or problem with low fuel pressure or no spark at spark plugs due to dirty spark plugs or faulty ignition coil or injectors getting cracked or dirty and needs to be cleaned.

To confirm the problem, the basic troubleshooting is required.

From start to end troubleshooting these problems I suggest you to check the help link below and follow its procedure: -----

Mostly all types of car no start problems are discussed here with solutions:---



These will help.


Posted on Dec 09, 2012

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How would i time my 1992 ford mustang without a harmonic balencer pulley

if this a 2.3 set the key on the crank at the very top, this will get you real close to TDC.

May 23, 2012 | 1992 Ford Mustang 2.3

1 Answer

Where do i locate the crank sensor on a 1992 mustang 5.0

the '92 doesn't have a crank sensor - the distributor is geared directly to the crankshaft. Usually only cars that have coilpacks (vs traditional distributors) have crank sensors.

Sep 28, 2011 | 1992 Ford Mustang

1 Answer

Ihave a 92 mustang that wont crank, new soleniod but need to know where wires go.

The wire from the battery goes on one of the large posts, the wire to the starter goes on the other large post, as well as any accessory wires. Usually there is only one or two that go on that side. The small wire goes on the very small stud. If there are two very small studs, use one, and if it doesn't crank, use the other. One is used for another purpose.

Aug 09, 2010 | 1992 Ford Mustang

1 Answer

I have a 91 mustang gt. when i crank it over i

Bad ign switch, not the key switch, the one down on the column. good luck

Jan 20, 2010 | 1991 Ford Mustang

1 Answer

I have a 1992 Ford Mustang 2.3L. The timing belt broke when I was driving and the motor shut down fast. I have replaced the timing belt and set the timing. BUT NOW I have no spark. any ideas..

Check your crank sensor. Sometimes, it can be put back in backwards causing no signal from the crank, therefore no spark. Check to see if there is signal coming out of the sensor, this is the first step to FixYa.

Aug 31, 2009 | 1992 Ford Mustang

1 Answer

1992 ford mustang lx 2.3L will not start

The crankshaft sensor went bad. I Was'nt getting any fire from the coil pack. Tried switching coils and still nothing, tried switching ignition modual, nothing. I checked to make sure it was in time and it was. Nothing left to check so I changed the crank sensor and it firerd right up! Thanks.

Jun 13, 2009 | 1992 Ford Mustang

1 Answer

Cranks but wont start

you have answered you own question bruv change remove the fuel pump and inspect

Mar 06, 2009 | 1987 Ford Mustang

2 Answers

1988 mustang rough idle its fine nwhen its cold then when it warms up it gets erratic

check plugs .rotor arm .distibuter cap .or check for dirty fuel filter

Feb 24, 2009 | 1992 Ford Mustang

1 Answer

92 lx 5.0 stopped running.

Have you checked the exhaust system? Catalytic converter may be completely clogged

Sep 06, 2008 | 1992 Ford Mustang

Not finding what you are looking for?
1992 Ford Mustang Logo

100 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers


Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides