Question about 2004 Chrysler Sebring

2 Answers

Driver side power window stopped working

All others work fine. How do I remove the door panel to replace switch if needed. This is a 2006 Chrysler Sebring Sedan - Thanks!

Posted by on

  • 1 more comment 
  • Anonymous Apr 30, 2009

    power window right hand is not working

  • Anonymous Mar 20, 2014

    will not work any longer Is it a fuse? Others work fine

  • Anonymous Mar 21, 2014

    how to replace starter

×

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 82 Answers

The door panel is held on by plastic clips and 5 screws. 3 screws are on the bottom and 1 in the pull cup and 1 in the inner door handle.Then grab one of the corners and give a small tug, when you get some of the clips to pop out then proceed around the whole panel. To replace the panel take the clips out of the door with a fork and slide them back into the panel and then line it up on the door and use your hand like a hammer and bang the panel back on. Hope this helps

Posted on Jan 12, 2009

  • Deborah Stokes
    Deborah Stokes Dec 03, 2013

    I need to know about a 2007 Sebring

×

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 137 Answers

1. Roll door glass down. 2. Disengage two clips attaching speaker grille to door trim panel. They are at the front of the grille, one near the top, and the other one at the bottom.
3. Remove three large washer-headed screws surrounding the speaker.
4. Remove access cover at front of door trim panel. Remove by prying at its rear edge. 5. Remove red courtesy reflector from lower tail or door. Disengage by prying at screwdriver notch at bottom of reflector.
6. Remove flag trim panel from door by prying off at two attachment clips points.
7. Remove seven screws attaching door trim panel to door. a. One screw is located at lower rear screw pocket. b. Three screws located along the bottom of door. c. One screw located inside handle opening. d. One screw located at the upper front. e. One screw in the pull cup. 8. Disengage two hidden clips attaching at the rear of the trim panel, by prying off at two attachment clip points. 9. Lift trim panel upward and away from door, disengage trim panel from upper retainer channel. 10. Disengage clip attaching latch linkage to back door handle. 11. Disconnect electrical connectors as necessary, including lower foot light, If equipped. 12. Remove door trim panel from door

Posted on Jan 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Power windows don't work


For all types of power window problem and power windows not working,i suggest you to go through the help links given below.Click the link to go through its procedure to troubleshoot the problem :------

driver side power window problem?
http://technoanswers.blogspot.com/2011/06/driver-side-window-problem-on-mercury.html

-----------

Driver side power window wont go up?
http://howtobyme.blogspot.com/2011/10/driver-side-power-window-wont-go-up-on.html


---------

Power window problem
http://repairhelpcenter.blogspot.com/2012/01/pontiac-grand-am-power-window-not.html
------------

rear door or window will not open ?
http://technoanswers.blogspot.com/2011/06/rear-door-or-window-will-not-open-on.html
--------------
How to remove door panel, door window motor and regulator ?
http://technoanswers.blogspot.com/2011/05/how-to-remove-door-panel-door-window.html

--------

Power windows not working after car wash?

http://howtobyme.blogspot.com/2011/11/power-windows-not-working-after-car.html
---------power locks, power window and power mirror not working?
http://howtobyme.blogspot.com/2011/09/power-locks-power-window-and-power.html

All power windows not working?
http://howtobyme.blogspot.com/2011/09/all-power-windows-not-working-on-2003.html
------------
How to remove window motor and regulator on Car?
http://howtobyme.blogspot.com/2011/09/how-to-remove-window-motor-and.html

-------------Complete Diagnosis & Testing Power Windows?

http://repairhelpcenter.blogspot.in/2012/02/diagnosis-testing-power-windows.html

------------

How to replace power window motor in car?
http://schematicsdiagram.blogspot.com/2011/06/how-to-replace-power-window-motor-in.html
----------
HOW TO REPLACE A POWER WINDOW SWITCH
http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-power-window-switch.html
------------
How to Replace a Window Motor
http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-window-motor.html
----------
HOW TO REPLACE A WINDOW REGULATOR WITH MOTOR
http://schematicsdiagram.blogspot.com/2011/08/how-to-replace-window-regulator-with.html
---------
HOW TO REPLACE WINDOW RUN CHANNEL SEALS
http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-window-run-channel-seals.html
-------
HOW TO REPLACE A WINDOW REGULATOR
http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-window-regulator.html


-----------This will help.Thanks.

