Question about Cars & Trucks

Open Question

How do i replace the lifters in my 04 dodge ram 1500 hemi when i do it myself?

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

chiquititas
  • 1010 Answers

SOURCE: Dodge Ram 1500 can it have a plow?

Yes It can and It should not void the warranty. Contact your dealer.

Posted on May 15, 2008

  • 840 Answers

SOURCE: passanger side mirror replacement on 04 dodge ram 1500?

very easy take the mirror inside cap off if you can not get to the 3 bolts then you will have to take trim panel off to take trim panel off look for plastic caps take them out and unscrew them then pop out the bottom of the door and pop the sides out then lift up and out should be loose enough for the bolts now/ 10mm bolts 3 Please rate my response thank you very much

Posted on Feb 02, 2009

  • 1 Answer

SOURCE: 2007 dodge Ram 1500 hemi fuel cap sensor comes on

I have the same problem. It started with engine code 0440 (evap system malfunction). I changed the gas cap and now getting the "loose cap" light plus the 0456 (evap leak very small) and 0457 (gas cap loose/off)

Anyone know where the sensor is located?

Posted on Jul 05, 2009

  • 104 Answers

SOURCE: what does the code p0300 mean on a 04 dodge ram

http://www.obd-codes.com/p0300

Posted on Aug 30, 2009

  • 83 Answers

SOURCE: how do i change the power steering pressure switch

From the Factory Service Manual, you can get one relatively cheap from www.promanuals.net. Here is a link to your 2004 Dodge Ram Service Manual.

The power steering pressure switch is installed in
the power steering high-pressure hose (Fig. 9).

(1) Disconnect electrical connector from power
steering pressure switch.
(2) Place a small container or shop towel beneath
switch to collect any excess fluid.
(3) Remove switch. Use back-up wrench on power
steering line to prevent line bending.

1425db0.jpg

Posted on Oct 05, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

04 DODGE Ram hemi cylinder 3 misfire


Check engine compression and compare. then test running engine compression most engines have about 130-170 cranking compression and about 90-110 running compression. OR bring that cylinder to its Top Dead Center compression stroke apply air to the cylinder and check to see where the air is going open throttle plate bad intake valve, from exhaust pipe bad exhaust valve, from oil cap piston rings.

Mar 23, 2014 | 2004 Dodge Ram 1500

1 Answer

2004 Dodge Ram 1500 Hemi Brake and ABS lights come on and speedometer does not read properly.


i just had the same problem w/ my 04 ram.......after replacing the sensors that the abs computer codes gave me it still had the same problem....then i unplugged the abs module only to find water in it.....apparently its a problem w/ dodge.....i dried it out with an air hose and it works fine now... hope this helps.......Chip

Sep 01, 2010 | 2004 Dodge Ram 1500

1 Answer

Sluggish driving. No power pulling a small trailer. Hard to get up small hills. Bad mpg, even from a dodge. 04 ram 1500 5.7


i have the same truck with hemi and i notice alot of power after i put on a cold air intake and i did a cheap one, i know the hemis say they have alot of power but i still think diesel is always the way to go when pulling..

Aug 09, 2010 | 2004 Dodge Ram 1500

1 Answer

04 dodge ram hemi rmove plug from transfer case


bullet then spring then of course the plug. that thing is your detent for your shifter its what keeps it from jumping into another gear

Apr 24, 2010 | 2004 Dodge Ram 1500

1 Answer

Replace timing chain on 03 dodge ram 1500 with 5.7 hemi


i have an 02 and i purchased a repair manual from autozone

Jan 05, 2010 | 2004 Dodge Ram 1500

1 Answer

P0406 Code


It is for the Exhaust Gas Recirculation (EGR) valve.

Feb 02, 2009 | 2005 Dodge Ram 1500

2 Answers

04 Dodge Ram 1500 Hemi 2WD O2 Seneor


change up and down stream o2 senors

Dec 15, 2008 | 2004 Dodge Ram 1500

1 Answer

Pinion Bearing


the only way to replace pinion bearings is to remove the differential. you shouldnt have to remove the bearing to replace the seal

Nov 17, 2008 | 2004 Dodge Ram 1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

104 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...