Question about 2007 Mahindra Scorpio 2.6TD

Open Question

4x4 not working

The fuse is good. the indicator light stays on saying 4x4 low but the trans is 2x2 high. the trans will go into 4x4 high on its own sometimes.

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

4X4 Indicator lights not working at all no flashing or anything. Checked fuses and they are good unless there is another I don't know about. Also will not go into 4WD Hi or Low stays in 2WD.


Step by Step Troubleshooting 4wd 4x4 88-98 Chevy GMC ...

? 21:32
https://www.youtube.com/watch?v=Su9Dkrfd_Zg
Jan 20, 2014 - Uploaded by rwdelling
Step by Step Troubleshooting 4wd 4x4 88-98 Chevy GMC Truck ... flashing indicator lights and then would not shift from 2-4wd atall. .... 1997 2dr Tahoe in Nov and I've been having the same problems all winter. I was getting worried thinking I would have to pay a lot of money to get my 4WD working again.

Jan 03, 2016 | 1997 GMC Yukon

1 Answer

4x4 low light on car will not move


The electronic module (located behind the glove compartment) controls the operation of the transfer case in response to inputs from the electric shift motor, 4x4 mode switch, CPP switch, BPP switch, DTR sensor, throttle position output from the PCM, front and rear OSS sensors, and the VSS. Do you know what DTC'S Are ? Diagnostic trouble codes !

P1804 4WD High Indicator Circuit Failure GEM GO to Pinpoint Test C . P1806 4WD High Indicator Short to Battery GEM GO to Pinpoint Test C . P1808 4WD Low Indicator Circuit Failure GEM GO to Pinpoint Test C . P1810 4WD Low Indicator Short Circuit to Battery GEM GO to Pinpoint Test C . P1812 4WD Mode Select Circuit Failure GEM GO to Symptom Chart. P1815 4WD Mode Select Short Circuit to Ground GEM GO to Symptom Chart. P1820 Transfer Case CW Shift Relay Coil Circuit Open or Short to Ground GEM GO to Pinpoint Test B . P1822 Transfer Case CW Shift Relay Coil Short to Battery GEM GO to Pinpoint Test B . P1824 4WD Electric Clutch Relay Circuit Failure GEM GO to Pinpoint Test A . P1826 4WD Electric Clutch Relay Short to Battery GEM GO to Pinpoint Test A . P1828 Transfer Case CCW Shift Relay Circuit Failure GEM GO to Pinpoint Test B . P1830 Transfer Case CCW Shift Relay Coil Short to Battery GEM GO to Pinpoint Test B . P1836 Transfer Case Front Shaft Speed Sensor Circuit Failure GEM GO to Symptom Chart. P1837 Transfer Case Rear Shaft Speed Sensor Circuit Failure GEM GO to Symptom Chart. P1838 Transfer Case Shift Motor Circuit Failure GEM GO to Pinpoint Test B . P1846 Transfer Case CONTACT PLATE "A" Circuit Failure GEM GO to Pinpoint Test B . P1850 Transfer Case CONTACT PLATE "B" Circuit Failure GEM GO to Pinpoint Test B .

P1854 Transfer Case CONTACT PLATE "C" Circuit Failure (GEM Only) GEM GO to Pinpoint Test B . P1858 Transfer Case CONTACT PLATE "D" Circuit Failure (GEM Only) GEM GO to Pinpoint Test B . P1866 Transfer Case Maintenance Required (GEM Only) (4-wheel drive operation can be restored by clearing the DTC and cycling the ignition.) GEM GO to Pinpoint Test B . P1867 Transfer Case Contact Plate General Circuit Failure (GEM Only) GEM GO to Pinpoint Test B . P1874 Automatic Hall Effect Sensor Power Circuit Failure GEM GO to Symptom Chart. P1875 Automatic Hall Effect Sensor Power Circuit Short to Battery (GEM Only) GEM GO to Symptom Chart. P1891 Transfer Case Contact Plate Ground Return Open Circuit GEM GO to Pinpoint Test B Your best bet , take it to a qualified repair shop

Apr 04, 2017 | 2002 Ford Explorer

2 Answers

2003 Montero Limited, will not go into 2w high . What is the most Common fault?


Yes larry is very correct.Try going in reverse.

