Question about 1997 Chevrolet S-10 Pickup

Open Question

3rd door broken loop latch

Where can I find a replacement part for the top loop latch for the driver's side 3rd door?

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
countrysi248
  • 443 Answers

SOURCE: 3rd door latch broken or disconnected. will not open.

Take the handle off the third door with the two screws and look up in there with a light and see if the arms are off or just whats going on.. Holler if you need more. Jerry

Posted on May 13, 2009

Ad
  • 202 Answers

SOURCE: driver side door will not closed. latch will not open in the door

Take seat belt out of door jamb...

j/k

open the handle like you are trying to open the door, then get a screwdriver, and flip the latch back to open. It is stuck in the shut position. Hurry before it rains.

Posted on May 27, 2009

BeninVa
  • 389 Answers

SOURCE: need to replace door latch on 2001 cavalier

Hello, I think I know your problem and I can help. The rods are attached with little plastic fasteners that "swing away" to release the rods. I am sending you a picture of a typical fastener, if you look at it you will see a square channel with one side open. The open part is where you unsnap it. It's a tight squeeze but you can reach in and unsnap the connectors to free the latch, then just remove the bolts holding the latch to the door. When you go to put it all back together, I find it's easier to unbolt the outside door handle and push everything up and out the hole to give room to connect the fasteners. Once everything is connected just slip it all down and bolt the latch to the door and bolt the outside handle back. I hope this helps you with your problem, if not feel free to ask anything else that might help, good luck. fc85c18.jpg

Posted on Feb 24, 2010

dnewcombe1
  • 1564 Answers

SOURCE: drivers side door wont shut

Before you go about changing the latch, make sure that the latch is fully open. This can be done by pulling the latch teeth inward towards the drivers seat with a screwdriver, while releasing the door opener handle at the same time. Often these large heavier doors become out of alignment at the hinge side causing the latch to close prematurely. If you are able to accomplish this task, lubricate the entire latch with white spray lithium grease. Keep in mind that the latch has two settings. The first is to catch the door(for safety) and the second is to secure the door. Thank you, Dana

Posted on Feb 28, 2010

  • 14 Answers

SOURCE: third door 2002 s10 will not open replaced broken

The handle you replaced is a dual action. It should have two linkage arms. 1 coming down from the top & one coming up from the bottom. Sometimes the little plastic keepers that the rods snap into that hold them on to the handle become worn out. Hopefully replace the lower keeper. They may look ok, but it is a very small tolerance.

Posted on Sep 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Door latch is broken on 97 Chevy truck how do I get door open


First, try going through the passenger side and using the inside handle. if not, get it open by using a slim jim.

Nov 10, 2017 | Cars & Trucks

1 Answer

Honda crv 2008 driver side door will not close. The lock on the door has come down and will no longer latch to the door frame loop. What do I do to fix this?


loosen the hinges just enough to try and close the door and realine it.you can try top or bottom first,you will have to do this a couple times to get it right

Oct 21, 2012 | Cars & Trucks

1 Answer

Door on a driver side does not work I put a new door handle now it doesn't work?


Can't tell from the vid but you did hook up the rod from the handle to the latch mechanism, correct? There should be 3 different rods hooked to the latch, one for the lock, one for the inside handle and one for the outside handle. make sure the one for the outside is hooked up at both ends. Then disconnect the one going to the handle and try actuating the latch by pushing/pulling the rod. If you can't actuate it that way, the latch may be broken internally and will need to be replaced.

Oct 14, 2012 | Cars & Trucks

1 Answer

Broken door window was replaced now the door latch doesn't work properly.


could be a couple of thing on is the pieces of broken glass went into the lock assembly or a rod got bent replacing the glass

Jun 16, 2012 | Cars & Trucks

1 Answer

92 Honda accord drivers side door won't open. And


IF DOOR WONT OPEN FROM INSIDE THEN IF YOU LIVE UP NORTH RUST IS PROBLEM.....TAKE A FUNNEL POUR BRAKE FLUID WHERE THE LATCH IS....WAIT 1-2 DAYS AND DOOR WILL OPEN.....SHORT TERM FIX

May 23, 2012 | 1992 Honda Accord

1 Answer

Removed door handle and there is a cable that is attached to the handle that is broken (driver's side) and I'd like to know how to remove the cable inside the door to replace it.


to remove the old cable and to install the new one you will need to remove the latch and then unhook cable from the latch. remove the screws on the outside and then you will need to unhook any linkage connected like outside handle rod going to latch, take note of the location of anything removed from the lacth and how it goes on and where, this can get confusing when putting it back together, good day,

Aug 12, 2011 | Toyota Avalon Cars & Trucks

2 Answers

My driver side door wont close. the handles seem to do nothing. any advice?


the door lock mechanism has a broken spring internally .door lock has to be replaced.

Jan 15, 2010 | 1998 Ford Windstar

1 Answer

3rd door latch broken or disconnected. will not open.


Take the handle off the third door with the two screws and look up in there with a light and see if the arms are off or just whats going on.. Holler if you need more. Jerry

May 12, 2009 | 1998 Chevrolet C1500

2 Answers

1999 Ford F150 supercab - back driver door won't open


You will have to open it from the inside-Yes, I have done it and it takes about 15 min. or so.-I have also posted about 40 images, after I opened the door-In an effort to contribute a little to all the lost souls with the Curse of the F150 3rd Door issue. Hope this helps-BTW I just did this on 12/04/2011-found my particular issue-I will need a new cable, so I'll have to go to the dealer tomorrow and buy one. Also included images of the tools needed-Good Luck!
Link to the images are here>>>http://s289.photobucket.com/albums/ll220/techdispatch/F150%203rd%20door%20curse/?start=all

Jan 13, 2009 | 1999 Ford F150 Regular Cab

1 Answer

1995 Toyota Camry drivers side door latch unhooked


On the metal rod that runs vertically up to the door handle, there should be a large yellow clip that holds the rod onto the handle. These break with regularity, look at the bottom of the inside of the door shell to see if it indeed has broken & fallen down.

Sep 13, 2008 | 1995 Toyota Camry

Not finding what you are looking for?
1997 Chevrolet S-10 Pickup Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6918 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...