Question about 2000 Ford Contour

1 Answer

My cooling fan will not turn on 2000 ford contour

I have a 2000 ford contour. and my cooling fan will not turn on unless i straight wire it to the battery. i have just replaced the collant sencer. and it still wont automattialy turn on . and my temperature gage is stuck on hot.. i an stumped. what else do u think i need to do

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,533 Answers

You need to replace the cooling fan because the resistor is in the cooling fan and it is best to go to a salvage yard and have them look it up on a computer and it will tell what fan will work on your car

Posted on Jan 12, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the cooling fan thermostat on a 99 ford contour


The cooling fan is controlled by the coolant temperature sensor near the thermostat, and when it senses too high temperature of the coolant, it operates the fan relay.
Check the fuse for the cooling fan, the cooling fan relay, and the fan itself for proper operation. You can use a multimeter to see if power is getting to the sensor. If not, and you find the fuse is good, then you'll have to find the break in the wire.

Jun 11, 2014 | 1999 Ford Contour

1 Answer

I'm running my ford Contour 2000 and the a/c cools very good but sudently stop cooling when I run more than 60 MPH (some times more, some times less); but when I slow down like 30 or 35 it cools again. the...


Your high side pressure is to high. The refrigerant needs to be operating at the right pressures in order for the air-con to function properly:

If the pressure is too low, there is risk of compressor damage in addition to lack of cooling
If the pressure is too high, the effectiveness of cooling diminishes at the very least
To avoid hitting issues related to this, modern air-conditioning circuits are equipped with a pressure switch/sensor. Its job is to protect the system from self-destruction by preventing the AC from running under the wrong conditions.

Jan 17, 2018 | 2000 Ford Contour

1 Answer

I have a 1998 ford contour and the cooling fan will not engage


Check your relay for the fan.....Its usually on the drivers side under the hood right over the tire.....Go to or call autozone and ask them the exact location

Mar 13, 2012 | 1998 Ford Contour

1 Answer

Fan for ac and heater won't come on but can feel warm and cool air


change out the blower motor instructions below
  • Disconnect the negative battery cable.
  • Disconnect the blower motor lead connector from the wiring harness connector.
  • Remove the blower motor cooling tube from the blower motor.
  • Remove the four retaining screws.
  • Turn the motor and the wheel assembly slightly to the right so that the bottom edge of the mounting plate follows the contour of the wheel well splash panel.
  • Lift up on the blower and remove it from the blower housing.
  • Installation the new blower motor by reversing the removal steps.
  • Connect the negative battery cable.
  • Dec 14, 2010 | 2000 Ford F150 Flareside SuperCab

    1 Answer

    I have a 1995 Ford Contour SE, 2.5L. I have two questions - 1. The cooling fans are not currently working and 2. The in dash temperature gauge is at max temp, even when the engine is cold. Is there an...


    Answer to second question: It appears that that the wire to the coolant Temp Sensor has developed e short to the chassis somewhere which is giving the Max reading on the guage. Check the wiring in the engine bay around the Thermostat area for chafing or if the wire to the sensor has become disconnected and is touching the engine. The cooling fans normally are turned on by another sensor either near the temp sensor or on the radiator. Check the wiring around those places as well.

    Aug 18, 2010 | 1995 Ford Contour

    1 Answer

    Radiator fan always on, won't turn off unless unplug battery


    Hi!!

    Either it is hot wired straight from the battery or the fan relay got stuck.

    Locate Fan Relay in engine compartment fuse box and try switching it with another one of the same part no. If fan stops, replace Relay.

    Don't forget to rate this post, Good Luck..

    May 14, 2010 | 2004 Ford Mustang

    2 Answers

    Cooling fan won't turn on its a 1995 ford contour


    sounds like it has a ground problem or a brake in the wire.

    Mar 14, 2010 | 1995 Ford Contour

    1 Answer

    Our 95 v6 ford contour is overheating. the radiator fans are not turning on.


    CHECK THE COOLING FAN CIRCUIT WIRING , CHECK EACH WIRE FOR CONTINUITY , AND ENSURE ALL CONNECTIONS ARE CLEAN AND FREE OF CORROSION.

    Oct 26, 2009 | 1995 Ford Contour

    Not finding what you are looking for?
    2000 Ford Contour Logo

    Related Topics:

    297 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Ford Experts

    yadayada
    yadayada

    Level 3 Expert

    79865 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22326 Answers

    fordexpert

    Level 3 Expert

    5687 Answers

    Are you a Ford Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...