Question about 2000 Mazda 626
I would like to find a picture/booklet which shows the airbag system and all of the components.
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: mazda 323 both airbag lights
The airbag light will come on any time there is a problem in the air bag/passive restraint system, while the light is on the air bag(s) is disabled. To the cause, the most common cause is the rotating contact under the steering wheel that connects the bag to the firing control module, it's common name is a clock spring, which it looks like when the cover is removed. If you intent to replace this part make sure you disconnect the battery for 10 minutes before starting to work on it. 1 other note, there will be a trouble code stored in the systems control module, you should access that code first to be sure of the part that turning the light on.
Posted on Aug 06, 2008
SOURCE: Mazda 626 hatchback limited 2000
Fussy old bugger, when's the last time you had a front end alignment? Has it always been off center? Have you had any front end work done (tie rods replaced etc?) If the steering wheel has never been off, it shouldn't have to be removed now (unless it was installed improperly at the factory-doubtful) Yes you MUST disable the air bag to remove steering wheel. Any chance the car hit a curb, pot hole, etc? !st thing should be an alignment at a good garage, they should be able to find any damage to front end components caused by a pothole/curb. correct, and align. That should correct the position of the steering wheel and make you a smiling fussy old bugger. countrycurt0 PS-I'm a fussy old bugger too.
Posted on Aug 15, 2008
there are a quite a few problems associated with the airbag light flashing. The light will flash in long and short frequencies, this is a diagnostic code, e.g. two long flashes followed by six short flashes equals code 26, which is clockspring. Other codes are: 46 and 47 connector under seat, 3 power supply etc.
Posted on Dec 06, 2009
yes it isn't that much if you buy them.they slide inside the coupler and release the line.
Posted on Dec 27, 2009
Testimonial: "Thank you didn't know if there was a tool for this."
Tips for a great answer:
Sep 06, 2015 | 2000 Mazda MX-5 Miata
Jan 12, 2014 | 1999 Mazda 626
Jan 02, 2013 | 2005 Audi TT
Feb 28, 2011 | 2000 Mazda 626
Feb 11, 2010 | 1999 Mazda 626
Jul 13, 2009 | 1999 Mazda 626
Aug 15, 2008 | 2000 Mazda 626
116 people viewed this question
Usually answered in minutes!