Question about 2001 Ford Focus

Open Question

Where is steering fluid reservoir on ford c max

Posted by Anonymous on

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

warlock61
  • 659 Answers

SOURCE: air in power steering lines

trans fluid and p/s fluid same thing thats fine. Did you fill fluid first before starting vehicle? These pumps burn up easily if run dry.

Posted on Dec 16, 2008

c1apton15
  • 3400 Answers

SOURCE: Been putting clear power steering

Sounds like rack is clogged or one of hose is clogged or pinched. Next time you put fluid in it try bleeding it. It's easy, top up fluid then turn wheels all the way to stops on right then back to left stops. Do it a couple of times, but be careful - do NOT hold at stops for more than 5 secs.

Posted on Jan 02, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How to add power steering fluid to 2008 pontiac g6


If you can't find a power steering fluid reservoir under the hood in the engine compartment your G6 could have Electronic Power Steering . If you look up under the dash below the steering column you will see a electric motor mounted to the steering column !
The power steering system reduces the amount of effort needed to steer the vehicle. The system uses the powertrain control module (PCM), body control module (BCM), power steering control module (PSCM), discrete battery voltage supply circuit, steering shaft torque sensor, steering wheel position sensor, power steering motor, driver information center (DIC), and the serial data circuit to perform the system functions. The PSCM and the power steering motor are serviced as an assembly and are serviced separately from the steering column assembly. The steering shaft torque sensor and the steering wheel position sensor are not serviced separately from each other or from the steering column assembly. The steering column assembly does not include the power steering motor and module assembly.

Jun 23, 2015 | 2008 Pontiac G6 Sedan

1 Answer

Where do power steering fluid go in a 2010 Ford Fusion 3.0 liter


The power steering reservoir is located on the left side of the
engine compartment....the cap should read STEERING FLUID
ONLY....look for the minimum and maximum levels shown on
the reservoir.

Regards,
Dennis

Sep 20, 2014 | Ford Fusion Cars & Trucks

1 Answer

Can I top up power steering fluid in my bmw116i myself?


Yes, you can. Just find the power steering fluid reservoir (should be near or on the power steering pump), unscrew the cap, and fill to the max. full line.

Nov 03, 2012 | 2005 BMW 1 Series

1 Answer

How to change the fluid of the power steering ?


Open the engine hood.

There will be several fluid reservoirs under the bonnet. If the car / truck has power steering, one of them will hold about 150-300ml of fluid that should be a red color. If you put some on your hand it is very slippery.

The other reservoirs will hold water for the windscreen washer, and one connected to the radiator to hold coolant.

Check that the reservoir you intend to put the power steering fliud in is not connected to the radiator and does not contain water.

Take the cap off to check.

If you can't see in to the bottom, roll up some kitchen paper towel and feed that in until you get some fluid on it - red, you hope!

There will be marks (horizontal lines) on the side of the reservoir showing "Min" (minimum) and "Max" (maximum or full). Slowly pour in replavcement fliud until the tiop of the fluid is between the marks.. Put the cap back on, close the engine hood, drive for a short distance (2 km?) and check the levels again.

Top up the reservoir to just under "Max". Replace the cap.

Check the level after a short period of normal driving - a couple of weeks, If it is still going down a mechanic needs to check the power steering seals.

good luck.

Jul 31, 2011 | Honda Prelude Cars & Trucks

1 Answer

Where is power steering fluid checked & put in?


There is a special reservoir for the power steering fluid, it will be marked or may be part of the power steering pump. The reservoir will have a max mark on it or may have a dip stick attached to the cap.

Feb 02, 2011 | 1995 Buick Park Avenue

1 Answer

Air in power steering how to get it out


Did you replace any parts?. any way fill reservoir instal cap, start engine and turn steering whell from lock to lock, left and rigth until it stops, do it couple off times then recheck reservoir refill and repeat this until it does not need to add any more fluid, then let car idle until fluid is clear of air,(foamy) fill reservoir to max line by now noise must be gone.
Good luck

Jan 07, 2011 | 1994 Toyota Corolla

1 Answer

Adding power steering fluid


Locating the Power Steering reservoir and adding PS fluid. 1999 Pontiac GP


  • The reservoir is clearly visible in the engine bay on the 3.1 litre engine cars.
  • For the 3.8 Ltr engine cars, use a flashlight to look down past the alternator for a black cap with a steering wheel printed on it to indicate the power steering fluid reservoir. ( passenger side of the vehicle).
  • Remove the cap of the power steering reservoir, clean the dipstick, re-insert and remove again to check the fluid level. If the level is at or below the low level mark, add fluid slowly, taking care not to fill above the MAXIMUM mark. It's best to add small amounts and re-check the level as you go to ensure you do not overfill the reservoir above the MAX level.
  • ONLY use the power steering fluid recommended for that vehicle by GM.



  • Dec 03, 2010 | 1999 Pontiac Grand Prix

    1 Answer

    Need an digram of 2000 ford focus power steering pump


    cfef959.gif
    Item Part Number Description 1 - Steering wheel 2 - Steering column 3 - Boot 4 - Tie-rod 5 - Tie-rod end 6 - Steering gear 7 - Steering gear to fluid cooler hose 8 - Fluid cooler 9 - Power steering pressure (PSP) switch 10 - Power steering pump 11 - Fluid supply hose 12 - Fluid reservoir 13 - Pump to steering gear pressure line 14 - Steering gear pinion extension

    Jul 30, 2009 | 2000 Ford Focus

    1 Answer

    The stiring is hard ??


    pover steering reservoir low on fluid or steering pump went down,check the fluid level and fill to max first if not you need exchange steering pump

    Jun 13, 2009 | 2001 Mercury Sable

    Not finding what you are looking for?
    2001 Ford Focus Logo

    Related Topics:

    129 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Ford Experts

    yadayada
    yadayada

    Level 3 Expert

    75066 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22095 Answers

    fordexpert

    Level 3 Expert

    5470 Answers

    Are you a Ford Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...