Fuel pump resetswitch on a 08 kia rondo? - 2000 Kia Sportage

well all or most cars as the same, only location different.
yes some are very odd.
1: drain all AF coolant.
2: gain access to it, (what V6 is that) 2.7 L Mu MPi V6???????
3: remove STAT housing, 3 bolts do not snap them .ask how .
4: new stat installed , and not backwards and not with out jiggle bleed pin/hole not in the correct direction (up is best) but SM service manual covers that. all this.
5: put it back with new gasket OEM, not wrong one.
7: hoses back.
8: new AF at 50% burp air out and done.\\

the V6 the 2 banks for water feed a larger aluminum pipe water manifold and the below its it, only thing with 3 bolts there
blurry or not it has 3 bolts. on tranny end of V
this is located on the Rear V banks, at transmission side.

Check this video out and be ready to jot a few notes. It's really well done. Good luck! https://www.youtube.com/watch?v=Cf24kUP7BPc How To Replace Front And Rear Brakes On Kia Rondo

The latch release rod has come off or the latch is defective, remove the door panel and replace the retainer clip if that is the problem

good to do with a mechanic

Can b manythings. Get testdrive from honestmech at surecritic.com

you must mean the fuel gauge? is dead? just a hint here.

wire /connector left loose.
when replacing any fuel pump check the 2 pins on the level sender
it will read 10 to 200 Ohms about 10 is full, and 200 or bit higher is empty, if the sender reads INFINITY. the sender is bad.
or is unplugged in the tank.
the sender is just a wire wound variable resistor.
a pot or correct name is a rheostat. (electronics, true names)
on car, its a FUEL level SENDER.

double posted.

OK! Go to GOOGLE and search for this:
2007 Kia Rondo LX "schrader valve" and then select "IMAGES".

Now from the GREEN BOXES select: "PURGE VALVE" and see LOTS of photos like this:









NOW TRY THIS great site!

Purge Control Solenoid Valve

Anthony

IT IS INSIDE THE FUEL TANK . IT IS MADE INSIDE THE FUEL PUMP IT IS SERVIECABLE AND RECOMMENDED EVERY 30K . THERE IS A ACCESS TO THE TANK UNDER THE SEAT THERE IS A FEW SCREWS THAT HOLD IT A COVER DOWN REMOVE THIS AND YOU CAN ACCESS .
REOMOVE FUEL PUMP AND TAKE APART THE ACTUAL PUMP SEATS INSIDE THE FILTER .IF YOU TRY TO DO IT YOURSELT BE SURE NOT TO FORGET ANY O RINGS THEY TEND TO STAY IN THE OLD FILTER WHEN REPLACING AND IF YOU DONT SWAP OVER THE VEHICLE WILL NOT START