Question about 1999 Jeep Grand Cherokee

1 Answer

1999 Grand Cherokee 2 wd... frontend noise... I repalced the lh front hub assy and still have it.. rotated tires ... nothing different... tires look fine.. Help?

Posted by on

  • 1 more comment 
  • bcdpreservat Jan 12, 2009

    Thanks for the reply... it sounds like a wheel bearing / hub assy. That is why I replaced the lh unit... that is what it sounded like.



    It is not a "pulsing" sound like a chopped up tire.... but I rotated them anyway.



    It is two wheel drive so no axle shaft up there or rear differential to deal with..... could it be the ABS sensor? Kinda doubt it...



    Sound stays the same when I kick it up in neutral. hmmmmmm

  • Alex M
    Alex M May 11, 2010

    Possible that front end is out of alignment, need more info on what the noise sounds like

  • Rudolf Diesel
    Rudolf Diesel May 11, 2010

    can you describe the noise?

    Thanks

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 15 Answers

Replace shocks, i did yesterday at Sears because i was have the same problem and it took care of the nosie. the bushung were bad. 10 year old jeep. i ride is awsome now.

Posted on Feb 20, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have 2012 grand cherr every little bump u hit it has 20 in tires on it sounds terrible


If you are describing a Grand Cherokee, the tires are half flat at 20psi. This accounts for your road noise. Chances are the tires now have a pattern or groove from under inflation.

Do not know the specs for your tires, but I generally look at the maximum psi molded into the sidewall of the tire and subtract at least 4 psi to fill them.

If you go to the Discounttire.com site or the Tirerack.com site they have detailed descriptions of how tires are rated for Noise as one element.

Sometires have more noise than others. But irregular wear will make any tire noisier than normal. You also could have a problem in the bearings in the front hubs.

If the tires have not been rotated, do that and it might help.

Sep 02, 2012 | Cars & Trucks

1 Answer

I have 2005 grand Cherokee making noise from front! Sounds like tire noise but it did not change when I rotated tires. Noise is there when ever car is rolling, I tried letting it roll in neutral and the...


If the tires aren't cupped, feathered or chopped then most likely it is the wheel bearing. Though it may be tight it could be dry inside and not yet at the point where you will feel pay.

Jun 27, 2012 | 2005 Jeep Grand Cherokee

1 Answer

Replace Front Wheel Hub Bearing 2002 Jeep Grand Cherokee 2 wheel drive


Removal
  1. Raise and support the vehicle.
  2. Remove the wheel and tire assembly.
  3. Remove the brake caliper, caliper anchor, rotor and ABS wheel speed sensor.
  4. Remove the cotter pin, nut retainer and axle hub nut.
  5. Remove the hub/bearing mounting bolts from the back of the steering knuckle. Remove hub/bearing from the steering knuckle and off the axle shaft.
Installation
  1. Install the hub/bearing to the knuckle.
  2. Install the hub/bearing-to-knuckle bolts and tighten to specification.
  3. Install the hub washer and nut. Tighten the hub nut to specification. Install the nut retainer and a new cotter pin.
  4. Install the brake rotor, caliper anchor, caliper and ABS wheel speed sensor.
  5. Install the wheel and tire assembly.
  6. Remove the support and lower the vehicle.

Apr 22, 2012 | 2002 Jeep Grand Cherokee

1 Answer

The rear end sounds like the bearing is going bad? like a tire with a bad cord.


jack up and remove wheels please use jack stands , rotate each wheel slowly and listen for noise at hubs or differential, maybe just an hub bearing, if axle bearing look for wet backing plate or grease around brakes . if axle bearing you have to get chiltons or haynes Manuel for truck and follow instructions

Mar 15, 2011 | 1999 Jeep Grand Cherokee

2 Answers

Viberation and noise frontend at 50-60 miles an hour.


get front tires balanced, while they have it up in the air ask them to check wheel bearings and ball joints

Dec 23, 2010 | 1999 Chevrolet Silverado 1500

2 Answers

Im am rotating tires on a 94 jeep cherokee the


Move the passenger side rear tire to the front, and passenger side front to driver side rear. Switch the driver side rear tire to the front and driver side front to passenger side rear. Repeat this "X" pattern each time you rotate the tires. Rotate the tires from side to side if the tires are different sizes on the front and rear.

This is the better solution. Hope helped (remember rated this help)

For more details about Jeep Cherokee, review the Service Manual.

Good luck.

Nov 11, 2009 | 1994 Jeep Grand Cherokee

1 Answer

Need help on changing the front right cv joint axle shaft on my 1999 grand cherokee


remove wheel and tire caliper and rotor axle nut hub bearing pull axle out of spindle slide new axle in and reverse procedure

Aug 05, 2009 | 1999 Jeep Grand Cherokee

1 Answer

FRONT END


Drive the car in a parking lot and make left and right hand turns.
If the noise goes away on either turn then the problem is a front hub bearing.
If the noise is still there, it could be possible front differential bearings.

Oct 16, 2008 | 1999 Jeep Grand Cherokee

Not finding what you are looking for?
1999 Jeep Grand Cherokee Logo

Related Topics:

169 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

64034 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...