Question about 2000 Dodge Durango
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
try checking the Relay in the fuse box under the hood, and there is also one up under the dash, if you dont hear the relay click with you put power to it then pop it out then try a new one. a lot of times it could be the relay but you still get power to the fuse. cause the relay clicks closed and locks that way. if not that check for power at the blinker, take the bulb out turn the blinker on and see if there is a voltage change there if not then it could be a bad ground or line under the hood.
Posted on May 19, 2009
I HAD SAME PROBLEM WITH BATTERY DRAINING IT TURNED OUT TO BE THE LIGHT UNDER THE HOOD WAS HANGING AND STAYING ON... GOOD LUCK
Posted on Sep 19, 2009
Lets look at these codes and what they imply is a problem.
P0135 - O2 Sensor Heater Circuit Malfunction Bank 1 Sensor
P0155 - O2 Sensor Heater Circuit Malfunction Bank 2 Sensor
The O2 sensors in this system have tiny wire filament heater in them, this allows the O2 to reach operating temperature very fast, if you turn the key on and wait a few seconds on a cold engine you will feel the sensors get hot very quickly, hot enough to burn your fingers. Here are the reason's that cause the codes to set for the heater circuits of the sensors.
Heated Oxygen Sensor (H2OS) Banks 1 and 2 Sensor #1 circuit open shorted to ground.
- Heated Oxygen Sensor (H2OS) Banks 1 and 2 Sensor #1 circuit poor electrical connection.
- Faulty Heated Oxygen Sensor (H2OS) Banks 1 and 2 Sensor #1 circuit (both of them, no not likely)
- Heated Oxygen Sensor (H2OS) Banks 1 and 2 Sensor #1 circuit fuse or fuses blown/open. (Very likely)
- Faulty Engine Control Module (ECM) (very unlikely)
Posted on Sep 15, 2011
By run - do you mean it dies when you put it in gear? Or that it just bogs down when you attempt to accelerate or drive away?
A plugged Catalytic converter will cause this. So will a Bad MAP or MAS (Mas Air ) sensor. So will a bad TPS (Throttle Position) sensor.
Need more input to answer more precisely.
Posted on Jul 25, 2012
Tips for a great answer:
Dec 07, 2012 | 2000 Dodge Durango
Jul 21, 2012 | 2000 Dodge Durango
Jun 28, 2012 | 2000 Dodge Durango
Aug 15, 2017 | 2000 Dodge Durango
Nov 07, 2011 | 2000 Dodge Durango
Please see my tip at http://www.fixya.com/cars/r5925550-dead_battery_troubleshooting . These are generic instructions. If you get stuck or need specific instructions for your car, please get back to me with model, year and engine info.
Apr 17, 2011 | 2000 Dodge Durango
Mar 23, 2010 | 2002 Dodge Durango
Sep 12, 2009 | 2000 Dodge Durango
17 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: