Question about 2005 Land Rover Range Rover

Open Question

Trans FailSafe Prog with a "cooook" sound under neath while changing gear

Hi, the RR 2005 which displays the error messages it has a "Cooook" under neath while changing gear. it happens in different times and sometimes it has a delay in picking up the motion... if i want to ride on a small hill, alert sound comes up and it doesnt move front but by reverse it can climb smoothly. the same car has Battery light on, Air Suspension Inactive, HDC Inactive, ABS Light On...

Posted by on

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Air suspension inactive, HDC inactive, ABS light on, Range Rover

Air Suspension Inactive usually means there is a problem with the Air Suspension. However, it will also come up when alternator or battery voltage is low, or when you reset (disconnect and then connect) the battery. To reset it manually: while in P(ark), turn steering wheel all the way left, hold few seconds, and then all the way right, hold few seconds. All the warning lights will go out. Most common failure is the passenger front air strut, since batteries are prone to leaking acid, it leaks right on top of the rubber airbag and burns through it. Dealer willcharge you one hour to diagnose, or you can easily diagnose this by looking at the ride height of each particular corner of the truck. If its sits low, or emits hissing sound when you park the truck, its leaking. If you keep driving with leaky air strut, you risk burning up the air compressor, as its working extra hard to compensate for the leak. Replacing the strut is easy 45min job even for a novice mechanic, and you can do it yourself. Strut can be found new for approx $750 online. If you are fed up with air suspension issues, there is a $700 kit that converts the truck to springs, and disables all of the air suspension. Look up Arnott Industires

Posted on Jun 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 bmw x5 trans failsafe program message after oil change


First check transmission dip stick for correct fluid level. Next schedule a transmission filter change. This should have been done at 60,000miles

May 25, 2017 | BMW X5 Series Cars & Trucks

1 Answer

My question is what is the cause of engine fail safe of range rover?someone give some advice?


Search Results

    Thread: Need Help please Engine Failsafe what is it? - Range Rovers

    www.rangerovers.net/...range-rover.../35972-need-help-please-engine-fa...

    Oct 19, 2011 - 8 posts - ‎6 authors
    I still drove my car with this engine fail-safe prog because i know all ... if you fail to do these things with most range rovers, you will always be in ... Thread: Engine failsafe mode after lambda sensor change
    8 posts
    Aug 1, 2014
    Thread: Engine Failsafe Throttle Actuator Control Error
    16 posts
    Mar 20, 2014
    Thread: Engine failsafe and air susp inactive/HDC
    10 posts
    Oct 22, 2010
    Re: Engine failsafe prog
    16 posts
    Jan 16, 2009
    More results from www.rangerovers.net

    engine failsafe mode ' LandyZone - Land Rover Forum

Jan 11, 2016 | Land Rover Range Rover Cars & Trucks

1 Answer

E53 X5 will not go in gear


failed electronic stability control module.sits behind your gear stick.take it to a dealer to check the codes first.as they can check that part first. as two other things can go wrong in your gear box .but the codes will check that.

Dec 18, 2013 | BMW X5 Cars & Trucks

1 Answer

I have a bmw 2000 540i and after the car runs for ten minutes the on board computer flashes "trans failsafe prog". what is wrong.


Your transmission is going into limp mode because of a fault. Get the tranny diagnosed.

Dec 13, 2012 | Cars & Trucks

1 Answer

Message shows Trans Failsafe Prog


OK, the sad news is that you are quite likely to be due for a transmission overhaul. But switch the car off on level ground and let it sit for a few minutes and it should come good for a while. Possibly even weeks. The trigger for the warning and fail safe is related to the build up of particulate matter in the sump of the tranmission so I'm told. You might prolong the period until the transmission needs a rebuild by dropping the pan and cleaning it out,then refitting and filling with a top quality transmission oil. Its only a short term fix though. The good news is that the transmission is quite a conventional unit and unless you are still under warranty you can get quotes from mainstream auto transmission specialists and you may only pay around $3500 AuD with a 12/20 warranty.
Good luck. David

Aug 20, 2010 | 2005 BMW X5

2 Answers

BMW X5 2004 TRANS FAILSAFE PROG


Hi; If I get the 'Trans Failsafe Prog" message twice within about 2 hours, The SES light will go on automatically. Since I do not seem to have any real transmission problems, this SES message clears itself in about 24 hours. The "Trans Failsafe Prog" messageseems to be used to indicate other transmission problems as well, like loss of transmission fluid, so be careful. I have a 2002 X5. Cheers. Omer

Dec 31, 2009 | 2002 BMW 5 Series

1 Answer

Trans failsafe prog came on and sluggish start out stuck in 3rd gear, abs light comes on with dsc light and sometimes engine light and speedo/odometer and temp guage not working


this is common, most of the time water gets into the ecu box, you can tell this by looking inside the black box under the bonnet, the worst ones have a white holder inside them.
check this if not get a plug in to see.
sometimes this message isnt there, if so check the gearbox oil if you have a 5hp box it has to be running then remove large allen key, if it drips out its full, bear in mind there will be oil ontop of plug that is stuck in thread. if low on oil it this will give u the prob

Aug 15, 2009 | BMW 5 Series Cars & Trucks

1 Answer

I also have a trans.failsafe prog.indicator light on my 2000 bmw


You have an alternator or battery concerne,low voltage caused all the other problems,Start with a battery,then have alternator tested.The failsafes are designed to keep from burning up solenoids and other electronic components.

Jun 19, 2009 | 2000 BMW 7 Series

Not finding what you are looking for?
2005 Land Rover Range Rover Logo

Related Topics:

50 people viewed this question

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

yadayada
yadayada

Level 3 Expert

75797 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...