On these issue,there are few solved help links for troubleshooting the issue easily.-------

Click the link below:---
No 4x4 light on dash?

http://repairhelpcenter.blogspot.com/2011/12/no-4x4-light-on-dash.html

-----------
4X4 Truck makes roaring noise in the front end?

http://schematicsdiagram.blogspot.com/2012/01/4x4-truck-makes-roaring-noise-in-front.html

-------------
Car will not go into 4WD high or 4WD low?


http://schematicsdiagram.blogspot.com/2011/12/car-will-not-go-into-4wd-high-or-4wd.html

--------------
No 4x4 light on dash?

http://repairhelpcenter.blogspot.com/2011/12/no-4x4-light-on-dash.html

------------
4 wheel drive system will not disengage?

http://technoanswers.blogspot.com/2012/01/4-wheel-drive-system-will-not-disengage.html

----------
4WD light is flashing and beeping? NO 4WD high?

http://schematicsdiagram.blogspot.in/2012/02/4wd-light-is-flashing-and-beeping-no.html

----------
2002 Jeep Wrangler: 4WD Idiot Light is ON?

http://technoanswers.blogspot.in/2012/06/2002-jeep-wrangler-4wd-idiot-light-is.html

----------

Traction control switch will not engage on 4WD High or Low

http://whoisbyme.blogspot.com/2012/10/traction-control-switch-will-not-engage.html

-----------

4WD light flashing and 4WD will engage after few minutes

http://repairhelpcenter.blogspot.com/2012/10/4wd-light-flashing-and-4wd-will-engage.html

------------
2008 Toyota Tundra: 4x4 Wheel Drive Light is Flashing?

http://technoanswers.blogspot.in/2012/05/2008-toyota-tundra-4x4-wheel-drive.html

----------
4x4 front differential will not engage the axle on ford?

http://technoanswers.blogspot.in/2012/02/4x4-front-differential-will-not-engage.html

-------
4x4 will not engage on Ford F150? http://technoanswers.blogspot.in/2012/02/4x4-will-not-engage-on-ford-f150.html

-------------
Dodge Ram 4x4 light keeps flashing 4X4 LOW LIGHT IS FLASHING ON DASH

http://technoanswers.blogspot.in/2012/09/dodge-ram-4x4-light-keeps-flashing.html

----------
Ford 4x4 front wheels will not engage?

http://technoanswers.blogspot.in/2012/02/ford-4x4-front-wheels-will-not-engage.html

-------------

These details will help.

Thanks.

Nov 26, 2012 | Cars & Trucks

1 Answer

Where are the fuses for the 4x4 located on a 05 envoy


This not a fuse problem. When you switch to A4WD or 4HI, do the indicator light for those positions stay on solid or do they blink and then return to 2HI position? If so, then there is probably a problem with the transfer case actuator/motor.

Aug 10, 2012 | 2005 GMC Envoy

1 Answer

2003 ford expedition 4x4 high/low light start flashing every couple minutes


I too have a 2003 expidition with the same problem. both fault lamps are flashing on and off. I took it out of 4x4 (all wheel) thinking it was a glitch but, even in 2x2 they still flash on and off. Will be bring it into the ford dealer this week. will follow up when I get her back.

Aug 18, 2011 | 2003 Ford Expedition

1 Answer

The low range light has come on its stuck on 4x4 and is slowing my truck down how do i fix this


you cannot run your truck normally in 4x4 low!!!! the low is designed to go slow slow.try shifting into neutral gear on column tap the high 4x4 then shift to reverse,back up 15feet then shift to drive.it should go into high 4x4 then if you want to go back to 2wheel high shift to neutral tap the 4x4 high until the light goes off,shift to reverse and back up 15feet then shift to drive and the 4wheel drive lights should all be off. then you'll be in 2x2 rear wheel drive. thank you for choosing fixya.com

Jan 22, 2011 | Ford Excursion Cars & Trucks

2 Answers

The 4x4 does not work. when I turn the switch on nothing engages. i checked the fuses and they are good. any help?


there could be a vacuum leak for the front diff actuator . if the actuator does not engage it will not switch into 4x4

Jan 03, 2011 | 2001 Ford Explorer Sport Trac

1 Answer

I have a 1996 chevy 3500 p/u. No high beams or indicator light.


You dimmer switch needs replaced inside the stering column.

Sep 14, 2009 | Chevrolet 3500 Cars & Trucks

3 Answers

4 wheel drive not working


In regards to my 4x4 problem, I checked everything out again and it turned out I got a defective GEM. Problem solved. The way i figured it out was if the 4x4 light on the dash is on all the time, unplug the GEM 26 pin connector, if the light goes out replace the GEM.

Feb 02, 2009 | 2001 Ford F350 Super Duty SuperCab

1 Answer

2003 F150 4x4 indicator stays on


this sounds like the indicator switch is either shorted or loose.  look on the trans axil and see if you can see a set of wires going into it.  next clean them off really well and check for exposed wires.  if nothing you might have to get to the switch on the inside.  it will take some mechanical know how not to mess anything up.  

good luck
jason

Jan 17, 2009 | 2005 Ford F-150

Not finding what you are looking for?
2007 Mahindra Scorpio 2.6TD Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mahindra Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

sachin sharma
sachin sharma

Level 2 Expert

171 Answers

L Pfaff
L Pfaff

Level 3 Expert

11573 Answers

Are you a Mahindra Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...