Question about 1995 Buick Park Avenue
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Drain all gas as much as possible for weight reasons, Unhook fuel lines, unhook electrical connections, and ground connections, filler tube, and straps, then tank will drop out. Remove retaining ring on sending unit remove unit from tank taking note how it comes out because its got to go back in the same way it came out, chg. pump on sending unit there is one electrical plug, reinstall unit in tank with retaining ring, assemble in reverse order.
Posted on Feb 14, 2009
Check out this link. It may help you with your problem.
Posted on Apr 23, 2009
SOURCE: broken fuel line
You need to inspect the conditon of the entire line. If it is extremely rusted, any repair will likely fail and even where you did not make a repair, you can expect to see new leaks shortly.
if line is in reasonably good condition you can cut the line using a mini-pipe cutter, and use brass ferrule type connectors to "splice" in a new section of line, making sure that fittings are located on good clean areas that are free of rust or pitting.
Use of rubber fuel line should only be considered as a temporary repair to get the vehicle to a place where it can be done properly. If you find it necessary to do this, use only high pressure fuel hose and high pressure clamps, placing two clamps with the tightening screws 180 degrees apart at each end. (by temporary, I don't mean temporary for the next two years...only for getting back from where you were stranded)
Posted on Aug 31, 2009
For most common location, open hood and look near cowl for a plug near the air conditioning box just forward of the windshield wipers. It should have several wipers and the resistor itself protrudes downward into the box held in place with two screws. Screws have 7mm, 8mm, or 1/4 inch hex head.
If not: look near blower itself under the dash on the passenger side. The resistor should protrude upwards into the HVAC housing near the blower.
Posted on Sep 17, 2009
Testimonial: "That was quick! Thanks! Perhaps in passenger compartment versus engine compartment!"
Tips for a great answer:
Jan 25, 2015 | 1992 Buick Park Avenue
Nov 09, 2012 | 1994 Buick Park Avenue
Aug 03, 2012 | 1995 Buick Park Avenue
Jan 30, 2010 | 1994 Buick Park Avenue
Sep 17, 2009 | 1995 Buick Park Avenue
May 03, 2009 | 1995 Buick Park Avenue
Jan 14, 2009 | 1994 Buick Park Avenue
Oct 05, 2008 | 1995 Buick Park Avenue
95 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: