An expert who has achieved level 2 by getting 100 points
An expert that got 5 achievements.
An expert whose answer got voted for 100 times.
An expert whose answer got voted for 20 times.
Re: dodge ram 1500 wobble when braking
There is chrysler TSB 02-001-07 Rev. A. that addresses this issue. it requires replacement of the control arm bushings. if your vehicle is still under warranty this will be covered. if your dealership has the parts the repair takes about 4 hours
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Your rims are not properply seating on yje hubs.make sure yje center hole on the rim is fitting over the axle hubs. Check for chamfering of the inner edge of the rim hole so the radius on the hubs don't eep the wheel from fully seating.. After market rims are not generic fit. You risk losing a wheel going down the road if fit is not corrected.
P2299-BRAKE PEDAL POSITION / ACCELERATOR PEDAL POSITION INCOMPATIBLE
The PCM recognizes a brake application following the APPS showing a
fixed pedal opening. Temporary or permanent. Internally the PCM will
reduce throttle opening below driver demand. One trip fault and the
code will be set within 5 seconds. ETC light will illuminate, the light
will only stay illuminated while DTC is active.
DRIVER PRESSING ACCELERATOR PEDAL, THEN PRESSING BRAKE PEDAL, AND CONTINUES TO HOLD THEM DOWN SIMULTANEOUSLY
STOP LAMP SWITCH
The most likely cause of this DTC is
Brake Torquing the engine by pressing the Accelerator pedal and the
pressing the Brake Pedal.