Its only blowing out like warm air i thought it was maybe the thermastat but after i changed that its still only blowing out warm air and i checked the hoses and one is warm i don't know if that means antthing but hopefully you guys can help
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Not bleeded properly. Not sure whats the correct procedure for this car but you can try running it without a radiator cap until all the air comes out. Do not drive the car until you make sure heater is working and radiator fan comes on. Also look for the bleeding screws around
You could possibly have a bad heater control valve if the car has one. Another item maybe a stuck or faulty blend air door. This would be the actuator most likely. It may not be shutting off all the way to allow complete heat through. The other possibility is a partially clogged heater core.
Engines can rock on the motor mounts. You probably have a vacuum line that is pinched, cracked, broken,kinked, or unhooked. check the engine compartment lines first. If you have thin plastic vacuum lines, they can kink more easily than rubber lines. If you have been working under the dash (replacing a radio, etc) check your work area in case you have a broken fitting on a vacuum housing or an unhooked line.
If the heater core isn't leaking it doesn't likely need changing. It sounds like you could have a problem with the heater control valve - a valve in one of the heater hoses that controls flow through the hose. If you smell coolant and see moisture on your windshield (inside) or have coolant leaking onto the floor - you might need the heater core replaced.
Sounds like you may have a partially plugged heater core. You could flush this out separately, from flushing radiator & engine block. Diconnect heater hoses going to your heater core and clamp off, so not to loose coolant from engine. Now hook up separate hose to one side of heater core pipe and flush out with typical garden hose. Repeat procedure on both heater core inlets. Reconnect original heater hoses and test difference. You may have to add an additional litre of antifreeze. If this don't work i suggest changing heater core. Good luck.........Ron.