Question about Mitsubishi Cars & Trucks

Open Question

2009 MITSUBISHI ECLIPSE GT- ASC WARNING LIGHT COMES ON AFTER DRIVING ABOUT 15 MINS. AND CANNOT BE RESET.

BRAKE LIGHT STOP SWITCH AND CENTRAL CONTROL MODULE FOR ABS/ASC HAS BEEN REPLACED AND STILL HAS NOT SOLVED THE PROBLEM.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Brian032472
  • 150 Answers

SOURCE: Abs/Brake Light ON, although new brakes, ABS still works

I would suspect a speed sensor.

Posted on Jan 30, 2009

  • 2 Answers

SOURCE: transmission doesnt shift abs & brake light on speedometer doesnt work

I had the same problem with ABS light and speedometer, I was told that it is the transmission control module. It has not yet stopped shifting but I have had times where it just wont stay running. It will start and then stall. Hope this helps.

Posted on May 24, 2009

  • 35 Answers

SOURCE: brake light bulb Mitsubishi Eclipse Cars

look for access panels in rear hatch there will be one on each side remove those and there will be 10 ml nuts holding the light housings on remove those then you can access the lights

Posted on Jul 02, 2009

  • 580 Answers

SOURCE: ABS and ASC warning lights stay on 2000 530d

Check to see if your brake pads and rotors are in good condition. Or if you have replaced the pads yourself and have not reset the wheel sensors this would cause the ABS Antilock Brake System light and the ASC Automatic Stability Control light to stay on as the ASC uses the ABS brakes with computer assistance to control the car

Posted on Jul 08, 2009

  • 580 Answers

SOURCE: asc light comes on and engine cuts out

When your ASC light is on this is to let you know your Automatic Stability Control system is switched off press the ASC button Till light is off /ASC is on this works with your rev limiter and should stabilized your idle. If the problem persists have your throttle control unit checked as thi can trigger the ASC light as well and may also activate the ABS light if not fixed

Posted on Jul 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Transmission make loud sound when put it in revers


PLEASE HELP! SOS! car starts but doesnt move! - Club3G Forum ...

www.club3g.com > ... > Performance & Tech Forums > Problem Reports

Nov 16, 2010 - 61 posts - ‎14 authors
now yes, i will take the transmission is fubar into consideration but theres an .....however... idk about my cv joint, my car ONLY would make a loud ping noise when i move from a stop or brake ..... almost always when i put it into reverse. such as an engine mount sound, ... Vehicle: 2004 Eclipse Spyder GT. Loud knocking sound after oil change..
14 posts
Sep 20, 2010
Horrible noise upon start when cold
21 posts
Dec 24, 2009
Sporty knocking.. Oh noez!!one!!1!
16 posts
Mar 22, 2006
More results from www.club3g.com

Loud thump when I shift into drive or reverse - CarGurus

www.cargurus.com > Questions > Chevrolet > Cavalier

CarGurusDec 19, 2012 - And while driving loud thump when car motor shifts th... ... Bad throttle position sensor can trip both lights and make the transmission shift at high rpms and shift hard even under light acceleration. .... the transmission will shift hard when firstput into reverse or drive ... 2004 Chevrolet Cavalier LS For Sale.Missing: mitsubishi ‎eclipse

Mitsubishi Transmissions & Drivetrains Repair Questions ...


Dec 06, 2015 | 2004 Mitsubishi Eclipse

1 Answer

What does it mean when a Tcl light comes on on a 2002 Mitsubishi Eclipse


Do you mean TLC light? Its the traction control. Have you been driving normally, or aggressively?

Mar 07, 2015 | 2002 Mitsubishi Eclipse

1 Answer

I havea 2001 mitsubishi eclipse gt and the battery and brake light will not go off. The battery is brand new and brake fluid is full. What could it be?


Bad recharge tension,must see with voltmeter by battery,mostlikely bad alternator bridge/brushes.Rare:alternator belt slip,can be asociated with motor over heating (because of the water pump shared belt).Brake light must track the problem,can be stucked float on the pump oil cap,worn brake pads (if it have the sensor,easily identify by wire near the pads),bad hand brake switch.

Oct 22, 2013 | 2001 Mitsubishi Eclipse

1 Answer

I have a Mitsubishi eclipse '03 my brake & battery


You would need to check the wiring and fuses to see if anything is blown or melted. The warning light is for both hydraulic brakes and the charging system.
In your case the light probably came on because the alternator stopped charging the battery.

Dec 24, 2012 | Cars & Trucks

1 Answer

VW passat 2001 2.8L The hand brake ligth comes on with a continou


Its faulty sensor for driver warning (control light and acustic) when is parkbrake switched up. For safety goes warning after move on. When stopped is warning out. Its VERY EASILY to repair

Jun 08, 2010 | 2001 Volkswagen Passat

1 Answer

The brake lights on my 2001 mitsubishi eclipse GT won't work


Do your gauges work? Some systems tie those in together check that fuse too

May 03, 2010 | 2001 Mitsubishi Eclipse

1 Answer

A yellow circular arrow warning light has come on. What is it?


A yellow light containing an exclamation mark surrounded by a triangle, all surrounded by a curved arrow is the Automatic Stability Control warning light (ASC + Traction Control). If the light just flashes momentarily whilst driving it means that you have driven in a way that has triggered the ASC system to activate and protect you. If the light is on all the time it can mean that you have switched the system off. The switch for the ASC is one of the row of chrome switches just under the airconditioning controls. If you operate the switch and the light stays on, you have a faulty ASC system. OK to drive the car but be aware that the stability control will not save you from a skid. Have it looked at if you can't get the light to stay off.

Normal operation: Light on when you turn on the ignition, should go out after engine starts. Light flashes if you are driving hard on a slippery surface and the system is acting to stabilise the car.

Faulty: Light on all the time measn either you have turned the system off or there is a fault.

Oct 28, 2009 | 2002 Mini Cooper

2 Answers

My DSC and Brake warning lamps continuously light up in yellow once the engine has warmed up. They remain on after driving for a while and sometimes they shut off. Any ideas?


Check to see if your brake pads and rotors are in good condition. Or if you have replaced the pads yourself and have not reset the wheel sensors this would cause the ABS Antilock Brake System light and the ASC Automatic Stability Control light to stay on as the ASC uses the ABS brakes with computer assistance to control the car

Jul 09, 2009 | 2001 BMW 325

1 Answer

ABS and ASC warning lights stay on 2000 530d


Check to see if your brake pads and rotors are in good condition. Or if you have replaced the pads yourself and have not reset the wheel sensors this would cause the ABS Antilock Brake System light and the ASC Automatic Stability Control light to stay on as the ASC uses the ABS brakes with computer assistance to control the car

Jul 06, 2009 | 1999 BMW 5 Series

1 Answer

Asc light comes on and engine cuts out


When your ASC light is on this is to let you know your Automatic Stability Control system is switched off press the ASC button Till light is off /ASC is on this works with your rev limiter and should stabilized your idle. If the problem persists have your throttle control unit checked as thi can trigger the ASC light as well and may also activate the ABS light if not fixed

Nov 11, 2008 | 1997 BMW 318

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

100 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8195 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...