Question about 2004 Chevrolet Impala

1 Answer

2004 chev impala cruse control not working

Cruse control does not work any more, tried to pull up brake peddle, it worked for a while and now its not working again. green light does not come on.

Posted by on

  • idaholady32 Jan 14, 2009

    thanks, willget that checked out

  • Anonymous Mar 17, 2014

    light up wont kick on

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 16 Answers

If pulling up on the brake pedal worked, lets start there. I'm not sure on that specific car, but there should be a white switch on the brake pedal bar up under the dash that turns on the brake lights when you push the pedal. It would also turn of the cruise. those switches are adjustable. it should skrew in and out. if that is the problem, you've probably been driving around with the brake lights on all the time.

Posted on Jan 14, 2009

  • Jeremy Stringer Jan 14, 2009

    if pulling up on the brake pedal worked, lets start there. I'm not sure on that specific car, but there should be a white switch on the brake pedal bar up under the dash that turns on the brake lights when you push the pedal. It would also turn of the cruise. those switches are adjustable. it should skrew in and out. if that is the problem, you've probably been driving around with the brake lights on all the time.

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

5 Answers

How come my cruise control won't even light up, much less work? 2004 trailblazer


has a fuse and an actuator motor or
the set resume switch could be faulty

May 31, 2016 | 2004 Chevrolet TrailBlazer

1 Answer

Can the brake light sensor prevent the cruise control to work


yes it can. your cruse will disengauge when you apply your brake.

Nov 23, 2014 | Cars & Trucks

1 Answer

Where is fuse for cruse control


It could be either.....Cruse Control vacuum hose off or has cracks (located inside the engine area) or the 'kick-off' switch located on the brake peddle is bad. That being said, the lid of your fuse box should have a list of what each fuse is and location....also will be in your owners manual.

Oct 17, 2014 | Cars & Trucks

1 Answer

My 2004 chev impala headlight won't turn on and


If you made sure your battery connections are tight then you may need trace you hot wire for a bad connection around the fusible links that run from battery.

Aug 23, 2013 | Cars & Trucks

1 Answer

My 2004 chev impala climate control blowes cold on driver side and warm on the other side


The climate control on that car has two electric motors. one for each side.They are located under middle of the dash.Alot of times they get stuck,and all you have to do is pull the linkage and alot of times it will start working again..They probably been in one position for a long time..You should have a panel to remove and you can access them without alot of problems

Sep 04, 2011 | 2004 Chevrolet Impala

1 Answer

2006 Chev Impala turn signals not working on rear lights, turn signal flashing at a faster rate than normal, No brake lights when pushing on brakes.


Two issues here, you will need to replace the flasher. this will correct the erratic turn signals.

Concerning the brake light. Make sure the bulbs are in working condition and, check the wiring harness for faults as well. if the bulbs and wires arr OK, replace the brake light switch.

You can test for proper current by pulling the brake light bulbs out the socket and, use the copper prongs inside the brake light socket for testing. use a volt meter and, hit the brake pedal and, see if the meter registers a current. if not, replace the wiring harness.

Jun 04, 2009 | 2006 Chevrolet Impala

1 Answer

2007 Dodge Ram 2500 - Brake peddle wobbling


only comes as a whole pedal assembly. not to hard to change out though just takes a little while if its your first one

May 21, 2009 | 2004 Dodge Ram 2500

2 Answers

Cruse controll


Pull up on the brake pedal. If that does not work check your brake light bulbs (LED brake lights will also keep your cruise control form working). Finally check all of the fuses. This system needs at least 3 different fuses to work properly.

Aug 05, 2008 | 1998 Honda Accord

1 Answer

Cruise control does not work


Replace the Brake light control switch located in front of the brake peddle under the dash this also turns the cruise off when braking. While driving put your foot behind the brake peddle and pull back toward you while doing this try your cruise if it works there are three possible causes or a combination of all three. Brake control Switch, Loose or sloppy brake pedal not activating the Brake switch properly or week brake pedal return spring. Good Luck.

Jul 26, 2008 | 1994 Jeep Grand Cherokee

Not finding what you are looking for?
2004 Chevrolet Impala Logo

260 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61292 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...