Question about 2000 Mercedes-Benz E-Class

1 Answer

Heater blower not working

My E240 petrol fan blower stopped working
i have some idea,s could this be a resistor or relay
switch control or fan motor any ideas
greatly appreciated.

Posted by on

  • garry_bond Jan 25, 2009

    thanks ray i will try this, and let you know ?
    Do you know where the resistor is positioned
    thanks once again for your time


×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 61 Answers

Very common fault was the blower regulator fails (blower resistor)

Posted on Jan 24, 2009

  • Raymond Hall
    Raymond Hall Jan 25, 2009

    Rather than me telling you how to do it here is a useful link that will show you how to do it .
    http://forums.mbworld.org/forums/e-class...

    Just cut and past this in to your address bar.
    Hope this helps.


×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2012 jeep libery blower motor control processor location


Processor? This system consists of a control unit ( switch/selectors ) a blower motor resistor and a blower relay. If the blower fan is not working on all speeds, suspect a resistor ( common problem ). If the fan is inoperable, possible fan motor,fuse,relay,wiring and in some cases the resistor as well. The resistor is located under the passenger side dash area close to the heater motor. The wiring coming from the heater motor will plug into the resistor

Dec 26, 2015 | Jeep Cars & Trucks

1 Answer

Acura legend ac control untied stop working along with the fans any idea wat could it be


The rotary control switch on the dash controls the blower motor for the A/C. The A/C will not turn on unless the blower motor is functioning properly. The passenger-side radiator fan will not turn on until the A/C begins running. BUT the driver's side radiator fan should always work. Ergo, check the function of the blower motor (located underneath the dash behind the glove box). Usually when it goes bad, it's because of the blower motor RESISTOR (mounted inside the blower motor housing). When the resistor goes bad, the blower motor shorts out, causing it to fail. The switch rarely ever fails. The radiator fan relays are located next to & on both ends of the radiator. Check them too. In the link, the blower motor RESISTOR is #5.
Acura Parts AcuraOEMparts com Genuine Acura OEM Parts from Delray Acura

Apr 02, 2013 | 1991 Acura Integra Hatchback

1 Answer

Terracan blowers wont turn off


Ok i could be 1 of 3 things blower relay,blower switch or blower motor resistor.First thing to do is check the blower motor resistor by pulling on and wiggling the pigtail to the resistor with the ignition and fan switches on.Then if there is no bad connection i would replace the relay and if no change afterwards replace the fan switch.

Jan 19, 2012 | 2006 Hyundai Terracan 2.9

1 Answer

Heater/ac blower motor does not work,,, check fuses, didnt check blower resistor,


CHECK BLOWER MOTOR RELAY ALSO, AND USE A TEST LIGHT TO SEE IF POWER GOING TO BLOWER MOTOR, IF YES BLOWER MOTOR FAULTY.IF NO POWER GOING TO BLOWER MOTOR AND FUSE AND RELAY OKAY CONTROL SWITCH COULD BE BAD,A RESISTOR BAD MOST OF THE TIME IF YOU DONT HAVE BUT A FEW FAN BLOWER CONTROL SPEEDS.

Jul 22, 2011 | 1999 Oldsmobile Alero

2 Answers

I have a 2000 grand prix 3.8 with heater problems. i have changed the heater core, thermostat, resister, blower, the 2 relay switches and heater fan. there still is very little air coming thru.. any...


The blend door may not be working properly. It is actuated by a vacuum motor.

or the following part may be bad:

Blower Motor Control Module Removal & Installation To Remove:
  1. Remove the insulator from the right side of the instrument panel.
  2. Disconnect the connectors from the blower motor resistor and blower motor.
  3. Loosen the two forward screws and remove the rear screw of the resistor assembly.
  4. Remove the blower motor resistor assembly.
To Install:
Install the blower motor resistor assembly. Install the rear screw and tighten the forward screws. Connect the electrical connectors to the blower motor and resistor assembly. Install the insulator under the right side of the instrument panel.
prev.gif next.gif

Jan 21, 2011 | 2000 Pontiac Grand Prix

1 Answer

I have a 1992 Toyota Previa. The heater stopped blowing air. For the last year the fan would only work on the highest setting.... now nothing. Is it the Blower motor, fan relay, or Switch??? Any idea?...


the last year, your blower resistor has been bad, now your motor is bad. rap on the motor and see if it start to run, if so, replace the motor and the resistor.

Dec 16, 2010 | 1993 Toyota Previa

1 Answer

A/C and Heater will not blow air..


Blower motor resistor is most common ($20-$70) it controls the blower motor fan and speeds or fan relay fuse (usually under the hood) If it's not either then the blower itself is bad. You can pull the motor and apply 12volts to it to test, if it spins then the resistor.

Oct 02, 2009 | 2001 GMC Sierra Crew Cab

1 Answer

Car a/c heat blower stopped no warning


Check for a blown heater motor supply fuse,
Check operation of heater motor control relay,
Check operation of fan speed control switch,
Check heater motor speed control resistor pack (usually located in the heater ducting - in the air flow),
Check the heater motor runs if power directly applied to the motor- if not motor may be faulty.

Aug 26, 2009 | 2003 Dodge Neon

1 Answer

Ac blower motor


Check fuse supplying fan is not blown,
Check blower control switch is operating OK,
Check relay controlling fan is operating OK,
Check variable speed resistor pack is not faulty (the resistor pack is usually located in the blower ducting, in the blower airflow),
Check blower motor ground connection is not missing.

Aug 12, 2009 | 2000 Mercury Grand Marquis

Not finding what you are looking for?
2000 Mercedes-Benz E-Class Logo

1,053 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

yadayada
yadayada

Level 3 Expert

70387 Answers

Michael Contreras
Michael Contreras

Level 2 Expert

166 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...