Question about 1999 GMC Jimmy
Car wouldn't start and put new fuel pump on and new gas and still won't start?
Have you checked the fuel pressure at the injector ? It has to be at least 60psi for the engine to start.
Posted on Dec 08, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
pull line off of front of filter and cycle key 2 on position if there is no fuel present your feul pump may b the problem, before replacing old one make sure the fuse is good
Posted on Oct 06, 2009
A bad fuel pump will not keep the engine from turning over. I would first test your battery and make sure your connections are clean. If that check out I would check your starter and starter relay.
Posted on May 12, 2011
SOURCE: My 2001 GMC Sierra just
When your replaced the pump did you replace the fuel filter? You may have a fuel pump relay causing you some grief. I believe it is located in the engine compartment in the fuse center on the left inner fender. Check the relay and any related fuses. Check the electrical connection at the pump. They had problems with some of them and they would get kind of hot and distort and corrode. They have new updated ones that can be easily installed.
Posted on May 15, 2011
Nephew had similar problem on different vehicle - had spark to plugs, limited gas, everthing else checked. I did one thing first - check for two fuel filters - one in the tank was only screens and one in the line itself. Found a little in line filter just outside of engine compartment under car next to frame that looked like it had never been changed - partially clogged - replaced it.Almost ran but would not keep running. I had rotor and cap pulled - found that the screw holding rotor in place was loose. The rotor edge next to plug wire leads was chopped up and the cap's plug wire leads were heavily oxidized. Replaced them and got it running but a little rough. Pulled the spark plugs and found gaps from 25 - 100 ---replaced the plugs with correct gapping and it ran really well.
Posted on Sep 01, 2011
Tips for a great answer:
Jan 31, 2013 | 2000 Ford Explorer Eddie Bauer
Dec 22, 2012 | Cars & Trucks
Nov 17, 2012 | 1997 Toyota 4Runner
Jun 18, 2017 | 1995 Ford Contour
Sep 13, 2011 | 1996 Plymouth Breeze
Jul 20, 2011 | 1998 Chevrolet Blazer
Jun 05, 2017 | Chevrolet 1500 Cars & Trucks
Jun 09, 2011 | 1997 Chevrolet Tahoe
May 24, 2011 | 2001 Volkswagen Beetle
Mar 14, 2017 | 1998 Nissan Altima
183 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: