Question about 1990 Jeep Cherokee Limited

2 Answers

Spark plug wire diogram for 1990 Jeep Cherokee

I need to know the order the plug conect to the distrubtor cap. The engine is a inline six 4.0 leter.

Posted by on

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 100 Answers

The firing order is 153624

Posted on Jan 13, 2009

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 8 Answers

135624

Posted on Jan 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need a wiring diagram for spark plugs for a 1995 jeep Cherokee sport


V6 engine: firing order: 1 2 3 4 5 6, distributor rotates clockwise. Left bank of engine (driver's side), cylinders 2, 4, 6 (#2 at front of engine). Right bank: 1, 3, 5 (#1 at front of engine).
Inline 6 engine: firing order is 1-5-3-6-2-4. Distributor rotates clockwise.
The number one tower on the dist. cap should have a mark or numeral 1 on it. If not, turn crankshaft to top dead center of compression stroke on number one cylinder, the 0 degrees or "T" mark on the crank pulley pointer. If you are on the compression stroke (not the exhaust stroke), the rotor under the dist. cap will be pointing to the number one cylinder spark plug wire tower.

Mar 30, 2012 | 1995 Jeep Cherokee

1 Answer

1996 Jeep Grand Cherokee Cranks but well not start i have replace spark plug fuel filter and D-cap and air filter is firing order 6,3,5,1,4,2


Go to this site for what you need;

http://www.jeepz.com/forum/engine/16923-six-cylinder-4-0-liter-jeep-engine-specs.html

If by chance your check engine light does not light up on your dash, when you turn your ignition on, then your ecu is in need of repair.

Apr 01, 2011 | 1998 Jeep Grand Cherokee

1 Answer

Need ignition firing for 95 4 l. engine


1-5-3-6-2-4


ALL Jeep 4.0 motors use this firing order. Any year, any model, high output or not.


Also, the spark plug wire placement on the cap, in a clockwise direction from the post nearest the engine block is: 6-2-4-1-5-3. (to the left side of the number 6 post, there should be a hold down screw or strap for fastening the distributor cap to the distributor.

For a picture diagram, please go to this website:
http://www.jeepz.com/forum/engine/16923-six-cylinder-4-0-liter-jeep-engine-specs.html

Dec 27, 2009 | 1995 Jeep Cherokee

1 Answer

Spark plug wire position on distributor cap


1-5-3-6-2-4
ALL Jeep 4.0 motors use this firing order. Any year, any model, high output or not.

Also, the spark plug wire placement on the cap, in a clockwise direction from the post nearest the engine block is: 6-2-4-1-5-3.(to the left side of the number 6 post, there should be a hold downscrew or strap for fastening the distributor cap to the distributor.
For a picture diagram, please go to this website:
- http://www.fixya.com/cars/t2859850-need_spark_plug_wiring_1993_jeep_4l
- http://www.jeepz.com/forum/engine/16923-six-cylinder-4-0-liter-jeep-engine-specs.html

Good luck (rated this help)

Sep 06, 2009 | 1997 Jeep Grand Cherokee

1 Answer

I need the spark plug wiring for a 1993 jeep 4l from the engine to the distributor inline 6 cyl


The firing order can usually be found cast onto the intake manifold
d89ea9b.jpg

4.0L engine Engine firing order: 1-5-3-6-2-4 Distributor rotation: Clockwise
42e3dc6.jpg

Good luck (remember rated this help).

Aug 30, 2009 | 1993 Jeep Cherokee Country

1 Answer

Causes for no spark on 94 jeep cherokee please


Well it could be many things, But have you relpaced the dist. cap and rotor, within the last 15,000 miles or wires and plugs??? next step is the coil ? then it gets fun. like timing. but I think most jeeps with a Inline 6 have a bullet proof engine for the most part. As we all know there is plenty of semi's on the road. well the same set up is there. as an Inline Jeep. I would have to say 90% of semi's on the road are inline 6 cyl. engines. and may of them go to 1million miles.
so plugs,wires, cap, rotor and ignition coil. that is a good starting point.

Mar 24, 2009 | 1994 Jeep Cherokee Country

1 Answer

We have replaced all the spark plugs in our 1991 jeep cherokee but dont have the diagram of what plug wire goes where. Can you help me?


Which motor i-6 or v8?
look on the intake for firing order if it's the inline 6 from front to back they are numbers in order 1-6,using the timing marks set the engine at 0degrees on compression stroke and number 1 plug wire will be directly above where the rotor button is at I think the firing order is 135624 from number 1 on cap and going clockwise put the plug wires on the cap to the plugs in that order.

Dec 27, 2008 | 1991 Jeep Cherokee Briarwood

1 Answer

Jeep cherokee 1990


The 1987-90 Jeep Cherokee with the Renix Eletronic Engine controls take somewhere between 4-7 revolutions before the computer has enough information to get the engine started.

If it takes longe rthan that, it may be time for a full tune-up:
Distibutor Cap and rotor
Spark plugs
Spark Plug wires
Fuel filter
Air filter
and possibly an oxygen sensor

Aug 17, 2008 | 1987 Jeep Cherokee

1 Answer

Need diagram for 1998 Jeep Cherokee sport spark plug wiring


hi, you didn't say what engine you have, I'll assume it's the 4.0 L in line 6 cylinder. Standing on the PASSENGER side of the jeep, the spark plug at the front of the engine is #1, the next is #2, and so on to #6 which is at the back (nearest the windshield).
The distributor is between you and the valve cover on the engine. Pretend the top of the distributor cap is the face of a clock.
The #1 spark plug wire goes in the cap at what would be the 6 o'clock position, (as viewed from your position standing on the passenger side, facing the side of the engine). The firing order direction is clockwise, so the 'hand' of the clock (actually the rotor in the cap) would continue to the next distributor cap plug in, which would be spark plug wire to #5 (8 o'clock position), then #3 (10 o'clock position), #6 (12 o'clock position), #2 (2 o'clock position), #4 (4 o'clock position). So all this means isi your firing order is, 1,5,3,6,2,4 If you have a different motor or any questions, let me know. Good Luck! countrycurt0

Aug 06, 2008 | 1996 Jeep Cherokee Country

1 Answer

Firing order


The 4.0 inline 6 cylinder spark plugs are numbered from front of the vehicle to the back 1,2,3,4,5,6
The firing order is 1,5,3,6,2,4. As u stand on the passenger side of the Jeep, facing the engine, look for the distributor cap hold down screw closest to u. The 1st dist. cap plug wire to the left of that screw, is #1. Continue clockwise from there, 5,3,`6,2,4. countrycurt0

Jul 27, 2008 | 1989 Jeep Cherokee

Not finding what you are looking for?
1990 Jeep Cherokee Limited Logo

Related Topics:

198 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...