Question about Chevrolet Cobalt

Open Question

How do you replace 2008 chevrolet Cobalt hazard warning switch

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 137 Answers

SOURCE: how do I replace my 2006 Chevrolet Cobalt Brakes

first loosen the road wheel nuts. then jack it up. then remove the road wheel. then turn the wheel out (brake side) get a g clamp put one end on the caliber and the other on the outside pad and wind nice and slowly then remove the two bolts holding the caliber and put aside DONOT TOUCH THE BLEEDING NIPPLE OR REMOVE ANY OF THE RUBBER HOSES ON THE BRAKE LINES open the reserveor (BRAKE FLUID CAP) the disk (rotor) look for a retaing screw on it and remove it some cars havem some dont then tap the disk off asemably is the reverse of removel

Posted on Jul 08, 2009

  • 82 Answers

SOURCE: oil filter change Cobalt 2008 Chevrolet

the oil filter is located at the upper side , front of the motor it s a cartridge filter no like regular filters, , you will see a plastic black cap under the intake manifold, will need a gid range

Posted on Sep 03, 2009

  • 1986 Answers

SOURCE: I need instruction on replacing the passenger side

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door

Posted on Sep 29, 2009

rjpoirier_nb
  • 166 Answers

SOURCE: how to fix door handle on chevrolet cobalt 2008

Have to remove inner door panel and is usually 2 bolts around 10mm that hold handle in, but the rods must be removed first and these rods are only held in place by a spring steel clip that just flips out off the rod at the handle end.
To remove door panel - look for visible screws under and around the edges and or handles, remove all these. If window is winding type a horse-shoe clip holds the handle on and can be pushed off with a screw-driver if you push the panel away from handle and look behind the handle.
Then take a putty knife and or butter knives and insert between door and panel to pop plastic clips from door then lift on panel to remove from window jam.  Be careful of wires and plugs after this.  Remove plug clips and place panel aside.  Remove plastic and sound-proofing if any in the corner near the handle and a 10mm 1/4" drive ratchet to remove bolts on each side of handle.
This is a general answer but should work for the Cobalt as well.
East Coast Canada Rocks!!
:))

Posted on Jun 09, 2010

  • 7353 Answers

SOURCE: WHAT TYPE OF OIL DOES

5W30. but make sure it meets GM spec. GM6094M I would use Mobil1 or other synthetic that meets that spec.

Posted on Dec 20, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hazard light fuse


Hazard lights are usually powered by a flasher relay. It will be listed in your manual. Gm usually incorporates them to the internal panel

Sep 03, 2016 | 2007 Chevrolet Chevrolet Cobalt LS

1 Answer

Turn signal relay 2008 jeep location


There is no relay , controlled by integrated power module . Electronics !

Feb 12, 2016 | 2008 Jeep Grand Cherokee Laredo

1 Answer

Where is the stoplight switch on a 2008 cobalt located


It's will be mounted on a bracket near the brake pedal. Removing some of the drivers side lower dash trim pieces will make it easier to see/replace

Mar 01, 2015 | 2008 Chevrolet Cobalt

1 Answer

Hazard switch fell through dash board


youll have to take the pannel off the dash and retreve the switch.make sure it click or snaps back in its origional hole or you may need a new one..

Apr 08, 2014 | 2008 Chevrolet Cobalt

2 Answers

My 2008 Chevy Cobalt coupe has a passenger side turn signal that flashes fast on the instrument panel. However, no turn bulb is burnt out in either the front or rear. The rear passenger turn blub just...


It is as simple as your hazzard switch needs to be replaced yes your hazzard switch as now turn signals are built threw the hazzard switch my PT Cruiser had same problem as my s10 replaced hazzard switch fixed the problem

Aug 18, 2011 | 2008 Chevrolet Cobalt

1 Answer

My hazard lights wont turn off, my button is broke!! need to figure out how to turn them off please help before my battery goes dead!


check the fuse panel for the emergency flashes and pull the fuse,, It probably runs more than just that one function, but at least you'll save the battery untill you get a new switch

May 04, 2011 | 2008 Chevrolet Cobalt

1 Answer

Howto change a key cylinder for a chevy cobalt


There is a TSB on this issues if your having ignition lock issues.
Service Information
2009 Chevrolet Cobalt | Cobalt, G5 (VIN A) Service Manual | View All Bulletins | Document ID: 2325129

