Question about 2001 Porsche Boxster

2 Answers

Why don;t my turn signals work and my hazards do on my 2001 porche boxster

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Two completely separate fuses. Replace both if you are unsure as to which one is not working. before you do, check to insure any wiring insulation is not bared on the positive side of turn signals causing fuses to blow.

Posted on Dec 08, 2012

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 12 Answers

First thing id do is check fuses they are different to hazard lights

Posted on Dec 07, 2012

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 23 Answers

SOURCE: No brake lights 2003 Boxster

check under and around your entire brake pedal assembly in the car. there may be a contact switch or something like it being blocked by dirt or object.

Posted on Jul 09, 2009

badealer888
  • 414 Answers

SOURCE: 2002 Porche Boxster engine will not turn over

test battery and starter, first.

Posted on Jul 12, 2009

  • 504 Answers

SOURCE: i have a 97 boxster

check fuses/window control relay/window switch/loom in door

Posted on Mar 09, 2011

  • 330 Answers

SOURCE: battery dead from a porche

hello there
send me an email and i will send you a factory picture of an Emergency operating cable how to get to your battery.
It is located in your right front wheel well behind the black plastic lining,near the top

proporsche@yahoo.com

proporsche

Posted on Jun 23, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does the horn in my porche bolster go off on its own now an then


A short in the wiring somewhere. IT may be touching ground sometimes causing it to go off. Replace the horn switch. And check the wiring to the horn under the hood.

Jun 05, 2014 | 2001 Porsche Boxster

2 Answers

My turn signals and hazard lights stopped working


Hazard switch..had it happen to my 2002 impala

Dec 13, 2013 | 2001 Chevrolet Impala

1 Answer

I need to find the flasher relay for a grand marquis 2001 .does it has one? My turn signals wont work I can hear the sound but don't even flash


Yes, it does have a flasher, although it may be a combined unit with the hazard flashers relay. So you hear the clicking of the flasher relay? That seems to indicate the relay is working properly. Have you checked the bulbs and the turn signal fuse? Any turn signal bulbs light up anywhere, front or back?
How about your brake lights, do they work? Your car may have separate, stand alone turn signals in the rear, but many American cars use the same bulb and same filament on the bulb for the brake lights and turn signals. If your merc is like this and the brake lights work, then the bulb must be good.
Turn on the hazard flashers and see if all bulbs work and flash at each corner of the car. This would be the same bulb as for the turn signals. If they work, it could be a bad turn signal switch, may even be the flasher relay somehow malfunctioning, and in a few cases, a bad hazard switch can affect the turn signal switch. Check fuses and bulbs first. If you have any type of body control module that controls lights and other accessories, you may have to investigate that. I know I'm not being very helpful, just throwing out a few suggestions. Good luck.

May 21, 2012 | 2001 Mercury Grand Marquis

1 Answer

My car doesn't have a fuse diagram and my hazards and turning signals don't work. I bought fuses but don't know which one to change.


just pull them all out one at a time till you find the blown one .but if all fuses all ok then change the hazard warning light switch as this is the most likely unit to fail and cause these problems

Sep 26, 2011 | 2001 Ford Mustang

1 Answer

How to fix turn signal on 86 Chevy Astro Van


you don`t say but do the lights work either on the front/back on both sides.if not then it may be a fuse that needs replacing or need a bulb replacement.if the lights work but don`t flash then it sounds like a signal flasher problem.the flasher is located in the fuse panel under the dash on the drivers side.if the hazard flashers work then turn them on to find the hazard flasher by the fuse panel then you will know what the signal flasher looks like and change the signal flasher.make sure you change the one for the signals and not the hazard one.if the hazards work then i would say the signal switch is good as the hazards work through the same switch.

Apr 21, 2011 | Chevrolet Astro Cars & Trucks

1 Answer

2001 Boxter mechanic said it needs a new clutch not sure Wants $ 4000.00 ?? Is it that big of job


i would phone a porche dealer and ask them the price of a new clutch,you maybe suprised.....

Sep 11, 2010 | 2001 Porsche Boxster

1 Answer

Turn signals were intermittent and now will not


It is absolutely possible, and recalls are free. Take the free recall and hope it solves your issue!

Dec 10, 2009 | 2001 Oldsmobile Alero

1 Answer

Turn signals quit working. Can't find a fuse labeled for turn sig


Check the flasher unit on both turn and hazard lights,

make sure hazards are off
if hazard flasher bad and and on it will interfere with turn signal

Sep 05, 2009 | 2001 Dodge Ram 1500 Truck 2WD

1 Answer

No brake lights 2003 Boxster


check under and around your entire brake pedal assembly in the car. there may be a contact switch or something like it being blocked by dirt or object.

Jul 09, 2009 | 2001 Porsche Boxster

Not finding what you are looking for?
2001 Porsche Boxster Logo

161 people viewed this question

Ask a Question

Usually answered in minutes!

Top Porsche Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

874 Answers

yadayada
yadayada

Level 3 Expert

75117 Answers

Are you a Porsche Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...