Question about 1998 Plymouth Grand Voyager

2 Answers

WHERE IS THE WATER PUMP LOCATED ON A 1998 PLYMOUTH GRAND VOYAGER

JUST WONDERING HOW DIFFICULT IT WOULD BE TO CHANGE MYSELF. ANY INFO WOULD BE GREATLY APPRECIATED.

Posted by on

  • 2 more comments 
  • nmike69 Jan 12, 2009

    I THINK ITS THE 3.0 V6.

  • nmike69 Jan 21, 2009

    THANKS FOR THE HELP. EVERYTHING WORKING FINE

  • Rudolf Diesel
    Rudolf Diesel May 11, 2010

    Hello

    What size motor do you have?

    Thanks

  • Rudolf Diesel
    Rudolf Diesel May 11, 2010

    Hi

    Witch motor do you have in your van?

    RD

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 4 Answers

Here are the steps required to change the water pump on the 3.0L engine.

  1. Disconnect the negative battery cable.
  2. Drain the cooling system.
  3. Remove the drive belts. Remove the timing belt covers and the timing belt.
  4. Remove the water pump mounting bolts.
  5. Separate the water pump from the water inlet pipe and remove the water pump.
  6. Inspect the water pump and replace as necessary.
To install:
  1. Clean all gasket and O-ring surfaces on the water pump and water pipe inlet tube.
  2. Wet a new O-ring with water and install it on the water inlet pipe.
  3. Install a new gasket on the water pump.
  1. Install the pump inlet opening over the water pipe and press until the pipe is completely inserted into the pump housing.
  2. Install the water pump-to-block mounting bolts and tighten to 20 ft. lbs. (27 Nm).
  3. Install the timing belt and timing belt covers. Install and adjust the drive belts.
  4. Reconnect the negative battery cable. Fill the cooling system to the proper level with a 50/50 mixture of clean, ethylene glycol antifreeze and water.
  5. Run the engine and check for leaks. Top off the coolant level, if necessary.
WHERE IS THE WATER PUMP LOCATED ON A 1998 PLYMOUTH - 34bef4a.jpg

Posted on Jan 20, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I just did it on my 97 plymouth grand voyager. Im a mechanic by trade, so it wasnt too bad. I would recommend buying a chilton repair manual ( it cost me 26 bucks). It will walk you through it. You should have this as it helps you time the engine when removing and installing timing belt, as well as other things you will need to do.

Posted on Jan 28, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I need to know what the pipe is called that the lower rad hose hooks up to on the 1998 plymouth grand voyager mini van 3.0L, 3 speed automatic ?


if you follow the pipe does it go towards the transmission ? if so it's for the trans cooler. If not it will be the escape hose incase of overheating/to much pressure in the coolant system , if you go to a parts retailer like autozone they will have the part named on their data system , its a bit difficult without seeing vehicle to name parts . although you have given a good description, the lower rad hose carries cooled coolant so i would think it's the trans cooler but check at autozone or similar

Jul 07, 2014 | 1998 Plymouth Grand Voyager

1 Answer

Changed water pump now 1998more plymouth grand voyager wont start


Check all your wires you removed. Obviously something is not connected. Check your ground wires first. When you have determined you have a good ground then check for power to the starter. If it cranks but won't start then you have disconnected something to the fuel or ignition system. If it ran before you changed the water pump then you have missed a connection somewhere.

Mar 24, 2012 | 1998 Plymouth Grand Voyager

1 Answer

Belt squealing on a 1998 plymouth grand voyager 3.3 liter motor


have u checked the dampner pulley,it may b coming apart. if it only squeaks with the a/c on then it's your a/c clutch pulley.

Dec 04, 2011 | 1998 Plymouth Grand Voyager

1 Answer

Where do i find instructions on installing a water pump on a plymouth voyager


search the internet type into google search ( 1998 chrysler voyager manual ) and you will find a site where you can download it for free its about 55mb in size

Nov 29, 2010 | 1997 Plymouth Grand Voyager

1 Answer

How to change oil pump on plymouth grand voyager


go to http://www.autozone.com/autozone/homePage.jsp and sign up, put in your vehicles info and click on repair guides, they have oil pan remove and replace but no guide for the oil pump but its located in the oil pan and usually held on with 2 bolts and a gasket inside the pan, Tough job probably need someone with mechanical experience to help with this.

Apr 18, 2010 | 1997 Plymouth Grand Voyager

1 Answer

How to change waterpump on a 99 plymoth grand voyager 3.3 motor


i need your help about problem water pump. I did exchanged new water pump. but it keep increase hot up .. i still figure something out about water pump. do you think fan cooling broke either fuse blow out .. thank you ..

Jan 17, 2010 | 1998 Plymouth Grand Voyager

2 Answers

How do you replace the water pump on a 3.3L 1998 Pymouth Grand Vy


Go to the autozone.com website and register. It's free and will give you access to an online repair manual. The steps for replacing the water pump can be found there. Hope this helped and best wishes.

Aug 11, 2009 | 1998 Plymouth Grand Voyager

1 Answer

1998 plymouth grand voyager cruise control relay/fuse location?


Check under hood in box marked fuses & relay, on drivers side and look under cover of it for I.D.

Apr 10, 2009 | 1998 Plymouth Grand Voyager

Not finding what you are looking for?
1998 Plymouth Grand Voyager Logo

2,684 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

70346 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6869 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...