#09-02-35-005: Ignition Key Difficult to Remove, Ignition Key Binds or Sticks in Cylinder (Replace Ignition Cylinder) - (Aug 10, 2009)

Subject: Ignition Key Difficult to Remove, Ignition Key Binds or Sticks in Cylinder (Replace Ignition Cylinder)

Models: 2008-2009 Cadillac CTS (Built Prior to VIN Breakpoint 90163371)

2005-2009 Chevrolet Cobalt (Built Prior to April 14, 2009)

2006-2009 Chevrolet HHR (Built Prior to April 14, 2009)

2007-2009 Chevrolet Equinox (Built Prior to July 2008)

2005-2006 Pontiac Pursuit (Canada Only)

2006-2009 Pontiac Solstice (Built Prior to April 14, 2009)

2007-2009 Pontiac G5 (Built Prior to April 14, 2009), Torrent (Built Prior to July 2008)

Attention: This bulletin only applies to vehicle equipped with automatic transmission.

Aug 05, 2010 | 2005 Chevrolet Cobalt

3 Answers

Where does the flasher go on a 98 chevy malibu


Replacement The turn and hazard flashers are integrated into one flasher on these models. The flasher is located in the hazard warning switch and the hazard warning switch is located on the trim plate. Replace the flasher by unplugging the old one, removing it from the panel, and plugging in the new one.
  1. Remove the bezel from the ignition switch.
7f58edd.gif
Remove the bezel from the ignition switch

Carefully remove the instrument panel accessory trim plate.

9f5c3cc.gif
To remove the trim plate, use a suitable prytool to carefully apply pressure at the retaining clip points . . .

bd28884.gif
. . . then gently pull the accessory trim plate away

Detach the electrical connector from the hazard warning switch.

daa6205.gif
Unplug the electrical connector from the hazard warning switch . . .

Unfasten the screw securing the hazard warning switch and remove the switch.

c506713.gif
. . . then unfasten the screw securing the hazard warning switch and remove the switch from the vehicle


Installation is the reverse of removal.

Dec 01, 2009 | 1998 Chevrolet Malibu

1 Answer

The turn on lights does not flash


Check out this recall below:
Bulletin No.: 04098A

SPECIAL POLICY
Subject:
04098 - Special Policy Adjustment - Turn Signal/Hazard Warning Flashers 

Condition
Some customers of 1999-2002 Chevrolet Malibu, Oldsmobile Alero, Pontiac Grand Am, and 1999 Oldsmobile Cutlass may have turn signal/hazard flashers that become inoperative.

Special Policy Adjustment
This special policy covers the condition described above for a period of 10 years or 150,000 miles (240,000 km), whichever occurs first, from the date the vehicle was originally placed in service, regardless of ownership. The repairs will be made at no charge to the customer.

Good luck and hope this helps:
HAZARD WARNING SWITCH REPLACEMENT - ON VEHICLE 
REMOVAL PROCEDURE 

Remove the center air louver deflector. Refer to Air Deflector Louver Replacement - Center Vent. 
Remove the instrument panel cluster. 
Remove the hazard warning switch bezel from the instrument panel using a small-flat bladed tool to release the retainers.
Remove the left side bolt from the hazard warning switch through the instrument panel cluster pocket Remove the right side and center lower bolts from the hazard warning switch through the center air louver deflector pocket.
Reposition the hazard warning switch from the instrument panel to access the electrical connector. 
Disconnect the electrical connectors from the hazard warning switch. 
Remove the hazard warning switch from instrument panel. 

INSTALLATION PROCEDURE
Connect the electrical connectors to the hazard warning switch.
Position the hazard warning switch to the mounting points in the instrument panel. NOTE: Refer to Fastener Notice in Service Precautions.
Install the left side bolt to the hazard warning switch through the instrument panel cluster pocket. Tighten Tighten the left side hazard warning switch bolt to 3 N.m (27 lb in) . 
Install the right side and center lower bolts to the hazard warning switch through the center air louver deflector pocket. Tighten Tighten the left side hazard warning switch bolt to 3 N.m (27 lb in) . 
Install the hazard warning switch bezel to the instrument panel pressing into place until fully seated. Install the instrument panel cluster. 
Install the center air louver deflector. Refer to Air Deflector Louver Replacement - Center Vent.

May 24, 2009 | 2000 Oldsmobile Alero

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...