Question about 1999 Chrysler Cirrus

Open Question

1999 Chrysler Cirrus won't start - 1999 Chrysler Cirrus

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

fischmilch
  • 96 Answers

SOURCE: 1999 chrysler cirrus

Check the coil packs, or the Ignition module. Disconnect the harness to the ignition module. And test the leads to see if there is current. I don't know what the specs should be, but it will be minimal. Never overlook fuses either.

Posted on Nov 07, 2008

  • 22 Answers

SOURCE: Ignition key won`t turn on my chrysler cirrus

tap the lock cylender with a small hammer it will free up the tumblers and the insert key and its working again.

Posted on Jan 08, 2009

Molson02536
  • 3854 Answers

SOURCE: 1999 chrysler cirrus transmission will not shift

It sounds like it may be you speed sensor at the transmission which is also called Vehicle Velocity Sensor (VVS), The sensor or the wire harness may have gone bad and needs to be replaced, but it's a good thing to have your car scanned at Auto Zone since they scan free of charge. I just want to make sure it is the VVS and not the transmission Control Module (TCM), Check the fuse under the dash and under the hood and look for any blown fuse like the TCM fuse. Good luck and hope this helps, keep me posted

Posted on Jun 24, 2009

  • 880 Answers

SOURCE: where is thermostat in a 1995 chrysler cirrus LX

A tee is located to the right hand side of the intake manifold, on top you should see the coolant system cap, its silver in color and is about 2-3 inches in diameter. This tee is the thermostat housing, it goes to your radiator and engine block, remove it from the block and you should see the thermostat. Remember when replacing the thermostat, the spring side goes into the block! 2.0L and 2.4L it is under where the upper rad hose hooks to the engine. 2.5L it is under where the lower rad hose hooks to the engine.

Posted on Dec 29, 2009

  • 1 Answer

SOURCE: 99 chrysler cirrus lxi won't shift out of 2nd, no speedometer

Had the same problem on my 1999 cirrus lxi. Replaced the output speed sensor on the tranny and topped off the tranny fluid... cleared the check engine light and the cirrus ran great. Caution...the output speed sensor reqires removal of the front left tie and plastic weatherproofing to replace. once you find it's locvation, the replacement is relatively easy.

Posted on Jan 10, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1999 chrysler cirrus will not start


make sure you have a good solid ground for fuel pump @ tank ! I can\'t express this enough. Is power getting to pump ! can you hear it run when you have an assistant turn key to on position ? it will hum for 2-3 seconds. computers rarely go bad ! just heard about a new fuel pump was wired wrong @ the manufactors who built it. that would suck. good luck

Feb 05, 2013 | 1999 Chrysler Cirrus

1 Answer

Has spark has fuel but still won't start


Are you sure it has fuel reaching the cylinders. Spray starting fluid in and see if it fires.

Dec 28, 2012 | 1997 Chrysler Cirrus

1 Answer

Trunk won't open with key or inside release on 1999 chrysler cirrus


does the back seats fold down? you may have to open it from the inside,and it sounds like the lock is jammed . you can replace them and use the old key and cylinder
12_27_2012_9_16_20_pm.png

Dec 27, 2012 | 1999 Chrysler Cirrus

1 Answer

I've got a 1999 Chrysler LXI Cirrus, when the fuse


the switch in the steering column is the most likely culprit not a quick fix since there is an airbag involved might get pricy

Sep 08, 2012 | Cars & Trucks

1 Answer

1999 Chryster Cirrus problems


Just a couple of guesses. Bad (petulant) computer? Maybe a circuit inside that isn't right?
It doesn't sound like a grounding issue if it starts right back up, but you might check the computer ground. Quite often, that ground is on top of the engine, coming out of the wiring harness.
Hope you find it. Puzzling. Might help if you kept a scanner hooked up while driving. Then you might get some freeze frame information.

Apr 12, 2012 | 1999 Chrysler Cirrus

1 Answer

Where is oil sending unit location on 1999 chrysler cirrus 2.4 ?


most likley place is on the engine block look for it there

Oct 24, 2009 | 1999 Chrysler Cirrus

1 Answer

1999 CIRRUS WON'T START!!!


Right area. If it is a 2.4L, replace them. If it is a 2.5L, you need a distributor most likely.

Jun 18, 2009 | 1999 Chrysler Cirrus

1 Answer

My a/c is blowing hot air in my 1999 Chrysler Cirrus and 134 freon didn't work.


they prob blew the charge on the a/c it will have to be recharged

May 25, 2009 | 1999 Chrysler Cirrus

2 Answers

Ignition key won`t turn on my chrysler cirrus


tap the lock cylender with a small hammer it will free up the tumblers and the insert key and its working again.

Jan 08, 2009 | 1999 Chrysler Cirrus

Not finding what you are looking for?
1999 Chrysler Cirrus Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...