Question about 2008 Chevrolet Silverado 1500
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Yes. That is exactly it. The Air Intake Temp Sensor is built into the Mass Air Flow Sensor on the Air Filter Box. Below is a picture...
I personally have not connected one of these Chips to a Tahoe...What I can provide you with, is the Connector Diagram so you know exactly what Wires you need to Splice in to. See below...
I hope this helps you. If you have any more questions or need any more diagrams, please don't hesisitate to ask...Thanks again, JShreader.
Posted on Mar 31, 2009
I am not too familiar with this engine, but iat's are usually somewhere between the airbox and throttle body, I know on older gm trucks it's in the airbox. You should see a two wire connector.
Posted on Aug 02, 2009
I don't have a diagram but they are under your intake manifold. It's not to bad of a job. You don't have to remove the fuel rails or the injectors, they can come up with the intake. The #2 knock sensor is the one in the rear. I will suggest getting both of them and also the harness and do it all while you have it apart. I believe you will find that water has gotten down in the hole where the knock sensors are located. Make sure to clean it out very good with compressed air before you install your new knock sensors.
Posted on Oct 14, 2009
The Intake Air Temperature (IAT) sensor determines the air temperature
inside the intake manifold. Resistance changes in response to the
ambient air temperature. The sensor has a negative temperature
coefficient. As the temperature of the sensor rises the resistance
across the sensor decreases. This provides a signal to the PCM
indicating the temperature of the incoming air charge. This sensor helps
the PCM to determine spark timing and air/fuel ratio. Information from
this sensor is added to the pressure sensor information to calculate the
air mass being sent to the cylinders. The IAT is a two wire sensor, a
5-volt reference signal is sent to the sensor and the signal return is
based upon the change in the measured resistance due to temperature.
Fig. 1: The IAT sensor is located in the air cleaner outlet tube-2.2L engine and 2.4L engine
Posted on Apr 11, 2010
Tips for a great answer:
Jun 13, 2015 | 2003 Chevrolet Silverado 2500HD
Jul 16, 2014 | 2004 Chevrolet Silverado SS
Feb 07, 2013 | Cars & Trucks
Nov 22, 2012 | Cars & Trucks
Dec 29, 2010 | 1999 Chevrolet Silverado 1500
Oct 30, 2010 | 2004 Chevrolet Silverado
Mar 14, 2010 | 2007 Chevrolet Silverado 1500 2WD
Oct 21, 2009 | 1999 Chevrolet Silverado 1500
Mar 31, 2009 | 2008 Chevrolet Tahoe
143 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: