Question about 2007 Honda CR-V
How to replace the spotlight bulb in a 2010 Honda CR V?
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Took the dimmer switch out to check for problems. Quite easy to do, but as soon as I pulled the block connector out of the dimmer switch, I could see a small burn mark on the block connector!! And…the male pins that connect into the block connector were slightly corroded and had some burnt plastic between the pins.
Cleaning and scraping corrosion off of pins and connector solved the problem.
If you are having some low beam light issues, and are uncomfortable with these repairs, let your mechanic know to examine the block connector-to-dimmer switch connections for corrosion if all fuses and relays check out.
Unfortunately, the switch may not be the problem but the connection sure was! It pays to noodle around sometimes.
This also may be the root cause of excessive bulb failures. Our CR-V did not start blowing bulbs till this year, after 4 years of ownership. The dimmer switch is a low current switch that really just turns on the relays for the headlights. Increased resistance in the block connector and pins may have been the root cause all along.
Posted on Apr 23, 2009
UNSNAP PUSH-PIN FASTENERS FROM BOTTOM OF CENTER CONSOLE
AND REMOVE BOTTOM PANEL.
2. EXTRACT 4 SCREWS FROM BOTTOM EDGE OF BEZEL. EXTRACT 4
SCREWS FORM INSIDE DASH BELOW POCKET. PULL CUP HOLDER/
POCKET ASSEMBLY OUT OF DASH AND REMOVE.
3. OPEN GLOVE BOX AND REMOVE STOPPERS. EXTRACT 2 SCREWS
FROM RIGHT SIDE OF CENTER DASH BEZEL..
4. FROM BELOW STEERING WHEEL EXTRACT 2 SCREWS FROM BOTTOM
EDGE OR PANEL, UNSNAP UPPER EDGE OF PANEL, UNPLUG, AND
5. UNSNAP TOP EDGE OR CENTER LOWER BEZEL, UNPLUG, AND REMOVE.
6. EXTRACT 2 SCREWS FROM SIDES OF POCKET.
7. UNSNAP RADIO/AC CONTROL DASH BEZEL, UNPLUG, AND REMOVE.
8. EXTRACT 2 SCREWS FROM EACH SIDE OF THE RADIO BRACKET
ASSEMBLY TO REMOVE RADIO FROM DASH/AC BEZEL.
Posted on May 18, 2009
thermostat problem happens and unfortunately some do become faulty and you may need to replace it.I am assuming you are talking about the engine cooling thermostat switch that triggers the start of the fan here.Let me know if I am wrong and I will try my best to help.
Posted on Oct 06, 2009
Tips for a great answer:
Jul 14, 2017 | Honda Cars & Trucks
on May 10, 2012 | 2002 Honda CR-V
on May 10, 2012 | 2005 Honda CR-V
Jan 16, 2011 | 2006 Honda CR-V
Apr 21, 2010 | 2006 Honda CR-V
Feb 27, 2010 | 2007 Honda CR-V
Nov 28, 2009 | 2006 Honda CR-V
Jan 30, 2009 | 2004 Honda CR-V
343 people viewed this question
Usually answered in minutes!