Question about 2010 Toyota Corolla

Open Question

2010 Corolla S fan light inop

The backlighting for the selector dial and heater control work, also the lighting for center "buttons" of all controls work, ac/defrost/circulation.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1861 Answers

SOURCE: No lights on heater/fan panel.

Yes, there is illumination behind the heater control panel.

You need to remove the center inst cluster upper (radio) & lower finish (heater) panels to gain access to the heater control; the light socket is behind the heater panel.

Posted on Oct 06, 2008

  • 1 Answer

SOURCE: Toyota Corolla AC/heater fan only works intermittently

I had the same problem on my 2004 Corrolla and ultimately it only worked on high. The dealer charged me $45 diagnostic fee and almost immediately told me it was a part called the blower resister. They knew the answer right there and then but only realesed it when I agreed to pay the diagnostic. They charged me 179.00 to fix the AC and later I found out the part cost $8.95 and a novice could have replaced it themselves.

Posted on May 04, 2009

okcfirewall
  • 80 Answers

SOURCE: 95 corolla wagon instrument panel do not light up

somewhere on you dash is a dial, button or slider that controls the inside dome light it also controls and dims the dash lights. someone has probably turned this all the way down by accident. just find it and turn it back up. it will usually have a light symbol on or next to it. I hope this helps and good luck

Posted on Aug 01, 2009

  • 1 Answer

SOURCE: 2005 Toyota 4Runner AC temp. control lights are not working.

I am going to guess that the peanut bulb in the knob is burned out.

I had a similar problem with my 2003 4Runner and changed the bulb and it worked fine.

The dealer told me it would take about 8 hours to change the 3 dollar bulb. I looked in my manual and it took me between 5 and 10 minutes tops.

I don't remember what the bulb number is. I do know that I had to get it from a Toyota dealer and not a regular auto parts store.

Hope this helps.

Jeff
jaddison@westelcom.com

Posted on Sep 10, 2009

  • 347 Answers

SOURCE: 1990 Camry Fuse Diagram. The following suddenly

REPLACE BUSTED FUSES

Posted on Jan 01, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Which fuse to change for steering wheel lights and gear shifter lights 2010 ford edge


It's not a fuse , the SJB - smart junction box controls these lights ! This is fords body control module . If the Heater / A/C control panel ,hazard switch ,headlamp switch , message center switch all work, it is not a fuse . The gear shifter I would say the bulb is burnt out . The steering wheel lights could be out because of an open in the clock spring . The clock spring is a device inside the steering column under the steering wheel that keeps your horn , cruise control , radio buttons etc... connected electrically . How cars clock spring works

Feb 04, 2016 | 2010 Ford Edge

1 Answer

Why aren't lights for center console on the shifter working?


Could have a wiring problem , a wiring pin backed out of a connector ! If you don't know about automotive electrical an wiring diagrams an electrical wiring trouble shooting I suggest you take it to a ASE certified repair shop .
Instrument Cluster and Panel Illumination The instrument cluster and panel illumination is used to provide backlighting to the instrument panel, switches, and control components when the headlamp switch is in either the PARKING LAMPS ON or HEADLAMPS ON position. The level of intensity is adjustable by pushing the instrument panel dimmer switch either up to increase intensity or down to decrease intensity.
The dimmable backlighting components are:
  • Instrument cluster
  • Hazard switch
  • Rear defroster switch
  • Message center switches
  • Parking aid switch (if equipped)
  • Transmission range selector
  • Fog lamp switch
The non-dimmable backlighting components are:
  • Driver front door lock and power window control switch
  • Passenger front door lock and power window control switch
  • Driver rear door power window control switch
  • Passenger rear door power window control switch
Principles of Operation
The instrument cluster sends a signal to the instrument panel dimmer switch. The instrument cluster provides a variable pulse width modulated (PWM) signal to the dimmable backlighting components in accordance with the position of the instrument panel dimmer switch.
  1. Verify the customer concern.
  1. Visually inspect the following for obvious signs of mechanical or electrical damage.

    Visual Inspection Chart Mechanical Electrical
    • Instrument panel dimmer switch
    • Smart junction box (SJB) fuse(s):
      • 7 (10A)
      • 15 (30A)
    • Circuitry
    • Illumination bulbs
    • Instrument cluster
    • SJB
    1. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
    1. NOTE: Make sure to use the latest scan tool release software.
      If the cause is not visually evident, connect the scan tool to the data link connector (DLC).
    1. NOTE: The vehicle communication module (VCM) LED prove-out confirms power and ground from the DLC are provided to the VCM.
      If the scan tool does not communicate with the VCM:
      • Check the VCM connection to the vehicle.
      • Check the scan tool connection to the VCM.
      • Refer to Section 418-00 , No Power To The Scan Tool, to diagnose no communication with the scan tool.
    1. If the scan tool does not communicate with the vehicle:
      • Verify the ignition key is in the ON position.
      • Verify the scan tool operation with a known good vehicle.
      • Refer to Section 418-00 to diagnose no response from the powertrain control module (PCM).
    1. Carry out the network test.
      • If the scan tool responds with no communication for one or more modules, refer to Section 418-00 .
      • If the network test passes, retrieve and record the continuous memory DTCs.
    1. Clear the continuous DTCs and carry out the self-test diagnostics for the instrument cluster.
    1. If the DTCs retrieved are related to the concern, go to the Instrument Cluster Diagnostic Trouble Code (DTC) Index. For all other DTCs, refer to Section 419-10 .
    1. If no DTCs related to the concern are retrieved, GO to Symptom Chart .
Symptom Chart Condition Possible Sources Action
  • One or more module-controlled illumination source(s) is inoperative
  • Circuitry
  • Inoperative illumination source component
  • Go To Pinpoint Test A .
A2 CHECK VOLTAGE TO THE INOPERATIVE ILLUMINATION SOURCE
  • Key in OFF position.
  • Disconnect: Inoperative Illumination Source Connector.
  • Key in ON position.
  • Place the headlamp switch in the PARKING LAMPS ON position.
  • Measure the voltage between the inoperative illumination source, harness side and ground according to the following table:

