Question about 2005 Hyundai Accent
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
hi not aware of whether or not you solved horn problem? ie location but for info you will find horn just in front of the crossmember in front of radiator (where the bonnet closes onto ) horn is on the nearside looks like a disc secured by a nut+washer it has a plug on wire connector ps these horns are prone to fault but you might try tapping the horn gently with horn operated/pressed you can purchase a more reliable wind tone/horn and fitto same bracket and replace the terminalplug to connectors for new type easy diy check E BAY for hornes on car accessories ? hope this helps?
Posted on Oct 21, 2008
hi from uk location of fuel safety shut off valve/switch on uk r/h drive accents is on the engine bay bulkhead in front of drivers side it is a square box with red rubber top press button may be on opposite side on l/h drives ? if activated? just press button till click ? to reset these normally only cut off on impact ? to stop elec fuel pump continuing delivering if involved in an R.T.A fire prevention
Posted on Jan 08, 2009
It is always best to start simple on a lot of these things. This code indicates that somewhere in the evaporative system you have a leak that has set off the code. The gas cap is the most common culprit and that is where I would start. Buy a new gas cap and put it on. It may and should solve your problem. A lot of gas caps have rubber seals that do wear out over time. If this does not solve your problem simply use a search engine and type in p0441 a wealth of information will pop up. There are other possible causes and solutions but that's where I would start (with the gas cap)
Posted on Feb 17, 2009
A car can overheat for a lot of reasons.First make sure this is the problem by checking the radiator hose or water level. Open the radiator cap when the car is cold, crank it, and then watch the water level. If it drops when the car warms up this is not the problem.
The tools you will need will depend on what you have to take off to get to it. If you can access the thermostat you should only need a ratchet or wrench to remove it and something to scrape off old gasket with.
Location:The thermostat should be inside the thermostat housing on the motor. Follow your top radiator hose to the place where it goes into the motor. There should be a sort of dome shaped housing there with probably a bolt on either side of it.The thermostat is inside that.
This is a reasonably easy job, but shouldn't be done carelessly. It's also kind of messy.
When the car is cold remove the bolts from the housing with a ratchet. Lots of coolant and water will drain out. But the thermostat will be visible.Pay attention to which side of the thermostat is up.It should just lift up. Remove all the old gasket from around the area and clean it up well. Replace the thermostat and gasket then the bolts. Be very careful not to over tighten the bolts or the housing will be ruined.
Posted on Apr 22, 2009
Tips for a great answer:
Jul 11, 2014 | 2010 Suzuki SX4
Sep 25, 2012 | Hyundai Accent Cars & Trucks
Sep 24, 2012 | 2006 Hyundai Accent
Mar 19, 2011 | Hyundai Accent Cars & Trucks
Mar 05, 2010 | 2004 Dodge Dakota
Nov 18, 2009 | 1999 Hyundai Accent
Oct 23, 2009 | 2002 Hyundai Accent
Jun 01, 2009 | 2002 Hyundai Accent
May 23, 2009 | 2001 Hyundai Santa Fe
Mar 01, 2015 | 2005 Hyundai Accent
146 people viewed this question
Usually answered in minutes!