Question about Cars & Trucks

Open Question

My wheel balancer coats 850 have an error 3 when I push to start

When i try to balance the wheel and I push start I having an error 3 .....how to fix that

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

tragedy lok
  • 266 Answers

SOURCE: steering wheel shimmy

CHECK UR ALIGNMENT

Posted on Aug 18, 2009

  • 394 Answers

SOURCE: newly installed brake rotors and pads. balanced

Howdy,
Time to check the front struts to make sure the nuts holding them in place haven worked loose. You will be able to see if they are loose by the paint being wore away at the point where the struts are fastened. Top or bottom. Also grasp your tie rod ends firmly and see if there is and play there. Good hunting.

Posted on Feb 06, 2010

alicantecoli
  • 22095 Answers

SOURCE: my truck shakes when i accelerate

engine mounting

Posted on Mar 20, 2010

SOURCE: Car vibrates above 40 MPH WHEELS HAVE BEEN

If a car has been driven some time with unbalanced wheels the tyres can wear unevenly. Even when rebalanced the wheels are no longer circular and this can lead to vibration, my old Volvo used to vibrate at the back like it was a cobbled street for this very reason. Another source of vibration can be water actually in the tyre. If care was not taken to keep the tyre interior completely dry before fitting any water present can cause imbalance; this can become more noticeable in cold weather when the water becomes frozen inside the wheel when the car has been standing over night. Inspect the tyres to ensure the tread depth is the same around the tyre circumference Have the tyres removed to ensure the interiors are dry and only then have them balanced.

Posted on Jun 18, 2010

Larrysito
  • 73 Answers

SOURCE: Both rear wheel bearing gives

hi i will help just because i know what is to waste money i m a same suzuki owner and a landrover owner .
Before u start doing some work !!! WHEN U HAVE SOME MILES DONE ON THE CAR AFTER CHANGE OF THE BEARINGS U CAN STILL TIGHTEN THEM A BIT THIS IS NORMAL AND ALL MAY GO(THE NOISE) !!!
i had the same problem with my freelander so here is the help- ,do not use hammer to press in the bearing !!! use hydraulic press othervise the seal on the inner site of the bearing will get damaged!!! an that is y in about 1-3 months is out!!!
i changed the bearings about 3 times because all perfect dads will say hammer is Ok ,we use to do things this way. When i was getting far angry about y is it all around i took thing in my hands!!!
So i ordered a hydraulic press and did all the bearings again,since i don't have the issue!!!
IF TYHERE IS STILL SOME PROBLEM PLS REPLY
LARRY

Posted on Jan 03, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My car seems to vibrate violently when i excel speed over 55 miles


Start by checking the balance on your tires. If they check out OK, if the car is front wheel drive, check the constant velocity (CV) joints. If it is rear wheel drive, it is possible, but unlikely, that you could have lost one of the balancing weights from the driveshaft. It is also possible that you might have a broken motor mount. In truth, fixing this is going to be a matter of trial and error. I would start with anything that spins.

Apr 18, 2014 | 2006 Hyundai Azera

1 Answer

Electrical Board Wiring diagram for coats 850 balancer


This was all I could find:

https://www.google.com/url?sa=t&rct=j&q=&esrc=s&source=web&cd=1&cad=rja&ved=0CC8QFjAA&url=http%3A%2F%2Fwww.nytechsupply.com%2Fdownloads%2Fwheel_balancer_operation_manual%2FCoats_850_Operation_Manual.pdf&ei=omHAUczML-fE0QHqooHACg&usg=AFQjCNEm9EqJ9mDHaXPRhXNbfvweNtaDaw&sig2=UrkSObN8BHVH-GWyVUG0ZQ

Jun 18, 2013 | Cars & Trucks

1 Answer

My nissan quest 2007 at 90mph will be making a vibrating noise at the rear end


rear wheels need balancing most cars when you get them balanced are only set up to do speed limit 70 try this first before you start spending money if its front wheel drive there is not a lot else aprt from wheel bearings but you should hear a howling noise if no noise wheels balancing

Aug 18, 2012 | 2007 Nissan Quest 3.5 Minivan

2 Answers

99 4runner extremely bad vibrations when braking on dry road going downhill. On flat also, but not as bad.


Have you had your wheel bearings checked ? You can check them yourself if you put the wheel and tire off the ground and try to press each side of the wheel in opposite directions and the same on the top and bottom. do this with strength and try to do it fast. If it seems to have slack in it then it is probably your wheel bearing. Your tire alignment could also be out. Have you hit a curb hard or anything? The tire and wheel could also be out of balance. Try having them computer balanced at a tire shop. Sometimes tires with several miles on them will start to wobble. Sometimes the tire weights that are used to balance a tire actually come off and the tire will then be out of balance.

May 16, 2012 | 1999 Toyota 4Runner

6 Answers

My jeep wrangler shakes at 55 mph


lol Make sure you wash the inside of your rims after you go playing in the mud. a small amount of dried mud will make your wheel shake at a high speed. It will unbalance your wheel.

Mar 19, 2010 | 2006 Jeep Wrangler

2 Answers

HI I HAVE A 01 FORD EXPEDITION AND ABOUT 3 MONTHS AGO IT STARTED TO SHAKE A LITTLE WHEN IM GOING ABOUT 50MPH AND ITS LIKE WELL IM NOT A MECHANIC BUT ITS LIKE THE INJECTORS WERE DIRTY. OR SOMETHING WAS...


Sounds like a wheel balance problem. If there's no instability in the steering at speed (wandering, cutting) meaning you don't have to keep correcting it to stay on the road, its most likely tire balance. Check your wheels for packed mud, bent rims or tire belts that have seperated. The way to tell this is to look at the sidewalls for concave spots. This is where there will be a broken belt. This will create balance problems. If none of these exist take it to a tire shop and have them check the balance. The shop that installed the tires will usually do this for free.

Feb 08, 2010 | 2001 Ford Expedition

4 Answers

My car starts to shake when i get up to 55mph i was just wondedring what the problem might be


It can be a number of problems, especially related to the suspension system. Tire out of balance, warped brake rotors, loose suspension piece or steering rack part (hopefully not), and so forth. I would start with the wheel and tire combination as it's the easiest and cheapest to fix. have them checked at the tire place (or do it yourself if you have the equipment) then I would check the rotors, brakes and suspension components like the bushings, attaching bolts and so forth. Hope this helps you, Rick

Apr 18, 2009 | 1995 Oldsmobile Eighty Eight

3 Answers

Why does my 99 lumina start to shake after 20 mph


is the engine shaking or the whole car?If its the car (steering wheel) balance the wheels.

Apr 04, 2009 | 1999 Chevrolet Lumina

2 Answers

Car vibrates at idle.


you may have a pulley out of balance. ie harmonic balancer, steering pump, alternator. try increasing idle, set it at 850-900.

Oct 28, 2008 | 1992 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

725 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...