Question about Lexus IS 300

1 Answer

Have a 2001 lexus is300 with a code p1125 won't start what's wrong

Replaced crank sensor and crank shaft pully te car ran for 5 mins shut off and couldn't stat the car again.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Lexus Master
  • 21,873 Answers

The code is for a failed throttle control motor or circuit.
You might check to see if the throttle control is plugged in, otherwise you may need a shop manual to test the component.

Posted on Dec 07, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 88 Answers

SOURCE: 2001 ford windstar code P0340 cam shaft sensor malfunction

You most likely have a 3.8 liter motor. You need to have a obd-2 diagnostic performed. Pep boys, Autozone, Aamco etc. can do this. (Ford also, but costly). If cam sensor failing, code will be stored in e.c.m, and data stream will prove out. The cam sensor failure is common on fords and they are usally available aftermarket (save a few dollars over O.E.M.) . If there is another problem, the diagnostic will help determine. Windstars are also prone to fuel pump failures and ignition switch problems.

Posted on Mar 14, 2009

inhisname
  • 76 Answers

SOURCE: 2001 jeep grand cherokee 4.0 engine shuts off

it is possable/likely a bad ECTS (engine coolant tep. sensor), this can cause the injectors to allow to much fuel into cylinders and cause a low compression and or flooding situation, good luck, marty

Posted on Jun 07, 2009

ghost4548
  • 776 Answers

SOURCE: 2001 Hyundai accent crank position sensor needs

Go to http://www.hmaservice.com/ and register (vehicle by VIN). Afterward, you'll have access to technical information (manuals, wiring diagrams, service bulletins, etc) about your vehicle.

Posted on Jul 18, 2009

csmock132
  • 4669 Answers

SOURCE: 89 wrangler 2.5 5 speed.replaced crank sensor last

It sounds like your new crank sensor is defective. It should be under warranty.

Posted on Sep 02, 2009

  • 21 Answers

SOURCE: i have a 2004 kia rio manual trans. it will crank

Sounds like most of Kia problems...timing belt !
BEWARE that this is an "Interference Engine", meaning the valves and pistons "interfere" with each other and more than likely serious damage has already occurred.
If this is in fact the case engine will need to be rebuilt or replaced.
Good Luck!

Posted on Dec 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Cranks but won't run.


I firmly believe that Lexus should be serviced by the dealership. Mine is done every 8 months. They have the diagnostic equipment and expertise. First thought on yours is fuel pressure, or a faulty sensor. Put it on an OBD11 Code Reader. The test connector for fuel pressure is on the fuel rail near the bulkhead.

Others have the same fault!

https://www.google.ca/search?q=2002+Lexus+IS300+that+will+not+run&ie=utf-8&oe=utf-8&gws_rd=cr&ei=pWh-WfONPKGsjwSDraXwCw

Jul 30, 2017 | Cars & Trucks

2 Answers

Where is my throttle sensor on my 01 lexus is300


On the end of the throttle plate shaft. On the opposite side of the accelerator cable.

Jan 14, 2013 | 2001 Lexus IS 300

1 Answer

Replaced timing belt and car won't run


You had better check the timing belt again, you may have done something wrong and it skipped teeth.

Sep 04, 2012 | 2001 Volkswagen Beetle

2 Answers

1998 chevy s10 driving along and engine shut down.after sitting 10 min.it started but was rough.went 100.ft and it shut off again.sat for a while.it started and ran a couple miles like nothing was ever...


if it shuts off while driving and will not start back up for at least 10 minutes, then it may be the crank sensor doing this. is check engine light on! if so get it scanned to find problem code. if no scanner, auto-zone will scan for free. if light is on. CPS symtoms are: car dies and won't re-start till it cools down, or won't start at all. good-day ! crank sensor timing will be out of sync. it controls timing and sends info to pcm.

Jul 19, 2011 | 1998 Chevrolet S-10 Pickup

3 Answers

2000 Mercedes CLK..I think it is a vapor lock problem..car starts as usual but 5-7 minutes later it just shuts down..happened in traffic..so I dont dare to drive it..Afterwards it doesnt start unril...


Sounds like the crankshaft position sensor needs to be replaced. They are a common problem with the Mercedes. That sensor is the one that the engine control module looks at to see if the engine is running. When they get hot and stop producing a signal the engine control module thinks the engine is not running and shuts of the fuel. After waiting awhile they cool down and the vehicle will start up again. I've changed many of them when I worked at the dealer. Tricky part is when there working and the car is running there will be no check engine light on or code stored. Usually will only have the code when the car won't start. Let me know what you end up finding out on it but that would be the first place to look and probably the cheapest.

Apr 20, 2011 | 2000 Mercedes-Benz CLK

1 Answer

Where is coolant temp sensor located for a 01 lexus is300


Where is my 2001 Lexus is300 coolant sensor located at can write at drevargas70@gmail.com o can text 414-856-6955 I'll appreciate

Feb 17, 2011 | Lexus IS 300 Cars & Trucks

1 Answer

When I change the temperature in my is300 2001 it


temperature blend door actuator is the name and the little plastic gears has wore out you will need to replace two choices the lexus dealer or salvage yard you decide

Mar 21, 2010 | 2003 Lexus IS 300

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

239 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lexus Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

872 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...