Question about 2005 Chevrolet Cobalt

Open Question

2005 chevy uplander oil pan gasket replacement

Quoted $700.00 for new gasket. How hard is it to do yourself?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 138 Answers

SOURCE: My Chevy 2002 Tahoe is leaking oil. They told me

this truck is equipped with an aluminum oil pan you could have 1 or several things going on... a stripped drain plug which is causing it to leak or it may be a leaking front seal or a rear main seal. If it is a front seal it is not to labor intensive. But if it is a rear main seal leaking it will require the transmission to be removed since the seal is a 1 piece rear main

Posted on Sep 07, 2009

  • 5 Answers

SOURCE: 2000 Chevy Blazer

i am working on a s 10 of the same yaer and problem i will post my results after tomorrow when i have finished the job i bout this truck cause of the forum i own one that is a great one and this one is for experimental purpose i will let u know so far you cant lift the motor with a jack or a hoist so we r going another route in the mornin

Posted on Dec 27, 2008

  • 462 Answers

SOURCE: OIL PAN GASKET LEAK

The engine has to be supported and the cradle under the engine has to be removed. After everything is reinstalled the front end has to be realigned.

Posted on Sep 13, 2009

Testimonial: "Thanks for your help, but i think i need a little more info. before tring this."

  • 97 Answers

SOURCE: how to install timing cover gasket without

you can trim the corners off the timing cover at the bottom and pop in place it is better loosen oil pan bolts as much as you can with out taking then out in back and sides remove front bolts pry lightly on front sides to set gap pop in cover replace bolts use plenty rtv do not over tighten use jack stands

Posted on Mar 04, 2010

  • 1 Answer

SOURCE: rear wiper on chevy uplander does not work. fuses

i have a 2006 chevy uplander and i need to change the low beam headlamp how do i do it, also about a month after we had got the van the rear wiper stopped working i haven't checked the fuse yet, but is this a common problem for the uplander, and also the abs light stays on what should i do for that problem, and also when we drive it and then shut it off it does not want to turn on right away.

Posted on May 04, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have a 99 suburban that runs great with just under 100K, been blowing white smoke. Shop originally quoted head gasket. Upon starting repairs they decided exhaust manifold gasket instead. They replaced the...


Take it to a different shop and get a second opinion. It might need a complete rebuild, or it could be that a head gasket is shot, or one of the heads is cracked. Have them do a compression test and a computer diagnostic. Just guessing at an answer can get expensive.

Aug 26, 2014 | Cars & Trucks

2 Answers

How hard to replace 2007 saturn aura oil pan gasket


Yep, it is pretty difficult, and that's a decent price range that you were quoted. There is a lot of stuff in the way.

Feb 22, 2013 | 2007 Saturn Aura XR Sedan

1 Answer

Car goes into failsafe mode; codes p2110 and p2107


Bad ignition coil,spiking the PCM,spike comes back on TPS Sensor,then to PCM again,putting the car into ETC Failsafe,and you can only go 6 MPH.

If the coils are not the issue,then the 2110 & 2107 come into play, and you spend $700,00 just for a new throttle body. The motor in it is not replaceable as of 2010,may be some day
In that case you better put it on yourself. Only (4) 10mm bolts,but you have to drain a little coolant,as it goes thru the throttle housing

May 13, 2010 | 2004 Lincoln LS

1 Answer

Head gasket on sunfire


It's one of the more difficult and picky tasks. If you torque them down wrong, it's a waste of time and money. You can screw up the new gasket and warp the heads very easily. Have the heads machined whether they need it or not. And just as important, follow the book, step by step. Good luck, you're going to need it.

Apr 27, 2009 | 1999 Pontiac Sunfire

2 Answers

02 Grand Cherokee, 4.7l need new starter, quoted at $448 for parts and labor sound right??


I show the following for the part:
BOSCH Part # SR6423X moreinfo.gif {Remanufactured Starter) $150.00 US at Rockauto.com, so the price u where quoted is way high, get the part yourself, if the shop does it they double the cost of the part and pass it on to u, standard pratice in all shop's.

Mar 11, 2009 | 2002 Jeep Grand Cherokee

2 Answers

Engine light on 2000 camry


Buy a gasket and take the old valve off, clean the gunk out of it with carb cleaner, put it back on with the new gasket and you just spent $10. If the code pops again, buy a new EGR valve, $160 at Advance Auto. Then, report the shop who quoted you $795 to the BBB.

Dec 31, 2008 | 2000 Toyota Camry

1 Answer

Oil loss and code 1806 on my 2001 cadillac el dorado


i believe what you mean is a P1860 code? There is no P1806. The code is for a torque converter clutch pulse width solenoid, which is an internal electrical part of the transmission, it is a pretty labor intensive job, and you could actually end up needing a full transmission. that and the oil pan gasket could lead to a heafty bill, if its worth it to fix is up to your and your financial situation really, ask yourself if you can buy a different car with the money that you are quoted for the work.

Dec 12, 2008 | 2000 Cadillac DeVille

1 Answer

1995 gt wagon playing up...


sadly my man it sounds like a head gasket. any good mechanic would have recommended checking this first especially being a subaru (quite common). get a compression test done. and see if there is a white "foam" in your oil. if so the news is all bad. sorry but hope this helps

Aug 01, 2008 | 1995 Subaru Legacy

Not finding what you are looking for?
2005 Chevrolet Cobalt Logo

Related Topics:

409 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...