Question about Ford Explorer

1 Answer

I have no power going to the coil pack of my ford explorer xlt 6 cyl 4.0 L

The check engine light dose not come on and it all started when a wire was exposed and shorted out it cranks but wont start

Posted by on

Ad

1 Answer

Now you will need a repair shop with wiring diagrams
& the ability to use them correctly, to find & resolve
whatever happened with a possible damaged wire &
I assume, short to ground.

You need to see if you have spark or injector pulse
when cranking,if so your crank sensor is okey

Next check ALL Vehicle fuses

Then test for damaged drivers in the ignition module,
may get lucky & it will be okey

Repair the wire prolbem

Posted on Dec 07, 2012

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
justuscc
  • 360 Answers

SOURCE: No Start, No Spark, for Grand Caravan 3.8L

we get remans bad out of the box......... good luck

Posted on Sep 26, 2008

rainstreet
  • 1 Answer

SOURCE: MY FORD EXPLORER WONT START

fuel pump relay

Posted on Dec 17, 2008

wyatt1582
  • 453 Answers

SOURCE: Have a 1998 F-150 XLT, 4.6 (6) Windsor Engine.

Could be the coil pack should be read in ohms about 7 to be good

Posted on Jul 13, 2009

rickyrt441
  • 4399 Answers

SOURCE: 2003 ford explorer sport trac 4 x 4 xlt 63,000

Is it coming from your belt? Where is it coming from? You might have a pulley sticking.

Posted on Feb 09, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I received a check engine code indicating cyl 8 misfire. Replaced the common problem coil and no change. Spark plug is new. Engine run past 3000 RPM and starts to sputter. What can it be?


If you replaced the coil pack, plug wire, and injectors, then you have compression problem in clyinder 8, and your rings are bad, even though you may not see any smoke ...

Oct 18, 2014 | 2006 Ford Expedition XLT

1 Answer

Misfire p0303


Check wiring harness around and including plug to the coil pack. Also check fuel pressure with vehicle running. I'm not sure of the specs but, Iit should be around 35 to 40 psi. at idle, and 50 to 75 at higher RPM's. I've seen Fords run with a bad fuel pump and demonstrate these exact symptoms

Mar 06, 2014 | Ford Cars & Trucks

1 Answer

I have no power going to the coil pack of my ford explorer xlt 6 cyl 4.0 L


The check engine light gets power from the PCM - there is a PCM relay that gets power from a 10amp fuse number 6 and a 30amp fuse number 10 in the fuse box next to the battery. This can also affect the coil.

Dec 07, 2012 | 2001 Ford Explorer Sport Trac

1 Answer

Number five plug not firing


I'm assuming this is a DIS(distibutorless ignition system).If it is,the most common cause is a defective coil pack.Each coil will fire a pair of cylinders together on 4 and 6 cylinder engines(one "waste" spark,one to ignite the mixture).Try swapping the wires at the coil pack to see if the misfire follows the coil tower,or the same cylinder misfires(keep in mind that a check engine light means you will have to clear the code to get the computer to feed that cylinder fuel before you start it up again).If the other cyl on the pack now misfires(i believe 1+5 are on the same pack on a Ford engine),then the coil is bad(spark is "leaking"to ground).If the same cyl still misfires,try swapping a wire+plug from another cylinder.

Mar 14, 2012 | 1996 Mercury Cougar XR7

1 Answer

Need firing order for coil pack, 1994 ford explorer,4.0


V8 or V6

Cyl 1 thru3 or 4 ---front to back --pass side

Cyl 4 thru 6 --or 5 thru 8 in case of V8 --driver side

V6 1-4-2-5-3-6

V8 1-3-7-2-6-5-4-8

Mar 12, 2010 | 1994 Ford Explorer Limited

2 Answers

2002 Ford Explorer passenger power window problem


Check the fuse panel first, after that check your fuse relays under the hood, if not then it might be a wiring problem.

Jul 30, 2009 | Ford Explorer Cars & Trucks

1 Answer

No Start, No Spark, for Grand Caravan 3.8L


we get remans bad out of the box......... good luck

Sep 26, 2008 | 1996 Dodge Caravan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

77 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...