Question about 2000 Audi TT

2 Answers

Indicators do not work Although al lamps light when locking Car

Indicators do not work Although all lamps light when locking or unlocking the car. So all the lamps(bulbs) are working ok. It has had 2 New indicator storks over the past year but the indicators work for a few days then fail again I would be gratful for any solutions Pete. (Audi TT roadster 2000)

Posted by on

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 34 Answers

Hazard warning light switch fault.
The hazard light warning button in the middle of your dash is actually a relay that often fails, causing this problem. New switch required.

Posted on Jan 22, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Almost certainly earth fault, try connecting extra earths hear till the fault goes away.

Posted on Jan 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Indicator not working


Check the light bulbs, the connections to the bulbs and the fuses for the indicators. Start with the indicator lamp fuses if all indicator lights are not working.. Their location is shown in the owners manual.
If the problem is isolated to just one or 2 of the lights, you need to check the wiring, the connections and the light bulbs. However there will likely be multiple fuses on the car covering the indicator lamps so check these also. I have 4 different fuses on my own car covering different indicator lamps so check the fuse information in your owners manual for details of which fuses cover which lamps.

If you do find a blown fuse is the cause, only replace it with a fuse of the correct amperage. If it is a 15 amp fuse that has blown use only a 15 amp fuse as a replacement.

If the fuses, wiring, wiring connections and bulbs are all fine, but non of the indicators are working, the likely problem is a faulty indicator switch on the steering column.

Feb 17, 2015 | 2003 Ford Focus

1 Answer

Keyless remote will not lock and unlock doors but lights indicators still work.


No one can answer this unless you tell us about the car.

Aug 30, 2014 | Cars & Trucks

2 Answers

What does it mean when a yellow triangle with a surrounding arrow comes up on dashboard says "engin workshop"


ASR - Acceleration Skid Control system.
When ASR warning light blinking the system is activated itself for car acceleration skid control.


For today's typical high-torque engines, traction control (ASR) can increase both comfort and safety, particularly when driving on slippery roads or surfaces offering differing levels of grip. Traction control permits smooth starting and acceleration through the full speed range without wheel-spin or fishtailing.

tdisline_338.jpg


ASR only operates in conjunction with the electronic accelerator (E-gas) and uses components of the anti-lock braking system (ABS). If one wheel suddenly begins to rotate faster than the others (slip), ASR intervenes in the engine management system and reduces power until the wheel stops spinning.
The ASR system represents a further contribution to active safety as it maintains vehicle traction and directional stability throughout the acceleration phase at any speed. In addition, it reduces tyre wear. Activation of the ASR system is indicated by a flashing indicator lamp in the instrument cluster.

The ESP system means the Electronic Stability Program. If the ESP lights on the dashboard permanently the ESP system is faulty. You must access the ESP Electronic Control Unit (ECU) memory for pull out all DTC (Diagnostic Trouble Codes), using diagnostic equipment connected to the data link connector of the car. Then you will be full informed about bad pieces (e.g.: front right wheel abs sensor interrupted, ...). After bad pieces replacement you will be able to erase all faults memored by ESP ECU, in other words reset the ESP system and turn off the warning lamp on dashboard.

Mar 12, 2011 | 2003 Volkswagen Passat

1 Answer

Could you please advise where the Flasher Units are located in a 1997 Daewoo Leganza.


check engine bay fuse 12 and fuse 11 in car
ones for hazzard lights so do they work?
the other for indicators(turn signals)
left hand drive has fuse & relays left kick pannel area and right hand drive vehicles are similar
unit is not shown in workshop manuals
does indicators flash when locking unlocking vehicle? control is also through keyless entry module

Mar 09, 2011 | Daewoo Leganza Cars & Trucks

1 Answer

Car wont start after getting a new key and replacing batteries -


hi well this is a bit long so if you can bare with me i will try explain how to , clear system to decode, and recode as this is what it sounds like that the coding has gone from the ignition key....ok here goe's
to sync key with car depress lock or unlock button manually lock the drivers door within 30 seconds of the above system should now work....if not do next bit
switch ignition on ( using non chip key ) manually lock drivers door using key ( another one, hopefully you will have more than one) press unlock button 5 times, in one second intervals indicators flash 5x for every time signal is received switch ignition off and remove key
that's the de-programming done...
to de-program the system if above fails..........
switch ignition on ( use key without remote ) manually lock drivers door using key to be synced with car complete the following within 30 seconds of doing above within 5 seconds press the unlock button on key indicators should flash once wait 5 seconds press unlock button once to confirm programming vehicle should unlock this also will confirm deactivation of programming mode switch ignition off remove key..that should be it, then try new programed key in ignition.

to re-program system and sync with key switch ignition on manually lock drivers door using key ( another one, hopefully you will have more than one) press unlock button 5 times, in one second intervals indicators flash 5x for every time signal is received switch ignition off and remove key
that should be it, if no joy then will have to main dealer i am afraid...hope this helps

Jun 07, 2010 | 2001 Audi TT

1 Answer

RS Focus registered yesterday 19th March Keyless entry but remote fobs do not lock or unlock car. The car was driven back yesterday hav ing now covered 114 miles alarm was going off last night but thats...


should not be using fob buttons for entry or locking for emergency only .if keyless entry walk up to car with fob do not press any buttons see if door opens then walk away from car with fob about 20m then go back to car without fob and see if door locked if so all working fine .indicators will not flash if the above dont work take back to main dealer for diagnostics keys may need to be reprogrammed

Mar 20, 2010 | 2009 Ford Focus

1 Answer

Remoe dont lock or unlock the doors. hazard lights, indicators and horn dont work.


You might have a blowen fuze. I would check that first. If it is blowen and continues to blow after replaceing it, then you have a short somwere in the wiring.

May 19, 2009 | 2000 Toyota Land Cruiser

1 Answer

When locking car should lights flash


Hello, this is quite normal for lights to flash, Imagine being at a Cinema or Concert and half a dozen vehicles same model/colour parked in the area you thopught you left yours? Hitting the fob helps find your own vehicle, also lets you know that the vehicle is either Locked or unlocked.
Hope this FixYa's problem.
Paul 'W'

Jan 04, 2009 | 2000 Volvo V40

Not finding what you are looking for?
2000 Audi TT Logo

642 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

yadayada
yadayada

Level 3 Expert

60960 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

13152 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...