An expert who has achieved level 2 by getting 100 points
An expert that got 10 achievements.
An expert that got 5 achievements.
An expert whose answer got voted for 100 times.
Re: how to exchange rear tail light assembly on 2003...
Open the trunk remove the scuff plate that is located on the back part of the trunk closest to you. then pull the carpet back on the side that you are trying to get to and remove the three or four nuts holding the light assembley in. pull the assembley away from the body then disconnect the bulbs from the assembley. thay should just turn and come out socket and all.
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US. click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need. Goodluck!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Daihatsu Charade EL 2003 rear lens removal. Open the tailgate and remove the two bolts securing the lens assembly. Then get a good hold of the lens and pull out. You need to pull out the whole lens assembly since there are three plastic protruding 'clips' on the side along the lens. Please view attached pictures. Then turn the bayonet bulb holder, replace the slide on type bulb and reassemble everything back in place.
It will be one of the easiest replacements on the car. Inside the trunk, fold back the carpet and you should see fairly big wing nuts. Remove these and the whole assembly should come out. As you remove it, don't **** on the housing. The harness will have to be disconnected. The new lens can be installed reverse order.
Most of the time you can simply remove the tail light assembly from the car pretty easy and just a few screws. If it sdoes not have the screws going through the front of the housing then its rear mount and must be done by lifting the tailgate to get access. Once in the vehicle you should beable to remove the plastic housing covering up the assembly from the inside. Remove the 3-4 screws or bolts and the tail light assembly. Install the new one just the reverse. Pretty easy just take your time.
Open your hatch and behind the tail lights you will see panels with plastic knobs you can unscrew. Behind there are 3 8mm nuts you need to unscrew which will let you remove the whole tail light assembly. There is a post on the actual tail light assembly that holds it in so you may have to give it a firm pull to actually seperate it from the car. If you have the stock infinity sub you will need to remove that first to get to the drivers side tail lamp.
rear of the car is totally different, if you want to do the gt conversion you will need to exchange the whole rear clip.
gt light are wider,cant use just the lens or cover.check for parts at vegas fiero club
remove the trim panel at the very rear of trunk, remove it and place it out of the way, remove tail light Assemblyretaining nuts top and bottom, I think there are 6 per side, pull the tail light assembly straight back to access the bulbs for replacement.