Question about 1999 Chevrolet Silverado 1500

Open Question

Chevy silverado engine code po410, what to do to fix it

Pick up

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 9 Answers

SOURCE: Check Engine Code

a code of po146 is o2 sensor circuit-#2 post-converter sensor,left bank. Look for any broke wires going to the O2 on the left side facing the truck.

Posted on Apr 05, 2009

keemo68
  • 1263 Answers

SOURCE: where is the dimmer switch

the dimmer switch is located in the steering column and is a part of the turn signal module. you must remove the steering wheel,column cover to remove the turn signal/dimmer switch module.

Posted on Apr 17, 2009

  • 1608 Answers

SOURCE: 2006 5.3ltr chevy silverado z71 p0455 andp0449

These codes are for the evaporative emission system.The 455 is the vent solenoid.The 455 is a large leak in the evap.system.The vent solenoid I would replace because they go bad and will not work because they are under the vehicle in the rear of the truck.There is a bulletin for these and the vent valve is installed in another spot.The number for the bulletin is 02-06-04-037E.You should also look for a broken or loose hose or pipe that might have came off.Specially if you ran over something.If none found it could just be the vent solenoid stuck in the venting position.Good luck.

Posted on Dec 01, 2009

csmock132
  • 4669 Answers

SOURCE: chevy 2-2 engine codes po410 and p1137

1137 is an o2 sensor code but I would have to look it up to see which one. 410 is a common one. Check the maxi fuse for the sec. air inj pump in the little fuse box tucked into the fender right beside the battery.

Posted on Jul 10, 2010

  • 1311 Answers

SOURCE: engine light came on, code po410 came up.

This has to do with the secondary air pump system, this system is used at cold start-up and involves three components; air pump, solenoid valve and a relay. Many times the valve becomes stuck or clogged, the relay has also been known to fail.

Posted on Oct 27, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 chevy silverado ,5.3 liter engine .service engine soon light on so scanned for problem codes ,results bank 1&2 are running lean .what is the cause or problem that needs to be done to fix


Check for loos connections between the intake and the tube from the air filter. Check if the clamp is loose or leaks in the tube which can cause an incorrect reading. Other than that it may be a dirty MAF sensor which can be fixed by spraying carb cleaning or tuner spray in the intake or it may be bad or a bad oxygen sensor;.

Nov 22, 2011 | Cars & Trucks

1 Answer

Trouble Code 12 on 1993 chevy silverado


code 12 indicates that your in diagnostic mode

Nov 04, 2011 | 1993 Chevrolet C1500

1 Answer

Engine code po307 AND PO410


Hey; Code 307 is a code for misfire on cylinder #7. It could be caused by bad spark plug, ignition module. If engine has a miss then I would replace the spark plug first. If that don't fix then it will require further diagnosis with a scan tool. Code PO410 is for the secondary air injection system. Make sure the vacuum hoses going to the valves on the front and rear cylinder banks are connected and the hose(s) not damaged. Also make sure the solenoid is connected both electrical and vaccum' Maybe this will help

Aug 30, 2010 | 2001 Cadillac DeVille

1 Answer

Chevy 2-2 engine codes po410 and p1137 i know 1 is secondary air injection and other fuel air metering but book doesnt say xactly what part is and auto parts store cant help


1137 is an o2 sensor code but I would have to look it up to see which one. 410 is a common one. Check the maxi fuse for the sec. air inj pump in the little fuse box tucked into the fender right beside the battery.

Jul 10, 2010 | 2001 Chevrolet S-10

1 Answer

Engine light came on, code po410 came up.


This has to do with the secondary air pump system, this system is used at cold start-up and involves three components; air pump, solenoid valve and a relay. Many times the valve becomes stuck or clogged, the relay has also been known to fail.

May 11, 2010 | 2004 Chevrolet TrailBlazer

1 Answer

1999 chevy silverado seveice engine soon how to recet light


must have a scanner to reset light but it will come back on until you fix the problem have the system checked to get trouble code that will let you know where to start

Feb 17, 2010 | 1999 Chevrolet Silverado 1500

1 Answer

My chevy silverado engine shake when i make a complete stope


have vehicle scanned for trouble code some auto stores such as auto zone /advanced auto do it for free the code will give u a start point

Oct 27, 2009 | 2000 Chevrolet Silverado

Not finding what you are looking for?
1999 Chevrolet Silverado 1500 Logo

Related Topics:

84 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...