Question about 2000 Hyundai Sonata

Open Question

How much to replace a heater core 2007 hyundai sonata

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 21 Answers

SOURCE: replacing heater switch in 2004 hyundai sonata

Open the ashtray, and grab the bottom of the bezel. Its only clipped in, so give it a yank and the bezel will come off. Unplug the connectors and replace your switch.

Posted on Jul 02, 2008

  • 393 Answers

SOURCE: replacing rear wheel bearings on 1999 hyundai sonata

  1. for drum brakes with sealed hub(all one piece) remove lug nuts and wheel.
  2. spray penetrating oil around studs if there is a big phillips head screw visible remove it with impact driver/if not use big ballpeen hammer ,tap on flat of drum near studs(becareful not to hit them) until drum loosens(your creating a shockwave to loosen rust)
  3. once drum is off there are 4-bolts coming in from behind backing plate, remove them then hub should be able to be removed w/a little persuation from hammer.
with out sealed hub ,
  1. remove wheel
  2. remove dust cap,cotterpin,star washer(if equipped) do not re use cotter pin
  3. remove nut then washer, wiggle brake drum and front bearing will come out.
  4. put nut on shaft tighten 2-3 turns grab drum by sides and pull towards you this should remove drum leaving inner bearing/seal on shaft
  5. to replace reverse procedure making sure to pack new bearings w/grease(take drum and use long punch to remove bearing races, use race/seal installer to install new races
with disk brakes

  1. remove wheel
  2. remove caliper/bracket
  3. remove rotor
  4. remove 4-bolts from behind,tap old hub out
  5. reverse procedure



Posted on Nov 15, 2008

ghost45
  • 1280 Answers

SOURCE: Locating and changing spark plugs on 2007 Hyundai Sonata 4 cylinder

They are directly below the coil packs (10mm bolts).


a73d0bb.jpg

Posted on Oct 25, 2009

techbuster
  • 5081 Answers

SOURCE: how do you replace the fog light bulbs on a 2007

Look under the bumper and you will see two large phillips head screws right in front of the wheels. Take these two screws out and bend/move the plastice piece out of the way. Now you can easily get to the bulb. There is a cap that twists off that protects the wires and back of the bulb. Twist this off and then remove the plug portion from the back of the bulb. The bulb then turns 1/4 to 1/2 revolution to loosen and remove. Reverse steps for installation.

Posted on Dec 19, 2009

  • 389 Answers

SOURCE: how do you replace the license plate light on a

I can't see what you have but lets check a couple of things. If there is any screws visable on the outside of the lens then remove them. Once the cover is off then you should be able to see the bulb. Take the bulb between your thimb and four finger and push in gently and turn to the right and pull out. You would know the rest from there. If no screws outside then lets look in the trunk. You may have to remove some covering in the general area to see the bulb. Follow above directions. If nothing is there then the last place is under the bumper. Have a look and go from there. Let me know I we fixed it. The Raz

Posted on Apr 17, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does my radiator become empty after 30 minuets of driving and water appears on the driver side floor?


Your heater core is leaking, bypass the core by removing hoses from firewall and joining together, or cable tying over, this will get you back on the road until you can replace the heater core.

Aug 06, 2016 | 1994 Hyundai Sonata

1 Answer

Need to replace heater core on hyundai sonata 2002 gls


Vadeo how to replaes heter cord hyundai sonta

Jul 07, 2011 | Hyundai Motor 2002 Sonata

2 Answers

My heater in my 2007 sonota stop putting out heat what could be the cause of that


most likely you are just running low on coolant/antifreeze . if it is low the coolant cant reach the radiators wich are used to deliver the heat.

Mar 05, 2011 | 2007 Hyundai Sonata Limited Sedan

1 Answer

Change heater cord on 2005 hyundai sonata


You first have to drain the radiator, then you diconnect the heater hoses to your heater core .in the engine compartment. Then you remove the cover off the heater core assembly under the passenger side , under the glove box. Then you take straps off the heater core off. and replace . Install every thing you removed previously and refill your radiator and your done.

Apr 11, 2010 | 2000 Hyundai Sonata

1 Answer

How do you remove the dash to get to the heater core on a 2003 hyundai sonata?


Go to www.hmaservice.com and register( Vehicle by VIN). Afterward, you have access to shop manuals, service bulletins, wiring diagrams, etc. about your vehicle.

Oct 21, 2009 | Hyundai Motor 2003 Sonata

1 Answer

Hyundai sonata brake lights


you will probably have to replace the bulb

Jul 07, 2009 | 2007 Hyundai Sonata Limited Sedan

2 Answers

The heat in my 2002 hyundai sonata doesn't work, Help!!!


Is the fan working and blowing air but there is now heat?

If there is no heat and air is blowing out check your radiator level. If the engine coolant is too low water will not get to your heater core. Remeber check the radiator level and not just the coolant reservoir. Becareful when working around a hot car. wait til the car cools down to check the level of the coolant in the radiator.

Dec 26, 2008 | Hyundai Motor 2002 Sonata

1 Answer

Block heater


Do you mean the Heater core ? If that is what you mean. It is under the dash just inside where 2 hoses from the inside of the engine compartment go right into the car on the firewall at the back of the engine.Those hoses have to be hot when the engine has been running hot.So be careful. If they are not hot, no hot water is passing through to the heater core.

Dec 20, 2008 | Hyundai Motor 2002 Sonata

Not finding what you are looking for?
2000 Hyundai Sonata Logo

Related Topics:

68 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...