Question about Cars & Trucks

1 Answer

2004 pathfinder had a battery drain that was traced to the power seat control module....mechanic says I need to replace it but I cannot locate one either new or used... Any other options?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 32 Answers

Set where you want and unplug till u can locate the part. Try searching part # on eBay.

Posted on Dec 08, 2012

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 383 Answers

SOURCE: Wnere is fuse located for door locks, power seat, and gas cap door on 90 lincoln town car?

dhmwv: your fuse box is located in the passenger's compartment under the dash to the left of the steering column.

Posted on May 03, 2009

  • 412 Answers

SOURCE: Needing to locate the airbag control module '07 caliber

it is located behind the floor shifter in center console..under small piece of carpet

Posted on Jun 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I need to know where the seat memory module is on a 2001 Buick park avenue, and how do i disconnect it?


How do you know it's the seat memory module ? It is located on the bottom of the driver seat .
Memory Seat Control Module Replacement

Raise the seat to the full upright position.
Unsnap the front track cover from the seat by sliding forward.
Remove the 2 front screws from the memory seat module bracket.
Remove the front seat anchor bolts from the rear of the seat tracks.
Raise and support the rear of the seat assembly.
Disconnect the electrical connector.
Remove the 2 rear fasteners from the bracket.
Remove the memory seat module (1) and the bracket.

Feb 06, 2017 | 2001 Buick Park Avenue

1 Answer

2006 Dodge Dakota 4x4 SLT Body Control Module location


I have a manual for a 2004 Dakota that is probably similar to the 2006 electrically. Dodge never called it a Body Control Module; earlier models did have the Central Timer Module (CTM) which functioned like Body Control Modules in other manufacturers vehicles.
In 2004, the CTM was replaced by the Integrated Power Module (IPM), which consists of the Front Control Module and Power Distribution Center, and is located next to the battery on the left inner fenderwell (the Front Control Module is underneath the Power Distribution Center, where you will find relays and fuses). There are several other modules which control various functions, and they communicate with each other through the Programmable Communication Interface (PCI) bus circuit, also called J1850.
The Front Control Module controls all exterior lights, except brake lights and turn signals, and the windshield wiper functions. Other modules (PCM, TCM, antilock brakes, heated seats, instrument cluster, power locks/power windows/power mirrors, etc) control other functions, but all communicate through the PCI bus.

Nov 08, 2016 | 2006 Dodge Dakota

1 Answer

What do I look for to fix the Power seats and power tilt steering has no power


A control module ! Electronics The steering column has a tilt/telescoping control system that consists of an electronic control module capable of class 2 serial data communication, a steering column power assembly with positioning motor and sensor, and a steering column control switch. The multi-function lever provides for the control of the headlamp high beams, and the windshield washer and wiper.
The tilt/telescoping steering column in/out/up/down switch is an input to the driver position module (DPM). The tilt/telescoping drive motor is an output function of the DPM.
Steering column memory settings are stored in the DPM. The steering column position sensor is an internal part of the tilt/telescoping motor assemblies, and is an input to the DPM. The DPM uses the position sensor input when storing and recalling memory settings.
Same thing with the seats , electronic control module .
Battery positive voltage is supplied at all times to the memory seat module (MSM) through the battery positive voltage circuit from the POWER SEATS circuit breaker located instrument panel (I/P) fuse block. This voltage is used to power up MSM and also to apply power to the seat motors when commanded. Battery positive voltage from the TILT/TELE SW/MEM SEAT MOD fuse located in the body control module (BCM) fuse block that supplies voltage to the seat adjuster switch and the memory function switch, also supplies voltage to the MSM. The MSM monitors this voltage circuit in order to determine if battery voltage is supplied to the seat adjuster switch. The MSM is grounded through the module ground circuit and G301.
Body Control Module (BCM)
RH footwell, mounted to the toe board, behind the carpet

Nov 05, 2015 | 2006 Cadillac XLR

1 Answer

2001 volkswagan passat V6 manuel, Battery will not stay charged, replaced battery and alternator, still dies. Mechanic says "body control Module out" continues small amount of power to dash to drain...


U can measure the amps drained with amp meater.Anything exceding small amounts (0.05!?)must point shortcircuited wires may not blew the fuses,just increase the consume,radio muted on,other consumers (trunk light ,lighter,door danger lamps and so on,etc)Must track the problem before body control module.Many alarms drain large amounts of energy (2-3 days get a older battery out).A back up wire to radio also drain power,blinking leds and others.

Oct 22, 2013 | 2002 Volkswagen Passat

1 Answer

2004 GMC Sierra drivers side seat heater turnes on and off by itself


The seats are powered by a 30amp breaker which includes the circuits for the power motors.
The signal from the control switch goes to a door module then to a memory seat module, then to the heater elements.
It may be easier to disconnect the heating element for now, repairs will need a shop manual to test and trace the circuits.

Apr 29, 2013 | Cars & Trucks

1 Answer

My 1998 nissan pathfinder auto door lock clicks when im driving and locks automatically when I unlock the truck


That sounds like a possible bad door lock switch to me. I have also seen defective door lock control modules cause the same symptoms. These things can also cause your battery to drain because it is probably also doing this when the vehicle is shut off. The power lock solenoids in the doors will also bedestroyed if it is allowed to continue.

If you cannot get it diagnosed and repaired right away, I recommend unplugging your door lock control module to prevent furter damage to the vehicle. Yours is located under the dash next to the fuse block. (See picture)

11_1_2011_12_19_49_am.gif

Oct 31, 2011 | 1992 Nissan Pathfinder

1 Answer

2004 GTO: Electric seat backs will not go forward or recline. Everything else works on seats.


I tired a new switch becauuse of th seat not going foward or backward, the other positions worked. The module needed replacing, the mechanic ordered a new one, but it was a different number. He could not fing that module for the passenger power seat1 any suggestions?

Apr 08, 2010 | 2004 Pontiac GTO

2 Answers

The driver seat heater just quit. all fuses are good. how do you tell if the relay is good?


Swap it with a relay you know to be good and see if it works again,pick a relay that is not important to the function of your car.

Nov 01, 2009 | 2004 Cadillac SRX

1 Answer

Hello accent 2004 with anti theft system battery flat anti theft


Have you verified this system is running the battery down? The system you describe is called the Remote Keyless Entry System (Electronic Time/Alarm & Control System - ETACS Module). It cannot be 'disconnected' without disabling other systems (intermittent wipers, Chime bell, Door Warning, Dimming Off Room Lamp, Seat Belt indicator, remote power door lock/unlock system, etc.)

f92f17f.jpg

Jun 10, 2009 | Hyundai Motor 2004 Accent

1 Answer

I need to find the fuse for the driver seat in a 2001 C 320 merce


They usually have a circuit breaker, which is also in your fuse box, but you are probably wiser to find the plug-in for your seat, because fuses and breakers often control more than one thing. Trace the wires back from your seat until you find a connection, and unplug it.

May 08, 2009 | 2002 Mercedes-Benz C-Class

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...