    Illumination Source Connector- Pin Circuit Rear window defrost switch C2340-3 19 (LB/RD) Hazard flasher switch C2039-8 19 (LB/RD) Parking aid disable switch C2339-3 19 (LB/RD) Message center INFO switch C269a-3 19 (LB/RD) Message center SET switch C269b-3 19 (LB/RD) Transmission range selector C2096-4 19 (LB/RD) Fog lamp switch C2341-3 19 (LB/RD)
  • Is the voltage greater than 10 volts?

Feb 02, 2016 | 2008 Mercury Mariner

1 Answer

Is there a service bulletin for a Pontiac G5 for electrical issues?


their are 7 recalls on the 07 none are for an electrical problem with lighting system
http://www.pontiacproblems.com/recalls/G5/2007 and the following tsb from march 2010 is for flickering lights
  • TSB #PIC-5073B NHTSA ID #10034409
    • Date Announced: MARCH 01 2010
    • Additional Info: How to Fix
    Summary: CHEVROLET/PONTIAC: VARIOUS ELECTRICAL CONCERNS. SIR LIGHT, IP LIGHTS FLICKER/INOPERATIVE, PARKING LAMPS FLICKER/INOPERATIVE, TAIL LAMP DIM/INOPERATIVE, TRUNK OPEN LIGHT, RADIO INOPERATIVE DOOR LOCK INOPERATIVE, NO START, NO CRANK. POSSIB
    More Information »

ELECTRICAL SYSTEM:WIRING

  • TSB #PI-0817 NHTSA ID #10047261
    • Date Announced: SEPTEMBER 01 2012
    • Additional Info: How to Fix
    Summary: CHEVROLET/PONTIAC/SATURN: ENGINE FAILS TO START AFTER ENGINE CRANKS DUE TO FUEL PUMP WIRE HARNESS CONNECTOR NEEDS REPLACING, WITHOUT REPLACING FUEL PUMP COVER ASSEMBLY (FUEL PUMP FLANGE). MODEL 2007-2010 COBALT, G5, ION. *PE
    More Information »

ELECTRICAL SYSTEM:FUSES AND CIRCUIT BREAKERS

  • TSB #PIC-4578 NHTSA ID #10022806
    • Date Announced: JUNE 01 2011
    • Additional Info: How to Fix
    Summary: EPS/STR WHEEL CONTROL FUSE (#19) OPEN. *KB UPDATED 10/04/07. *NJ UPDATED 8/7/09. *PE UPDATED 8/1/11. *PE

    More Information »
  • TSB #PIC3385 NHTSA ID #10020916
    • Date Announced: FEBRUARY 01 2008
    • Additional Info: How to Fix
    Summary: REPEATED PARK LPS FUSE OPEN. *KB (ADDITIONAL INFORMATION) UPDATED 4/1/08. *NJ
2007 Pontiac G5 Recalls CarComplaints com

Sep 21, 2015 | 2007 Pontiac G5 Gt Coupe

1 Answer

Fan Blows, heater works, NO light on "A/C" Power


Yeah, before you do that, check all your fuses first to make sure there isn't a blown fuse. If all ok then it's time to start looking into the ac control panel. Some panels can be disassembled and a little cleaning can get them working again, just takes a little time, better that $300 to $500 for a new one.

Jun 28, 2011 | 1999 GMC Yukon

1 Answer

Renault Clio Air Con Fan Problem - Wont turn off


Find Someone else,
Have Them Replace The Fan Selector Switch,
There Is Only 1 Fan In The System, Since You Can Select Between Defrost, Dash, Floor,
But Cannot Control Fan Speed/Shut-Off Fan.
I Would Replace The " Fan Selector Switch" Installed In Your Heater-A/C Controller Unit
Mounted In Your Dash.
Take Care God Bless

Jul 02, 2009 | 2000 Renault 181

1 Answer

2003 Kia Optima - Dashboard Lights not working.


if you have aftermarket lights hooked up to the dash light it has been known to smoke the rheostat that controls the dimmer. I would also check the other fuses, sometimes the cluster refers to the guages themselves and not the lights that illuminate them

Jun 26, 2009 | 2003 Kia Optima

1 Answer

2006 tacoma prerunner sr5, fan speed light out on dial,how to fix


if the switch still works then you will have to replace the switch. You are talking about the light on the button right?

Jun 10, 2009 | 2006 Toyota Tacoma

2 Answers

Heater Control Dash Light Out


there is a bulb in the heater setting dial,remove the dials you will see the bulb,little ***********to change

Dec 27, 2008 | 2001 Volkswagen Jetta TDI

1 Answer

Climate control interior light replacement


You need to remove the console upper panel, and the center inst panel finish. Remove the screw under the middle knob, and the 4 screws behind the upper compartment door. Disengage the 4 clips and the 4 claws. Pull it straight out. Release the 2 claws that holds the heater control to the inst panel. You should now be able to access the bulbs. This should help you; repost if you have any problems.

Oct 10, 2008 | 2004 Toyota Corolla

2 Answers

No lights on heater/fan panel.


Yes, there is illumination behind the heater control panel.

You need to remove the center inst cluster upper (radio) & lower finish (heater) panels to gain access to the heater control; the light socket is behind the heater panel.

Oct 06, 2008 | 1994 Toyota Corolla

Not finding what you are looking for?
2010 Toyota Corolla Logo

Related Topics:

40 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...