Question about 2005 Toyota Yaris 1.3

1 Answer

When i try to start the car the engiene tries to start but its like the petrol is not going through? Therefore the car did not start!!

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Toyota Master
  • 956 Answers

No initial combustion (engine does not start)
1. ECM power source circuit
2. Crankshaft position sensor
3. Camshaft position sensor
4. Ignition system
5. Fuel pump control circuit
6. ECM
7. Voltage output circuit
Engine cranks normally but difficult to start
1. Fuel pump control circuit
2. Compression

Posted on Dec 20, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My car 307 sw 2006 1,6 starts only when the engien is cold. when i drive, for 10 min and try to start the engien again after a fool stop, it makes klicking sound when i try to start. and if i try to many...


It really sounds like the starter to me..Alot of time i have seen this happen simlpy because heat shield keeping exhaust heat away from starter is off..This would only be the case if your car is set up that way and on that model and make i dont know. Some times starters simply start to fail and this is one of the signs "starter gets hot and car wont start...might try replacing it would be my suggestion....hope this helps and good luck ....Please rate my post.......If you need more help fill free to contact me..

Aug 16, 2012 | 2006 Peugeot 307 1.6

1 Answer

2008 dodge grand caravan wont start. is low on gas but would that be a factor why the engien wont try to start? it does like when the battery is dying it just produces a noise on the engien. battery has...


Car no start problem is sometimes very difficult to confirm. You try all the possible things, but still you get no fault and problem is still the same.--------
In that case, you need to check few things individually.
Check the spark,the battery,the crank, the fuel and other most possible parts. Click this link below for more details:-- http://howtobyme.blogspot.com/2011/10/car-troubleshooting-tips.html

Oct 04, 2011 | 2008 Dodge Grand Caravan

1 Answer

When i fist start engiene its very accelarated


have you tried to manually decelerate the engine? you can find this is the engine were the engine connects to the accelerator wire.. you can actually manually decide at what rpm's you want your car.. dont go too low or your can can continuously turn off

Dec 26, 2010 | 1997 Honda Passport

1 Answer

97 nissan quest gxe won't start, engien & rotor turns


pressure should be 40 psi. change pump in tank if bad.

go here for help

http://groups.yahoo.com/group/villagerquest/

May 31, 2010 | 1997 Nissan Quest

2 Answers

Renault megane engine light flashing and car is juddering.


I have 2 meganes im working on at the moment both have the same problem. the electrical falt light is on coz the pipe has snapped (or come off) under the bonnet on the passangers side close to the window (theres a black box about 2 inch wide the pipe connects underneath). if I reconect the pipe and grab the engien with both hands it wobbles and the pipe pulls off. I suspect this is coz one (or all) the engien mountings are shagged. and this will be the cause of the juddering when driveing in first and second gears. solutions iv have come across for juddering involve changeing the coil pack but thats nothing to do with the problem my 2 cars have as one of them has new coils. they are 1.6 petrol, p reg and s reg

Jan 16, 2010 | 2005 Renault 181

2 Answers

Car wont start help


try to change the fuel filter first. Then check the fuel pump if it's still good. might need some cleaning since it was not running for several months

Aug 19, 2009 | 2001 Volkswagen Golf

1 Answer

99 vr6 eurovan engien dies when hot but minits


sounds like its the water pump needs changeing

Aug 14, 2009 | 2004 Volkswagen Eurovan

1 Answer

Seam to run out of petrol, but did'nt. now wont start,


Make sure you are getting spark at plugs. Coil may be going.

Jan 26, 2009 | 1997 Subaru Legacy

1 Answer

Engien wont start!?!


You might need a new starter or a new alternator. Get it checked at a shop to make sure you find the right thing that you need to change.

Oct 23, 2008 | 1984 Ford Mustang

Not finding what you are looking for?
2005 Toyota Yaris 1.3 Logo

318 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...