Question about 2010 Toyota Fortuner 3.0D-4D
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Diagnostic Test Code (DTC) P0046 is defined by SAE J2012 as "Turbocharger/Supercharger Boost Control "A" Circuit Range/Performance".
Please note that this is a CIRCUIT code. This means that the electrical circuit for your boost control is not operating within its designed "window of operation". The circuit must be properly diagnosed to determine the actual CAUSE of this code setting.
Specific vehicle/circuit information, as well as proper testing equipment and techniques will be required.
Posted on May 12, 2012
SOURCE: Solution to Trouble code
P0093 - Fuel System Leak Detected Large Leak
I would have a fuel pressure leak down test run, it may be a failed pressure check valve in the fuel pump inside the fuel tank and the system sees this as a leak. Don't replace any parts until the test is run, the part is very expensive to replace on this make of vehicle.
Posted on Sep 05, 2012
Tips for a great answer:
Mar 17, 2018 | Toyota Cars & Trucks
May 02, 2017 | Land Rover Freelander Cars & Trucks
May 18, 2016 | Toyota Cars & Trucks
Oct 17, 2015 | Toyota Cars & Trucks
Sep 30, 2015 | Toyota Cars & Trucks
May 28, 2015 | Toyota HiAce Cars & Trucks
Apr 14, 2015 | Toyota Corolla Cars & Trucks
The Engine and Automatic Transmission (not applicable to manual transmissions) in this vehicles drive train are fully electronically controlled by a computer called the PCM and TCM (Power Train Control Module, Transmission Control Module). When a problem like this or other drive-ability related problems occurs the computer stores a record of the problem (there are of course some exceptions to this, like the fuel pump, engine coolant temperature sensor and MAF sensor for instance) in the form of a fault code in its memory, to read these fault codes you must have the systems memory scanned with a special tool. Once the fault code(s) are read you then must perform the appropriate diagnostic testing to find and resolve the problem(s) DO NOT REPLACE ANY PARTS UNTIL A TRAINED TECHNICAIN HAS DIAGNOSED THE PROBLEM TO AVOID SPENDING YOUR HARD EARNED MONEY ON PARTS THAT MAY NOT CORRECT THE PROBLEM. Also always check fuel pressure for correct spec for your make and engine type.
Sep 13, 2012 | Toyota Cars & Trucks
May 12, 2012 | 2010 Toyota Fortuner 3.0D-4D
Sep 20, 2008 | Toyota Prius Cars & Trucks
1,332 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: