Question about Chrysler Town & Country

Open Question

How to change a license plate light bulb on a 2008 Chrysler Town & Country

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 160 Answers

SOURCE: Change License Plate Light Bulb

you should be able to get to thru the trunk

Posted on Dec 10, 2008

Ad
  • 98 Answers

SOURCE: how do you change the license plate light bulb

OK>>> it is very cold here, but nonetheless..I went outside to check on my Oldsmobile for your benefit....On mine (I can't guarantee it is the same for all of the vehicles listed above). If you are looking at the license plate, LOOK UP and you should see the bulb and whatever encasing is there. Mine is in a tube and it is attached with (2) mini bolts that will need to come out first, then it just looks like a simple matter of disconnecting the electrical plug, taking out the old bulb and putting the new one in. I hope this helps someone....

Posted on Feb 23, 2009

  • 85 Answers

SOURCE: 2005 town & country reading light

I have the same vehicle. when the sun comes up I will go out and look my self and get back. It should let me post a follow up.

Posted on Jun 17, 2009

  • 3 Answers

SOURCE: 2007 Chrysler TOWN AND COUNTRY.. OVRHEAD MAP

I had the same problem on my 07 and it turned out to be caused by the bulbs getting too hot and melting the surrounding plastic which opened the circuit powering them. I was able to fix the problem by removing the bulbs and cleaning the sockets allowing the bulbs to seat correctly. The lenses snap off to give you access to the bulbs. If you are not familiar with how interiors of cars come apart, I would not suggest doing it as you may crack the lens.

Posted on Oct 13, 2009

  • 9 Answers

SOURCE: I have a 2007 Chrysler Town and Country overhead mamap lite

I very gently pried on the outer curve of the clear cover. It snapped out easily. Then I noticed it only clips in to place on the left and right side of the widest part of the cover. I was then able to simply twist the bulbs out socket and all.

Posted on Dec 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 Chrysler Town and Country won't start. Lights, radio and horn works just fine. Even put in a new starter and still get nothing. Ran a wire from battery to the starter and got a little kick.


Chrysler Town & Country Questions - My van won't start ...

www.cargurus.com > Questions > Chrysler > Town & Country

CarGurusSep 29, 2008 - ckf2004 answered 4 years ago. I have a 96 chrysler town and countrylx and the engine died, turned over but wouldn't start, I researched and replace the flywheel .... My van sometimes won't start because it kills the battery.

My town & country 2004 wont start sometimes - CarGurus

www.cargurus.com > Questions > Chrysler > Town & Country

CarGurusMy town & country 2004 wont start sometimes - My van start doing something really weird. it will ... Asked by TownCountryguy May 03, 2013 at 03:31 PM about the 2004 Chrysler Town & Country Base .... Sometimes you tap it & it won't work.

Van won't start - Chrysler town and country - YouTube

? 1:01
https://www.youtube.com/watch?v=mkEL2vlLZr0
Jun 26, 2014 - Uploaded by Philip Walker
We have the same issue currently...very randomly...with our 2008 Caravan at the moment. Wife just got ...

2011 Chrysler Town & Country Engine Won't Turn Over, Will ...

www.carcomplaints.com/Chrysler/Town_Country/.../engine_wont_turn_...
The 2011 Chrysler Town & Country has 34 complaints for engine won't turn over, will not start. Average repair cost is $902.00 at 58178 miles.

Jan 14, 2016 | Chrysler Cars & Trucks

Tip

How To Install Replace Taillight and Bulb Chrysler Town & Country 04-07...


How To Install Replace Taillight and Bulb Chrysler Town & Country 04-07 1AAuto.com

on Apr 04, 2012 | 2007 Chrysler Town & Country LX New Cars

1 Answer

My wipers...lights..radio and horn went out but I can drive the car..what would cause this?


2008 Chrysler Town & Country Intermittent Electrical Failure ...

www.carcomplaints.com/Chrysler/Town_Country/.../intermittent_electric...
The 2008 Chrysler Town & Country has 25 complaints for intermittent ... The horn,lights, wind shield wipers front and back going crazy could not shut off. .... I was Driving down the road and my van went crazy possessed! ... Electrical checks reveal nothing wrong with the electrical system, and there is power to the radio.

2003 Dodge Caravan ES Electrical Problem - Discussion on Topix

www.topix.com > Dodge Grand Caravan
Aug 7, 2011 - my van was running fine, shut it off, went in for half an hour then it would not ... or the electric doors. windows do and brake lights. heater stays on hot and i can only ... My horn wipers,power windows, radio,blower front and back, headlights, do not work. ... Chrysler Readies Next-Generation Town & Country.Missing: 2004

Thread: I lost almost all of my dash lights, instruments, and ...

forum.chryslerminivan.net/.../7261-I-lost-almost-all-of-my-dash-lights-i...

Jan 17, 2008 - 10 posts - ‎6 authors
I have a 2003 Town and Country mini-van and I lost power to all my ... In addition to this my wipers, headlight controls, blinker controls, power door locks, and A/C/heat controls are out as well. The odd thing is that the power windows work, the power sideview mirrors work, the radio and ceiling lights also work.

Dec 16, 2015 | 2004 Chrysler Town and Country

1 Answer

Why does2008 town & country,right brake light does not work,but running light does


Because there are two different filaments in the bulb, It's like having two bulbs in one, the running /tail lights also typically run on different circuits as well, check all fuses first, if all good replace the bulbs, should be good. If it still does not work with the new bulbs there could be a problem in the circuit to that lamp, but the usual problem is just a bad bulb...

Mar 05, 2015 | 2008 Chrysler Town & Country Touring

1 Answer

My brake lights wont work at all light bulbs has been replaced and fuses been checked its a 1996 chrysler town & country


Brake light switch can be checked with a test light. Since the 3rd brake light is not working That's probably the problem.

Feb 15, 2011 | 1996 Chrysler Town & Country

1 Answer

Reset odometer after oil change 2008 chrysler town & COUNTRY


Chrysler 2008 Town & Country 4.0L engine. Message center says Oil Change is due. How do you reset the message after changing the oil?

Oct 21, 2009 | 2008 Dodge Avenger

1 Answer

Describe your 2005 Chrysler Town &


check the bulbs do not have fractured filaments,and check the headlamp relay.check the sockets for corrosion and if all that checks out ok check the connection on the back of the headlight switch and the daytime running light module

Aug 15, 2009 | 2005 Chrysler Town & Country

1 Answer

2005 town & country reading light


I have the same vehicle. when the sun comes up I will go out and look my self and get back. It should let me post a follow up.

Jun 17, 2009 | 2005 Chrysler Town & Country

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

374 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8531 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...