Question about 2000 Nissan Frontier

1 Answer

Where is the blower relay located on a 2000 nissan frontier

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 14 Answers

It's a circuit board located under the dash on the passenger side, it has 2 bolts holding it in place, it's blended into the black plastic.

Posted on Dec 13, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
dealt_soul
  • 296 Answers

SOURCE: 2000 NISSAN FRONTIER VIBRATION

Check tire balance, rear wheel bearings and i would replace u joints front and back, anyway if they have never been repaced.

Posted on Feb 15, 2009

  • 2 Answers

SOURCE: Location Of Starter relay switch

sometimes its the simple things. On the foot pedal for the clutch are rubber grommets that push the switch in on the manual trans. they get old and fall off or develop holes in them so the switch does not get depressed.

Posted on Apr 04, 2009

  • 215 Answers

SOURCE: Where is the thermostat located in a 2000 Nissan Frontier

You are correct the upper radiator hose leads to the thermstat housing. The thermostat housing should be retained by only 2 bolts.

Posted on Mar 01, 2010

  • 2 Answers

SOURCE: change brake light bulb on a 2000 Nissan Frontier

The entire bed line will need to be removed. The long screws that hold the metal bracet where the bed extender attaches also hold the tail light assembly in place.
I pulled the bed liner up at a 45 degree angle and layed it on top of the cab. This revealed the screws. Take both screws out and lay to the side along with the metal bracket for the bed extender.
Now firmly grab the edges of the tail light assembly and pull...there are 2 hard rubber nipples that snap in to hold the assembly. You will feel like you might break it but you won't..just pull straight back hard. The assembly will "POP" out and then you can just twist the back of each bulb there are (3) and pull out..now you will see the bulbs..just pull the bad bulb straight out and push the new one into place. Now just reassemble. Total time will be 30-45 min. for this repair.

Posted on May 04, 2010

samtoler
  • 666 Answers

SOURCE: I need to replace the knock sensor in my 2000

it is located on the bottom section of engine, Just unplug it and it screws out fairly easy

Posted on Jun 14, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where I can locate po325 knock sensor for nissan frontier 2000


underneath intake manifold between cylinder 1 and 2.

Mar 09, 2015 | 2000 Nissan Frontier

1 Answer

Fuel pump relay diagram


The fuel pump relay is located inside the vehicle under the driver's side of the dash just to the left of the parking brake (above it)

Jul 25, 2014 | 1998 Nissan Frontier

3 Answers

2000 Nissan Frontier tail lamp relay location


I checked alldata and it doesn't show a relay just a couple of connectors. 34f3c13e-fd67-4ad5-af04-4135acc1b637.gif

Jun 16, 2014 | 2000 Nissan Frontier

1 Answer

I need the location of the 2000 nissan frontier fuel filter


there is cover plate on cross member for back wheels. it is behide it.

Oct 01, 2017 | 2000 Nissan Frontier

1 Answer

2010 nissan frontier - no +12V at 7 pin connector


on the r/h side floor area by your right foot if you are sitting in the truck is a side cover. thas where the harnesses are for the hitch. they are hidden behind the cover. you should see a small harness with relays. thats the harness.

Jan 18, 2010 | 2008 Nissan Frontier

1 Answer

98 frontier has only high fan setiing that works


Check /replace the blower motor speed control resistor pack - usually located in the blower fan ducting - in the air flow.

Oct 11, 2009 | 2000 Nissan Frontier

1 Answer

2000 Nissan Frontier quit running


You have not run a engine control module fault code test, this is key to finding the possible causes. Borrow or buy a OBD2 code reader and check the codes

Sep 11, 2017 | 2000 Nissan Frontier

1 Answer

My motor blower died - Nissan Pathfinder 2000 LE


the relay should be under the hood on the firewall up by the dash there should be several relays there to check

Jan 16, 2009 | 2000 Nissan Pathfinder

2 Answers

Air conditioning Fan


Actually the relay is not the problem here. Your blower resistor has gone bad. The resistor reduces the amount of power going to the fan, thus allowing the slower speeds. I don't know the exact location, though it is typically in the blower housing.

Oct 09, 2008 | 2000 Nissan Frontier

Not finding what you are looking for?
2000 Nissan Frontier Logo

Related Topics:

151 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22258 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...