Jan 20, 2012 | 2006 Chrysler Sebring

1 Answer

My power windows don't work


For all types of power window problem and power windows not working,i suggest you to go through the help links given below.Click the link to go through its procedure to troubleshoot the problem :------

driver side power window problem?
http://technoanswers.blogspot.com/2011/06/driver-side-window-problem-on-mercury.html

-----------

Driver side power window wont go up?
http://howtobyme.blogspot.com/2011/10/driver-side-power-window-wont-go-up-on.html


---------

Power window problem
http://repairhelpcenter.blogspot.com/2012/01/pontiac-grand-am-power-window-not.html
------------

rear door or window will not open ?
http://technoanswers.blogspot.com/2011/06/rear-door-or-window-will-not-open-on.html
--------------
How to remove door panel, door window motor and regulator ?
http://technoanswers.blogspot.com/2011/05/how-to-remove-door-panel-door-window.html

--------

Power windows not working after car wash?

http://howtobyme.blogspot.com/2011/11/power-windows-not-working-after-car.html
---------power locks, power window and power mirror not working?
http://howtobyme.blogspot.com/2011/09/power-locks-power-window-and-power.html

All power windows not working?
http://howtobyme.blogspot.com/2011/09/all-power-windows-not-working-on-2003.html
------------
How to remove window motor and regulator on Car?
http://howtobyme.blogspot.com/2011/09/how-to-remove-window-motor-and.html

-------------Complete Diagnosis & Testing Power Windows?

http://repairhelpcenter.blogspot.in/2012/02/diagnosis-testing-power-windows.html

------------

How to replace power window motor in car?
http://schematicsdiagram.blogspot.com/2011/06/how-to-replace-power-window-motor-in.html
----------
HOW TO REPLACE A POWER WINDOW SWITCH
http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-power-window-switch.html
------------
How to Replace a Window Motor
http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-window-motor.html
----------
HOW TO REPLACE A WINDOW REGULATOR WITH MOTOR
http://schematicsdiagram.blogspot.com/2011/08/how-to-replace-window-regulator-with.html
---------
HOW TO REPLACE WINDOW RUN CHANNEL SEALS
http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-window-run-channel-seals.html
-------
HOW TO REPLACE A WINDOW REGULATOR
http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-window-regulator.html


-----------This will help.Thanks.

Jan 20, 2012 | 2006 Chrysler Sebring

1 Answer

2005 Chrysler T&C passenger side window went down and won't come up. All other automatic windows and door locks work fine - don't hear any motor sound / buzz / etc. when either driver side or passenger...


If the window had not been slow in it's action before it stopped working I'm guessing you only have a connection problem. I would remove the door panel and using a multimeter check the hot wire to see if power is reaching the switch. If it is check the connection on the motor. If power is reaching the motor through the switch you have a faulty motor. If at any point of testing there is no power backtrack the power wire to find where the break is. (it's usually in the door jam)

Apr 13, 2010 | 2005 Chrysler Town & Country

1 Answer

Drivers side window won't roll up


check for power at that window motor plug behind door panel while operating window switch. No power? replace window switch. Have power? replace motor.

Nov 28, 2009 | 2006 Dodge Stratus

1 Answer

Windows have stopped working


First check the fuses if you have not done so. You will need to remove the door panel to get to the driver side window switch, the power for all of the windows enters through the driver side switch. Use a multi meter to determine if power is reaching the switch, if it is not, run a temporary wire from the fuse panel to the switch and see if that will work the windows. If it now works you know the problem is a bad wire. If you are getting power to the switch but not power out the other side you know the switch is bad and must be replaced.

May 25, 2009 | 2002 Ford Taurus

1 Answer

Driver Side Window not working in 2006 Sebring


cable that lifts it up could have broke you will need to remove door panel and take it out to have a look.Does it make a noise when you operate the switch

Apr 05, 2009 | 2006 Chrysler Sebring

1 Answer

Driver's side power window doesn't work


2006 chrysler town and country passenger side window suddenly stopped working.
other windows work, sliding doors work as does rear hatchback.
fuses seem to be good.
might there be a safety switch that somehow got pushed that keeps the passenger window from opening?

Mar 12, 2009 | 2006 Chrysler Town & Country

5 Answers

DRIVERS SIDE POWER WINDOW 2006 CHEVY EQUINOX


Check inside wiring by the driver's side door hinge. Remove the rubber boot and you will find broken wires. Make a splice and you are fixed!

Dec 27, 2008 | 2003 Chevrolet Equinox

1 Answer

Driver's Side Power window control panel on door doesn't work.


I had the same problem a few weeks ago. I took it to a mechanic who has the same vehicle and he said it was the switch in my driver side door panel. Not that big a deal, but a little costly and the switch has to be programmed by a dealer wich is BS. The mechanic put the switch on and it will work on all my other windows except my driver window. so good luck.

Nov 18, 2008 | 2006 GMC Envoy

Not finding what you are looking for?
2004 Chrysler Sebring Logo

1,064 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

chargerhp
chargerhp

Level 3 Expert

813 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...