Question about 2000 Dodge Intrepid

1 Answer

Oil pump in 2000 dodge intrepid

Need to know the location of the oil pump.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Dodge Master
  • 21,873 Answers

Bottom of engine inside the oil pan.

Posted on Dec 09, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

csmock132
  • 4669 Answers

SOURCE: find location for oil filter for oil filter for dodge intrepid

What engine? 2.7 passenger side on the bottom next to oil pan. 3.2 and 3.5 Drivers side coming off the side of block, near the front under the exhaust manifold.

Posted on Mar 24, 2009

  • 154 Answers

SOURCE: location of speed sensor a for 99 dodge intrepid

The "Vehicle Speed Sensor" signal is generated by the transmisson output speed sensor. That is the one located at the rear of the case. It is externally mounted. That supplies "vehicle speed" info to the other On-Board Computers. The input turbine speed sensor is located just behind the bell housing area of the case. I believe the trans controller is the only module that needs that info. The Crank Position Sensor give engine RPM info and it is located on the bell housing near the engine block. I hope this helps.

Posted on Apr 02, 2009

  • 14 Answers

SOURCE: Where is the oil sending unit on a 1999 Dodge Intrepid?

I think it on the lower left side of block look from under car

Posted on Jan 14, 2009

  • 116 Answers

SOURCE: Need Diagram of water pump on a 1998 Dodge Intrepid 2.7,

the water pump is timing chain driven and to replace it requires serious disassembly of the engine. it is a 13 + hour job and is not for the casual mechanic

Posted on Apr 13, 2009

bschilz
  • 2049 Answers

SOURCE: where is cabin air filter 2000 dodge intrepid

The 2000 Dodge Intrepid is not equipped with a cabin air filter.

Posted on Jan 19, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i change the oil pump in a 2000 dodge intrepid


I'm assuming that you are talking about 2.7L, the check this procedure...

Removal & Installation - 2.7L Engines
  1. Drain the engine oil.
  2. Remove or disconnect the following:
    Crankshaft damper Timing chain cover Timing chain Crankshaft sprocket Oil pan Oil pickup tube and O-RING Oil pump

To install:


f24d78a.jpg

Fig. Oil pump mounting bolt locations-2.7L engine

  1. Fill the oil pump rotor cavity with clean engine oil.
  2. Carefully, install the oil pump over the crankshaft and into position.
  3. Install the oil pump mounting bolts and torque to 21 ft. lbs. (28 Nm).
  4. Lubricate the new pickup tube O-ring with clean engine oil and torque the pickup tube mounting bolts to 21 ft. lbs. (28 Nm).
  5. Install or connect the following:
    Oil pan Crankshaft sprocket Timing chain Timing chain cover Crankshaft damper
  6. Fill the engine with clean engine oil.
  7. Start the vehicle, check for leaks and repair if necessary.

Hope helps (remember to rate this).

Oct 02, 2010 | 1999 Dodge Intrepid

1 Answer

My oil light keeps coming on in my car, but when I check the oil it's full.


Could be a faulty oil sending unit, which is usually located by the oil filter, a weak oil pump, or just needs a good old oil and filter change.

Apr 28, 2010 | 2000 Dodge Intrepid

1 Answer

2000 intrepid no voltage at fuel pump. i can hook jump box to fuel pump and it will run. any suggestions


Possible emergency fuel shut off switch.
Probably located in trunk on one of the sides behind carpet. But not positive I know thats where they are on most fords. Make sure to check all fuse too..

Feb 04, 2010 | 2000 Dodge Intrepid

1 Answer

Where is cabin air filter 2000 dodge intrepid


The 2000 Dodge Intrepid is not equipped with a cabin air filter.

Jan 19, 2010 | 2005 Dodge Durango

1 Answer

2000 dodge intrepid 2.7..Queston is will a 3.2


not really a complete wiring change and some sensors it is a head ache unless you have the money and a professional please be careful if you are to try this yourself. We all know the 2.7l has lots of problems. The engine was made for synthetic oil and the dip stick is not accurate. I own four of them. nice cars and the Canadian Built engines as any other engine have bugs that need to be worked out. thank you for your time, Lee Davidian

Jan 11, 2010 | 2000 Dodge Intrepid

1 Answer

Location of oxygen sensor


There is only 4 sensors on a 2000 dodge intrepid and the bank 2 sensor 2 is the sensor located on the right (passenger) side and the one located after the catalytic converter (the one close to the firewall).

Apr 08, 2009 | 2000 Dodge Intrepid

1 Answer

Where is the oil sending unit on a 1999 Dodge Intrepid?


I think it on the lower left side of block look from under car

Jan 14, 2009 | 1999 Dodge Intrepid

1 Answer

I got coolant pouring from the most bottom of my crankshaft on a 96 dodge intrepid. The secondary belt that pulls the water pump and air is gone. I'd like to know what caused this and how much the repair...


If you have a 2.7 engine, your water pump is in need of replacement bad. It's located behind the timing cover and is turned by the timing chain. When the water pump goes out, coolant pours out in the inside of the timing belt and into the oil pan leaving the same water in the oil look as if you had a blown headgasket.

Jul 10, 2008 | 1996 Dodge Intrepid

Not finding what you are looking for?
2000 Dodge Intrepid Logo

Related Topics:

118 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...