Question about 1998 Toyota Camry

1 Answer

Hi i got cmary 1998 v6 MC20 i removed the leads with the coils to replace the lead bcause one of them was damaged and now when i came to put them back i forgot how do they go!!! i found numbers on the coils and similar number on the lead!! can anyone provide me with firing order and the diagram please???

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 48 Answers

Look at the intake if you can see it and right by each cylinder there should be a number connect the correct number on the coil pak to the same numbered cylinder on the intake

Posted on Dec 09, 2012

  •  zaid
    zaid Dec 11, 2012

    thnx mate its all good now i done and the car is running ok


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 142 Answers

SOURCE: tacoma v6 firing order diagram

Front 1 3 5


vehicle 2 4 6

You have a distributorless ignition. This is the firing order, 1-2-3-4-5-6.
Please remember to rate this answer.

Posted on Feb 12, 2009

  • 290 Answers

SOURCE: firing order and diagram

Posted on Apr 09, 2009

  • 1959 Answers

SOURCE: 1998 toyota ipsum car stereo wiring

Clck here for the correct wire colors for Toyota.

Posted on Apr 17, 2009

  • 18 Answers

SOURCE: finding the fuse box on a 1992 toyota cmary se v6

There are at least two fuse blocks on this particular vehicle. One should definatley be under the hood in plain view. The other, which is probably the one in question, is behind the small change or storage compartment to the left and under the steering column on the driver's side of the vehicle. Locate this small compartment and gently unhindge it from the dash assy. by pulling it away from its mounting. The fuse panel your looking for should be there. The fuse location and descriptions should be on the backside of the removed compartment.

Posted on Oct 23, 2009

  • 36 Answers

SOURCE: firing order for toyota camry v6 1996

the firing order is in fact 1 2 3 4 5 6 the number one cylynder is on the left at the back, as you look at the engine from the front >>
positions of cylinders
1 3 5

2 4 6

Posted on Mar 15, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Hi just changed the plugs in wife,s street triple iridium plugs went in. now the engine malfunction light is on any ideas

If engine light was not on prior to replacing plugs now u have to read out codes out of ur on board computer to lead u into the right direction u might need to use plugs according to what the manufacture specify cross reference it . Good Luck

Dec 21, 2016 | Cars & Trucks

1 Answer

Where is the 5th coil pack located on a 2005 buick rendezvous?

Hi patricia, If you have a faulty coil and your car's running rough to find the faulty coil just pull a spark plug lead off and start your car, If it runs (ROUGHER) than before then that coil is ok. Turn the car off and replace that spark plug lead back on to the spark plug. Repeat with the next spark plug lead and so on until you start your car and it runs the same as if THAT spark plug lead is on or off, NOW TO MAKE SURE THIS IS THE FAULTY COIL, Put a spark plug into the spark plug lead that's off and earth it to the motor or body (it has to be touching steel), Start the motor and if that's the faulty coil the spark plug won't spark I hope this helps.....

Mar 25, 2016 | 2005 Buick Rendezvous

1 Answer

What would be the best oil to use in a 1999 3.5lt v6 magna with 305000 klm

Spark plug leads need to be good as high resistance in a lead can cause coil problems, which in turn can cause high hydrocarbon readings to damage O2 Sensor and overheat and melt the CAT. In fact any miss be it plug, valve, lead, coil or compression will lead to O2 Sensor and CAT damage.

Jul 29, 2012 | Chevrolet Cars & Trucks

2 Answers

How do i replace the coil pack on and where would it be located?

i think each plug has its own coil pack on top of the spark plug ,take the cover off and have a look

Apr 06, 2011 | 2000 Chevrolet Tracker

2 Answers

Mazda Eunos 500 - Engine lacks power - investigation reveals strong sparks on all cyls fuel at all cyls compression to specification on all cyls timing ok. Removing spark plug lead on cylinder one makes no...

You said compression is good then i would say you may have a bad coil , unless one coil runs all cylinders, but could still be a coil,,next thing i would check would be the injector make sure it gets a pulse if it does then try switching injectors from that cylinder to another cylinder and see if the weak cylinder changes with the injector change, if it does then you have a bad injector,

Jun 14, 2010 | Cars & Trucks

1 Answer

How do you install coil pack on 98 camaro v6 3800

#1 disconnect neg. bat cable. #2 unplug both leads from the coil your changing. #3 remove both mounting screws and pull up and remove on it to remove it...reverse to install. be careful when removing the screws they're small and you dont want to drop them. hope this helps.

Apr 29, 2010 | 1998 Chevrolet Camaro

3 Answers

I can only find three spark plugs on my freelander v6 engin

  1. Disconnect battery earth lead.
  2. Remove engine acoustic cover.
  1. RH bank only: Release locking clips and disconnect multiplugs from plug top coils.
  2. RH bank only: Remove 6 bolts securing plug top coils to RH camshaft cover and remove coils.
  1. LH bank only: Noting their fitted positions, disconnect ht leads.
  2. Using a 16 mm plug socket, remove spark plugs from both cylinder heads.
  1. Set gap of each new spark plug to 1.00 mm .
  2. Fit spark plugs and tighten to 25 Nm (18 lbf.ft) .
  3. LH bank only: Connect ht leads.
  4. RH bank only: Fit plug top coils to spark plugs.
  5. RH bank only: Fit bolts securing plug top coils to RH camshaft cover and tighten to 9 Nm (6.5 lbf.ft) .
  6. RH bank only: Connect multiplugs to plug top coils and secure with locking clips.
  7. Fit engine acoustic cover.
  8. Connect battery earth lead.

Jun 04, 2009 | 2003 Land Rover Freelander

1 Answer

Running problem plugs and leads

the longest lead goes 2 the furthest cylinder, as they get shorter move back towards the distributor!!! all the leads are different lenghts! check the plug lead on the coil at the shock mount as it gives problems!!

Apr 19, 2009 | BMW 318 Cars & Trucks

1 Answer

I have a ford focus 2002 and one of 4 cylinders is not working .

hi jerry here, ive had the same problem where one of the 4 cylinders was missing problem was the coil pack,costs about 70euro to replace, to finde out if is it theres gone simply--- remove one spak lead(ht lead) at a time and listen for a change in engin sound then put it back on till you find the one therse gone test them one by one from the coil pack(disttributor) if its the coil pack you wont here the spark jump from the lead to the pack

Jan 21, 2009 | 2001 Ford Focus

1 Answer

Hyundai Sonata FE-B 2002 V6 2.7L

I'm reading your question.
ON your Santa fe V6.
You can't put a timing light. because they are a COIL ON PLUG.
The secuense of the spark from the coil.
Is completly diferent that distributor engines.
The timing on your vehicle is not ADJUSSTABLE.

NOTE: IF you want check the timing on your car,
The only way is with a Computer Diagnostic . Capable to get PID data. To see cam and crank syncr.

OK.. I hope this fixya your question.

Jul 18, 2008 | Hyundai Motor 2002 Sonata

Not finding what you are looking for?
1998 Toyota Camry Logo

Related Topics:

78 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides