Question about Dodge Nitro

Open Question

Dodge Nitro Heater blower not working - Nitro Dodge Cars & Trucks

Posted by Anonymous on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
dttech
  • 4803 Answers

SOURCE: blower motor only works on low and medium on 2007 dodge nitro

You replaced the resistor and WHAT relay? The blower motor circuit on a 2007 Dodge Nitro does not use a relay.

The blower resistor gets it's power from the A/C - heater control unit.

If you check for voltage at the blower motor resistor connector (Key on, relay disconnected), the DARK BLUE/GREY wire should be hot when the control switch is on HIGH. The DARK BLUE/VIOLET wire should be hot with the switch in the MEDIUM 2 position.The DARK BLUE/ORANGE wire should be hot with the switch in the MEDIUM 1 position. The DARK BLUE/BROWN wire should be hot with the switch on LOW.

If any of these are not as stated above, then you either have a bad A/C - heater control unit, or faulty wiring between the control unit and the resistor.

Posted on Jun 03, 2012

Ad
  • 154 Answers

SOURCE: 95 dodge dakota heater blower not working

It has been a long time since I've replaced one of those. From what I remember you don't have to go through pulling the heater box out. You do need to remove the glove box assembly. Look up under the passenger side of the dash. If you see the bulge of the motor/cover hanging straight down then remove the cover and the motor will be there. If you don't see that then te motor is mounted horizonally. If that is the case then the fresh air door assembly will need to be removed and it is behind that.
Here is a quick check to see if the motor is bad. Thump the bottom of the heater box by the passenger's feet. if the motor comes alive or makes noise then it is bad. Also check the fuse and make sure that it doesn't work on any speed. (the resistor would prevent operation on only one speed or more but generally not all speeds)

Posted on Apr 05, 2009

dttech
  • 4803 Answers

SOURCE: 2010 Dodge Nitro AC Fuse for fan location

First, it would be nice to know WHICH fan you are talking about. The engine cooling fan? The heater-A/C blower fan?

Second, this might be the time to educate you about fuses. Fuses do not cause electrical failures, Electrical failures cause blown fuses.

With that being said, it is highly unlikely that if you find the fuse you are looking for, that it will solve your problem.

Posted on Mar 22, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

08 dodge nitro blows hot air on passenger side but cold air out the drivers side!! Any answers




NOTE: LHD model shown. RHD model similar. All vehicles are equipped with a common heater, ventilation and air conditioning (HVAC) housing assembly (1). The heating-A/C system combines A/C, heating, and ventilating capabilities in a single HVAC housing mounted within the passenger compartment behind the instrument panel. The HVAC housing assembly includes:
  1. Mode-air doors (2)
  2. A/C evaporator (3)
  3. Recirculation door actuator (4)
  4. Air inlet housing (5)
  5. Recirculation-air door (6)
  6. Blower motor (7)
  7. Blower motor resistor (8)
  8. Heater core (9)
  9. Air distribution housing (10)
  10. Blend-air door (11)
  11. Blend door actuator (12
  12. Floor distribution ducts (13)
  13. Mode door actuator (14)

Jan 28, 2015 | 2008 Dodge Nitro

1 Answer

Ac blower not working


-Possibly burn fuse.

Check and replace it.

Good Luck


Mai

Aug 16, 2014 | 2010 Dodge Nitro

1 Answer

2007 Dodge Nitro AC and Heat stopped blowing


if the motor worked intermittently this sounds like the blower motor is bad and needs replacing.

Jan 10, 2014 | 2007 Dodge Nitro SXT

1 Answer

Hearter temp control was blowing too hot, now only blows cold


Clicking sound you hear is the worn brushes in your blower motor. At this point the blower moter may or may not start with the switch. THe blower motor is faulty so I would change that first, then check for vacuum leaks or faulty selector cable for the heat blend door. It could have came off door side or heater control side.

Dec 14, 2013 | 2010 Dodge Nitro

1 Answer

2008 dodge nitro heater blowing air but not heated. How do I fix this?


Does the car heat up to operating temp. Sounds like a thermostat problem. Could even be the heater control switch. Could be the heater core.

Oct 24, 2013 | 2008 Dodge Nitro

1 Answer

How to repace resister for heater control


HI,
You'll need to a copy of the factory service manual. But first Google it.

GL,
Td

Oct 08, 2012 | 2008 Dodge Nitro

1 Answer

Blower motor only works on low and medium on 2007 dodge nitro


You replaced the resistor and WHAT relay? The blower motor circuit on a 2007 Dodge Nitro does not use a relay.

The blower resistor gets it's power from the A/C - heater control unit.

If you check for voltage at the blower motor resistor connector (Key on, relay disconnected), the DARK BLUE/GREY wire should be hot when the control switch is on HIGH. The DARK BLUE/VIOLET wire should be hot with the switch in the MEDIUM 2 position.The DARK BLUE/ORANGE wire should be hot with the switch in the MEDIUM 1 position. The DARK BLUE/BROWN wire should be hot with the switch on LOW.

If any of these are not as stated above, then you either have a bad A/C - heater control unit, or faulty wiring between the control unit and the resistor.

Jun 02, 2012 | 2007 Dodge Nitro R/T New Cars

1 Answer

2010 Dodge Nitro AC Fuse for fan location


First, it would be nice to know WHICH fan you are talking about. The engine cooling fan? The heater-A/C blower fan?

Second, this might be the time to educate you about fuses. Fuses do not cause electrical failures, Electrical failures cause blown fuses.

With that being said, it is highly unlikely that if you find the fuse you are looking for, that it will solve your problem.

Mar 21, 2012 | 2010 Dodge Nitro

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

198 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...