Question about 2007 Toyota Hilux 2.5

1 Answer

How to turn off fuel light?

Engine : 2KD9903568

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

How to reset Toyota fuel light?

Posted on May 13, 2013

  • Stephen Kuyiku May 13, 2013

    To reset the light when blinking .

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

After putting fuel sudden the check engine light came on and after disconnecting battery secondly I saw another zigzag light stood.


If you don't turn the fuel cap a couple of clicks air gets into fuel ratio sensor and that will turn the check engine light on. Make sure you put fuel cap on securely!

Mar 12, 2016 | 2006 Hummer H3

1 Answer

Hard time to start but when it turns on I hear the fuel pump relay clicking a lot and the idol start going up and down until the car turns off and by the way I got the track light on and the check engine...


Year make and model ?
Have you swapped the fuel pump relay with another ?
Its normal for the traction control light to come on if the check engine light is also on.
Have you checked the engine computer for trouble codes ?

Mar 27, 2015 | Cars & Trucks

1 Answer

Service engine soon light


Disconnecting the battery will not clear the code . Have erase with a scan tool .

Jul 18, 2017 | 2005 Buick LeSabre

2 Answers

2003 gmc savanna, wont start, new fuel pump and ignition cylinder, I turned key to on position, let sit for 15 min and still wont start just turns over


Find fuel test valve in fuel rail on top of engine. Take cap off valve. Turn key on. Push down valve with screw driver. fuel should squirt out. If not check fuse fuel pressure relay and bad wires. If fuel does come out, remove a spark plug from engine. Connect plug wire to plug. Ground plug against engine. Crank over engine and look for spark.

Nov 03, 2013 | 2003 GMC Savana

1 Answer

My 2001 ford mustang v6 engine will not start due to not being turned on or driven in over a month. How can this be fixed?


Is the engine turning over? Are the dash lights coming on when key is turn on? If engine is turning over and lights are coming on the battery is good. If not the battery is dead. So once engine is turning over and car not starting try pouring just a little fuel inside the fuel bowl and try starting the car. Or get some starting fuel.

Oct 19, 2013 | 2001 Ford Mustang

1 Answer

My lexus is250 would not turn on


Hi there:
You will have to pinpoint what the engine is missing...
- Spark
- Fuel
- Compression

All three of these are tested when the engine is being cranked over. There are two way of checking for fuel. Fuel pressure and fuel trigger. Both are very important and must be present for the engine to start. Fuel pressure is self explanatory. You just hook up the gage and see what the reading is. Fuel trigger is check with a noid light. The injector gets unplugged and the noid light gets plugged in to the injector clip. With the engine cranking over, this light must blink. This is the signal to the injectors from the computer. You can have all the fuel pressure in the world, but it wont matter if the injector is not pulsing gas into the cylinder like it should.

Compression tester, spark tester, fuel pressure gage and noid light are all accessible at your local auto store. All three tests play a very important part in diagnosing a no start condition. Be extremely careful when doing these tests.

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Aug 20, 2012 | 2007 Lexus IS 250

1 Answer

Just replaced fuel pump now rear lights are goofy. If the engine is off the rear turn signals work fine but no running lights. With engine on, the left turn signal causes both lights to blink rapidly with...


YOU HAVE A BAD GROUND FOR FLASHERS OR FRONT YTURN IS OUT AND RUNNING LITES HAVE FUSE GOOD LUCK LOOK AROUND FUEL TANK FOR TORN OR PINCHED WIRES

Oct 06, 2011 | 1998 GMC Sierra

1 Answer

What causes injector not firing gas?


FUEL INJECTOR NOT FIRING COULD BE FAULTY FUEL INJECTOR.HOOK A NOID TEST LIGHT TO FUEL INJECTOR ELECTRICAL CONNECTOR. CRANK THE ENGINE WATCH THE NOID TEST LIGHT SHOULD BE BLINKING WHILE ENGINE TURN OVER.IF TEST NOID LIGHT STEADY PCM FAULTY NOT FIRING THE FUEL INJECTOR.IF FUEL INJECTOR DONT BLINK OR LIGHT UP.YOU HAVE OPEN WIRING CIRCUIT TO THE FUEL INJECTOR CONNECTOR.

May 13, 2011 | 1990 Geo Tracker

1 Answer

So my 1995 Rodeo will sometimes not start. When I turn the key to the on position, the check engine light comes on and I can hear the fuel pump pumping, but every so often, the pump doesn't pump and the...


First things first...Rewiring the fuel pump will only put a "Bandaid" on whatever the problem really is and will most likely create a situation where wires are draped across places where they shouldn't be, causing all kinds of future electrical problems. I have had to clean up that type of mess too many times.That type of "shade-tree" repair makes proper diagnosis and repair of a vehicle nearly impossible, even by a trained technician. My recommendation: DON'T EVEN THINK ABOUT IT!

OK, Now that I have my preaching out of the way...
The check engine light is supposed to come on every time you turn the key to the "On" or "Run" position before starting the engine. This is for a "bulb-check" just to let you know that it is not burned out. It should go out immediately after the engine starts and should stay off the entire time you are driving the car. It is not any type of indicator to let you know that the fuel pump has run. If your check engine light is not coming on every time you turn the key to "On", then there is probably a problem with your ignition switch or your ECM Main Relay. Either of these can cause an intermittent failure of the ECM to power up, a)d thus, not turn the check engine light on. Failure of the ECM to power up will also cause the fuel pump to not run because like the check engine light, the fuel pump is controlled by the ECM. (Rewiring the fuel pump will not make the engine start if this is in fact what the problem is.)

I have also seen many fuel pumps that run when they want to. You could have a bad fuel pump, but refering to your statement about the check engine light, I would guess that the fuel pump is not the main problem or even if it is a problem at all.

Dec 29, 2010 | 1995 Isuzu Rodeo

3 Answers

Check engine light comes on in a 07 sebring when the gas cap is removed and the engine is started there is no change in the indicator.


this is normal, you should not have engine running when re-fueling, fuel gauge moves very slowly if key is on while fueling, turn key off and then on and should read proper level.

Mar 01, 2010 | Chrysler Sebring Cars & Trucks

Not finding what you are looking for?
2007 Toyota Hilux 2.5 Logo

Related Topics:

197 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...