Question about 1992 Chevrolet S-10

1 Answer

Break light flashing - 1992 Chevrolet S-10

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 41 Answers

You may want to check your break switch located on your break pedal under the dash.

Posted on Dec 11, 2012

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does my dashboard lights flash on and off when I break? battery and oil light turn on red before car shuts off. car will restart but shuts off again after driving a short while and repeats.


Have the check engine light scanned for codes related to this problem first. You may have a charging system issue causing low voltage resulting in the lights flashing/stalling.

Jun 21, 2015 | 2001 Lexus ES 300

1 Answer

Flashing battery light and brake light


Are you referring to warning lights on the dash board? The flashing battery light may mean you have a charging problem and the flashing brake light may mean you need break fluid or have an other brake issue. Take it to a service station or the dealer. Or read the owners manual.

May 24, 2014 | 2006 Suzuki Reno

1 Answer

1993 GMC sierra 1500 replaced rear turn signal bulb and break light bulbs..still no break light and turn signal still flashing fast..no hazzard light on same side


the break switch is damaged replace it then the hazzad light and the break light will be ok .. and about the indicator light its circuit's capacitor or the resistor is damaged please check that and replace the same it will be ok

Aug 24, 2012 | Cars & Trucks

1 Answer

On my 1997 Jeep Grand Cherokee Tsi the information center keeps flashing rear lamp failure. I replaced the license plate lamps but it still flashes. Is there a way to reset this??


Mine did the same I found out it was a break light out in the third break light. Easy to remove with a screwdriver. Replaced the bulbs and the warning went away.

Apr 07, 2011 | 1997 Jeep Grand Cherokee

1 Answer

Right read blinker/break light dont work, turn signal blinks rapidly


It's the bulb. There are two filliments in the bulb. One is for when you turn your lights on and the other is for breaking and blinker flashing. When the break filliment goes bad it causes the blinker to flash very rapidly. 100% the bulb. Change it and all will be good again. P.S. if it were a fuse none of the break lights or blinkers would work.

Apr 20, 2009 | 2005 Ford Explorer

1 Answer

2000 blazer break lights stuck on


check the gruond in the black wire in the blinker switch if its ok, sometime the after market parts have ashort life time try to replace the flasher switch ( blinker switch)

Mar 07, 2009 | 2000 Chevrolet Blazer

3 Answers

SEAT TOLEDO WARNING LIGHTS


Could be the motor-management-warning light, but I guess it's the break-warning light. There might be too little breaking-fluid left in the lines ... A boardcomputer-readout should clarify this.

Otherwise, try parking on an ascending road with the nose pointing up, hit the hand-break and wait like 2 minutes; the light should come on. You might wanna retry it with the car's nose pointing downwards as well ... If so, definitely the breaking-fluid, otherwise probably not ;)

In any case - flashing warning light are never ok, so when you see it again and you're sure it's not just the ABS/ESP warning light, go and have your boardcomputer read-out, since it should contain useful errorcodes ..

Feb 07, 2009 | Volkswagen Passat Cars & Trucks

1 Answer

Parking break light


check the breaks. does it have abs

Oct 17, 2008 | 1989 Chevrolet K1500

Not finding what you are looking for?
1992 Chevrolet S-10 Logo

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...